Zeagle Defender EBS 310 Bedienungsanleitung

Page 1

ZE.01.05.0030 REV. A

EBS User Manual

Page 2

ZE.01.05.0030 REV. A

EBS User Manual

Page 3

ZE.01.05.0030 REV. A

EBS User Manual

TRADEMARK NOTICE

HUISH OUTDOORS and the ZEAGLE logo are registered or unregistered trademarks of Huish

Outdoors. All rights are reserved.

EC TYPE EXAMINATION CONDUCTED BY:

Products carrying the CE mark have the EC Type Examination conducted by:

SGS Fimko Oy, Takomotie 8, FI-00380 Helsinki, Finland

Notified Body 0598

All products sold by Zeagle in the EU (European Union) comply with the following requirements

where applicable.

EN12021: This standard specifies the allowable contaminates and component gases that make up

compressed air. This standard is the equivalent of the USA Compressed Gas Association’s Grade E

air. Both standards allow very small amounts of contaminants that are not harmful to breathe, but

can cause a problem if present in systems using gases with a high percentage of oxygen.

EN4856: The EBS is considered a Emergency Self Contained Emergency Underwater Breathing

Apparatus. A such, the EBS is designed for user deployment and operation with sufficient notice

given to the user to deploy the device.

A “Declaration of Conformity” is on the Huish Outdoors website at: https://www.huishoutdoors.com/

eu-declarations/declarations-of-conformity/

The Zeagle Defender EBS is certified as an underwater escape breathing apparatus for use to a

maximum depth of 4m in water temperatures of 4°C or greater. It is certified that the EBS meets the

Essential Health and Safety Requirements in Annex II of Regulation (EU) 2016/425 Personal

Protective Equipment. This PPE satisfies the requirements for a shallow water underwater escape

breathing apparatus based on relevant principles and elements of EN4856:2023 - Rotorcraft

Emergency Breathing Systems (EBS), requirements, testing and marking. Also in compliance to

harmonized standard EN250:2014 - Respiratory Equipment open circuit, self contained, compressed

air diving apparatus, requirements, testing and marking.

Page 4

INTRODUCTION

The Defender Emergency Breathing System (EBS) is a device intended to assist an individual to

escape from an emergency situation involving involuntary submergence below water, such as that

which might occur with a downed aircraft in a body of water.

It is a self-contained system that features a robust design with particular attention to simplicity,

reliability and convenient compact size to enable ease of use and maintenance.

Additional features that include adjustable mouthpiece positions, a flexible hose with swivel

connections and convenient port connections provide desirable options for the user to adapt the

device to personal preferences.

While the EBS is not difficult to use, specific training and practice is required for the user to use it

effectively in an emergency situation.

WARNINGS, CAUTIONS AND NOTES

This manual contains information that could affect your safety. Certain items are emphasized with

symbols and signal words to indicate a potential hazard.

ZE.01.05.0030 REV. A

EBS User Manual

Page 5

The Defender EBS is intended to be used as a device to assist an individual in self-rescue to escape

from an emergency situation involving submergence in shallow water for a brief period. It is not

designed nor tested for any other purpose.

Proper training is essential for your safety. Training experience must include in- water survival,

breathing compressed air underwater and emergency egress from aircraft.

You must be familiar with and trained in the use of this particular device to maximize your effective use

of it. Failure to respond to this warning could result in a situation leading to serious injury or death.

In order to prepare for, use and maintain this device properly, it is essential that you understand all of

these aspects through reading this manual and mastering the skills necessary to operate, inspect and

maintain it properly. Failure to do so could result in a situation whereby the EBS would not be an

available resource to assist with self rescue and possibly lead to serious injury or death.

GENERAL DESCRIPTION

The EBS is comprised of a cylinder of compressed air with an integrated cylinder valve and pressure regulator

designed to interface with the user and deliver air at a reduced pressure suitable for breathing. When fully

charged to maximum operating pressure of 310 bar (4500 PSI), the cylinder has the capacity to delivery 89 L

(3.2cubic feet) of air at atmospheric pressure.

