Installation
1. Be sure to turn OFF the HD source and HDTV.
2. Connect the HDMI extension cable between HD Source and HDMI In port
of the Transmitter.
3. Connect the HDMI extension cable between the HDTV and the HDMI Out
port of the Receiver.
4. Connect Cat 5e/6/7 cable between the Transmitter Link port and the
Receiver Link port of the Receiver.
5. Connect the Power adapter to the Receiver and power up the extender
6. Turn on the HD source and HDTV.
IR Receiver Cable Directions:
Plug the IR receiver into the ZIG-POE-70-RX “IR IN” port and place the IR
receiver so you can point to it easily with your IR remote controller.
IR Emitter Directions:
Plug any brand IR emitter into the ZIG-POE-70-TX “IR OUT” port and place
the IR sensor directly on the IR window on the front panel of the device
you intend to control.
Additional Options
1. IR Receiver Cable
HDMI Connector Signal Pin Out
