ZyXEL Communications 802.11g Wireless Ethernet Adapter 1-G-470 Bedienungsanleitung

G-470

802.11g Wireless Ethernet Adapter

Quick Start Guide

Version 1.00

Edition 1

5/2006

About Your G-470

The G-470 is a wireless network adapter for your computer. It

allows your computer to connect to a wireless access point

(AP).

Installation Requirements

Before installation, make sure you have a computer with the

following:

• A Local Area Network (LAN) Ethernet port.

• Windows NT 4.0, Windows 98SE, Windows ME, Windows

2000 or Windows XP.

• Windows 98 SE users may need the Windows 98 SE CD.

Hardware Connections

Figure 1 The G-470: Rear Panel

The following table describes the rear panel of the G-470.

Follow the steps below to install the G-470 in your computer.

1Screw the antenna clockwise onto the antenna connector.

Make sure the antenna is securely screwed onto the

antenna connector.

2Use an Ethernet network cable to connect your computer

to the ETHERNET port for Internet access.

3Use the power adaptor provided with your G-470 to

connect an appropriate power source to the POWER

socket. Make sure the power source is on. Use only the

included power adaptor.

Label Description

1 Antenna connector

2RESET button

3ETHERNET port

4POWER socket

If the G-470 is properly connected, an icon similar to the

following will appear in the system tray (typically at the bottom

right of your desktop).

After you make the proper hardware connections, check the

lights on the front of the G-470.

Figure 2 The G-470: Front Panel

The following table describes the front panel of the G-470.

Light Description

SGNL The blinking frequency of the

SGNL light indicates the quality of

the wireless signal.

The light is

steady on.

Signal strength is 80% or more.

The light is

blinking once a

second.

Signal strength is between 60%

and 79%.

The light is

blinking twice a

second.

Signal strength is between 30%

and 59%.

The light is

blinking four

times a second.

Signal strength is below 29%.

The light is off. The wireless network is not

connected.

If any of these lights are not on, check your connections and

inspect your cables for damage. If the lights are still off,

contact your local vendor.

Internet Setup

You must first prepare your computer / computer network to

connect to the G-470 by setting up your IP address.

1Click start (Start in Windows 2000/NT) > Settings >

Control Panel.

WLAN The light is on. The device is connected to the

wireless network.

The light is

blinking.

The device is scanning for an

access point (AP).

The light is off. The device is not connected to the

wireless network.

ETHN The light is on. Ethernet is connected.

The light is

blinking

Ethernet is connected, and is

sending or receiving data.

The light is off. Ethernet is not connected.

SYS The light is off. The device is ready.

The light is

blinking orange.

The device is not ready, or is

rebooting.

PWR The light is on. The power is on.

The light is off. The power is off.

Light Description

2In the Control Panel, double-click Network Connections

(Network and Dial-up Connections in Windows 2000/

NT).

3Right-click Local Area Connection and then Properties.

4Select Internet Protocol (TCP/IP) and then click

Properties.

5Select Use the following IP Address and fill in an IP

address (between 192.168.1.12 and 192.168.1.254).

6Type 255.255.255.0 as the Subnet mask.

7If your Internet Service Provider (ISP) gave you Domain

Name System (DNS) settings, enter them in the Use the

following DNS server addresses fields. A DNS server

translates domain names (e.g. http://www.zyxel.com) into

the IP addresses your Internet browser uses to navigate

the web (e.g. 203.160.232.7). If you are not sure of your

DNS settings, contact your ISP.

8Click Advanced.

9Remove any previously installed gateways in the IP

Settings tab and click OK to go back to the Internet

Protocol TCP/IP Properties screen.

10Click OK to close the Internet Protocol (TCP/IP)

Properties window.

11Click Close (OK in Windows 2000/NT) to close the Local

Area Connection Properties window.

Close the Network Connections window (Network and

Dial-up Connections in Windows 2000/NT).

Configuration

Open your Internet browser and enter the URL of a web site

in the address bar.

Your G-470 automatically searches for wireless networks.

This may take a few minutes. If any other screens appear,

follow the directions in the screens.

If the web page opens correctly, your G-470 is ready to use.

If the web page does not open, you need to set up your

Internet connection. You should have information supplied by

your Internet Service Provider.

In your browser enter 192.168.1.11 (default) as the URL and

press ENTER. The G-470 Web Configurator login screen

displays as shown.

Figure 3 Login Screen

Type admin (default) as the username and 1234 (default) as

the password and click OK. The Status screen appears.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ZyXEL Communications Adapter Handbücher

ZyXEL Communications

ZyXEL Communications ZyAIR G-405 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications G-270S Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications G-220 V2 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA450 Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications WPA-1000 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZYAIR G-110 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications G-220F Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications N220 - Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA4101 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA-401 v2 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZyAIR G-220 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA6456 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications G-210H Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA4215 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications G-210H Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications G-210H Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications G-220 V2 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications G-210H Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications Powerline Ethernet Multiplug Center PLA491 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA4215 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications G-162 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA4201 v2 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZyXEL ZyAIR B-220 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications G-102 Bedienungsanleitung

Beliebte Adapter Handbücher anderer Marken

PCB Piezotronics

PCB Piezotronics 090B274 Bedienungsanleitung

Gossen MetraWatt

Gossen MetraWatt AT3-III E Bedienungsanleitung

Akribis

Akribis ITF-21-BISS-MIT Bedienungsanleitung

Auvidea

Auvidea J20 Produkthandbuch

Tenda

Tenda W54U Bedienungsanleitung

ROHO

ROHO AGILITY Bedienungsanleitung

PROLiNK

PROLiNK WN2001 Bedienungsanleitung

Hawking

Hawking HUF2 Bedienungsanleitung

Airlink101

Airlink101 AWLC4030 Bedienungsanleitung

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Bedienungsanleitung

Philips

Philips SWA4554S/10 Bedienungsanleitung

JVC

JVC TS-C9D2B Gebrauchsanweisung

NETGEAR

NETGEAR A6100 Bedienungsanleitung

D-Link

D-Link DWA-121 Bedienungsanleitung

Philips

Philips SWA2037 Bedienungsanleitung

Basalte

Basalte 0610-20 Bedienungsanleitung

Yealink

Yealink EHS40 Bedienungsanleitung

RCA

RCA AH57R Bedienungsanleitung