The EBS has a limited capacity to deliver air for only a brief period in shallow water (4m;13 ft)

The time duration for supplying air will vary between individuals and breathing rates. This is an indicator

supporting the need for training to maximize effective use of the device.

ZE.01.05.0030 REV. A

EBS User Manual

Page 6

CYLINDER

A carbon composite reinforced AMS Type 3 cylinder is used to store compressed air for delivery to the user. It

complies with ISO 11119-2 standards for certification and has a maximum working pressure of 310 bar (4500

PSI).

All cylinders shipped with the Defender EBS are EU approved and labeled as follows in compliance with EU

standards.

EBS FIRST STAGE REGULATOR

The EBS integrated first stage regulator and valve is threaded into the cylinder to provide a compact assembly.

It is provided with an onboard pressure gauge, an ON/OFF port, fill port and low-pressure hose with a swivel

connection attached to the second stage.

The integrated cylinder valve/regulator is available in two different configurations with either a manually-

operated ON/OFF port or an option that requires a 3 mm hex tool to operate the ON/OFF selection.

Selection of the OFF position applies to maintenance activity only and should never be selected when

the EBS is ready and available for use.

ZE.01.05.0030 REV. A

EBS User Manual

Page 7

EBS FIRST STAGE WITH ON/OFF KNOB INSTRUCTIONS

The first stage regulator with an integrated on/off knob is illustrated below. The unit must be in the on position

or turned fully in the counterclockwise direction until aligned with green zone and arrow.

To turn off, rotate clockwise until the red zone is aligned with the arrow.

See instructions for use in EBS Deployment section of this manual.

EBS User Manual

ZE.01.05.0030 REV. A

The ON/OFF port of the integrated valve and first stage must always be in the ON position any

time the EBS is in service and ready to be deployed. If the valve has been closed to the OFF position at any

time, it must be fully reopened to the ON position by rotating counterclockwise at least one full revolution

before it is acceptable for use. DO NOT place the unit into service without ensuring it is in the ON position.

Failure to ensure unit is in the ON position will render the EBS incapable of delivering air to the user.

ON POSITION OFF POSITION

Page 8

The ON/OFF port of the integrated valve and first stage must always be in the ON position any

time the EBS is in service and ready to be deployed. If the valve has been closed to the OFF position at any

time, it must be fully reopened to the ON position by rotating counterclockwise at least one full revolution

before it is acceptable for use. DO NOT place the unit into service without ensuring it is in the ON position.

Failure to ensure unit is in the ON position will render the EBS incapable of delivering air to the user.

EBS SECOND STAGE REGULATOR

The second stage regulator with an integrated mouthpiece is connected to the first stage by means of a flexible

hose with a swivel connection. Its purpose is to provide a means to connect with the user’s mouth and supply

air on demand for breathing. See instructions for use in EBS Deployment section of this manual.

The second stage assembly also provides a location for storage of a nose clip to assist with breathing control

and a purge cover cap to prevent accidental operation of the purge function when the EBS is in transit or

otherwise not in service and ready to use.

ZE.01.05.0030 REV. A

EBS User Manual

Page 9

EBS PREPARATION FOR IN-SERVICE USE

CYLINDER PRESSURE - The EBS is delivered from the factory fully charged with the valve in the

ON position ready for immediate use. Cylinder pressure must not be less than 310 bar (4500) PSI to

be fully charged. If charging is necessary, refer to the Cylinder Filling Procedure contained in this

manual.

FIRST STAGE ON/OFF PORT -The port must be in the ON position at all times when the EBS is

in service and ready to use.

SECOND STAGE FEATURE - The mouthpiece orientation is adjustable but should only be changed

by a trained service technician. It may be indexed to the user’s preference, but only as a maintenance

option and may not be changed while the unit is in service for immediate use.

SECOND STAGE PROTECTIVE COVER - This device is intended for EBS transit or storage only. It

MUST NOT be installed anytime the EBS is placed in service and ready for use.

DEPLOYMENT OF EBS IN EMERGENCY SITUATION

1. Use one hand to secure your position at the nearest exit escape route. Use your free

hand to grasp the EBS second stage regulator and pull out and away from your body to

ensure hose is free from entanglement.

2. Place your mouth over the mouthpiece and exhale providing a puff of air to clear

residual water that might be inside the second stage housing. Then inhale, lightly at first

to be sure residual water is not present, and then continue to breathe normally. If there

is water present after first exhalation, block the air path in the mouthpiece with your

tongue and press the purge feature on the front of the second stage housing to clear

residual water and then continue to breathe normally, recognizing that the air supply is

limited and expedient travel to the surface is required.

DO NOT HOLD YOUR BREATH. BREATHE NORMALLY. Failure to

exhale lightly and continuously or breathe uninterrupted as you

ascend from even shallow depths can create a hazardous pressure

imbalance in the lungs risking respiratory damage, with the

possibility of serious injury or death.

ZE.01.05.0030 REV. A

EBS User Manual

Page 10

3. Immediately after you have control of the mouthpiece in your mouth, use your free

hand to locate and grasp the Nose Clip that is secured to the second stage housing.

Pinch the Nose Clip tabs together as shown in the illustration below to open it and place

it over the nose and release. The purpose of the Nose Clip is to block entry of water into

the nose while breathing. Do not try to breathe through the nose while submerged.

4. Note that the EBS is designed to deliver air only when you attempt to inhale. When you

stop inhaling, air flow ceases allowing you to comfortably exhale. Air flow to you can be

manually activated anytime by pressing the purge feature as long as there is a

remaining air supply in the cylinder.

5. After you reach the surface and have access to air, discontinue use of the EBS. Once

the EBS has been deployed for either an emergency or training it must be removed

from service, no longer available for emergency use until after it has been recharged or

received periodic maintenance.

CYLINDER FILLING GUIDELINES

Connection to a compressed air supply to charge the EBS requires a specific Filler Adapter. It

is a compressor accessory for the air supply facility and is not supplied * as part of the EBS

assembly.

ZE.01.05.0030 REV. A

EBS User Manual

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Zeagle Medizinische Geräte Handbücher

Zeagle

Zeagle DEFENDER EBS 207 Bedienungsanleitung

Beliebte Medizinische Geräte Handbücher anderer Marken

TekTone

TekTone Tek-CARE160 Bedienungsanleitung

NeuroMetrix

NeuroMetrix Quell 2.0 Bedienungsanleitung

AMT

AMT XLR8 Bedienungsanleitung

Medipost-Nutristoma

Medipost-Nutristoma MD300K2 Bedienungsanleitung

EDAN

EDAN SONOTRAX Pro Bedienungsanleitung

Restorative Therapies

Restorative Therapies RT300 Bedienungsanleitung

Gendex

Gendex Expert DC Bedienungsanleitung

Dexcowin

Dexcowin ADX4000W Bedienungsanleitung

Libelium

Libelium MySignals Bedienungsanleitung

Acelity

Acelity V.A.C.ULTA 4 Bedienungsanleitung

Caputron

Caputron ActivaDose II tDCS Bedienungsanleitung

FujiFilm

FujiFilm Sonart Betriebsanleitung

Plinth 2000

Plinth 2000 93CDT Bedienungsanleitung

GE SENOGRAPHE 800T Bedienungsanleitung

GE Definium 5000 Bedienungsanleitung

Kanmed

Kanmed GE-1380 Bedienungsanleitung

Huntleigh

Huntleigh FD1 Bedienungsanleitung

Stryker

Stryker SPR Plus Bedienungsanleitung