ZyXEL Communications P-870HW-51A V2 Bedienungsanleitung

www.zyxel.com

P-870HW-51a v2

802.11bg Wireless VDSL2 4 port

gateway

Firmware v1.00

Edition 1, 12/2008

DEFAULT LOGIN DETAILS

IP Address: http://192.168.1.1

Username: 1234

Password: 1234

ZyXEL Communications Corporation

Device Panels

WPS/WLAN BUTTON LEDS (LIGHTS)

ENGLISH

Introduction

The P-870HW-51a v2 is a VDSL2 gateway that provides super high-

speed Internet access through a telephone line and IEEE 802.11b/g

wireless networking capability. The P-870HW-51a v2 has a built-in

switch that allows you to connect up to four network devices.

Overview

• Before You Begin, on page 4

• Hardware Connections, on page 5

• Initial Configuration, on page 7

• Setting Up a Wireless Network with WPS, on page 10

• Wall-mounting, on page 11

INTERNET

ENGLISH

Before You Begin

Make sure you have the following things before you set up your P-

870HW-51a v2.

• Internet access - account information provided by your ISP, such as

user name, password, and so on.

• Internet Explorer 6.0 or later or Netscape Navigator 7.0 or later, with

JavaScript enabled.

See the User’s Guide for all configuration details including file sharing

and setting up a shared printer.

To read the User's Guide insert the CD that came in the box into your

CD-ROM drive. A screen should pop up. Navigate to the User's Guide

from this screen. If a screen does not pop up, open Windows Explorer

(click My Computer), click on the CD-ROM drive (usually drive D) and

navigate to it from there.

ENGLISH

Hardware Connections

This section shows you how to set up your P-870HW-51a v2.

1. DSL: Use a telephone wire to connect this port to a telephone jack (or

the DSL or MODEM jack on a splitter, if one is already installed).

2. ETHERNET 1-4: Use an Ethernet cable to connect a computer to this

port for initial configuration and/or Internet access.

3. Use the power adaptor provided with your P-870HW-51a v2 to

connect an appropriate power source to this socket.

4. Attach the antenna onto the P-870HW-51a v2.

5. Push the power switch to the on position.

Checking the LEDs (Lights)

Look at the LEDs (lights) on the top panel of the P-870HW-51a v2.

• The POWER light blinks during start-up and is green once the P-

870HW-51a v2 is ready.

• Each ETHERNET light turns on if the corresponding ETHERNET

port is properly connected. The lights blink when the P-870HW-51a

v2 is sending or receiving data through the corresponding

ETHERNET port.

• The DSL light stays on if a physical DSL connection exists and

blinks when transmitting data.

• The INTERNET light is green when Internet access is available.

• The WLAN/WPS light stays green when the wireless LAN is ready.

It blinks when the P-870HW-51a v2 is sending/receiving data

through the wireless LAN.

 If none of the LEDs (lights) are on, check your connections.

Make sure that you have the power adaptor connected to the

P-870HW-51a v2 and plugged in to an appropriate power

source. Make sure the power source is turned on. Turn the

P-870HW-51a v2 off, wait for a few seconds and turn it back

on. If the LEDs are still off, contact your local vendor.

ENGLISH

Testing Internet Connection

After you have connected the hardware and turned on the P-870HW-51a

v2, open a web browser on your computer and go to any web site (for

example, www.zyxel.com) to test your Internet connection.

If you are prompted for a user name and password, enter the account

information as given by your Internet service provider (ISP).

Initial Configuration

1. Open your browser and enter http:/

/192.168.1.1 (the P-870HW-51a

v2's default IP address) as the

address.

2. Enter the admin user name

1234 and password 1234

(default). Click OK.

 If the login screen does not display, make sure you allow

web browser pop-up windows, JavaScripts and Java

permissions. Your computer should be also set to get an IP

address automatically from a DHCP server. See the

appendices in your User's Guide for more information.

Internet Setup

When your Internet connection is setup correctly, the DSL and

INTERNET lights should be green.

 If you cannot access the Internet and the INTERNET light is

off, make sure you enter the correct information in the WAN

screens. If you are using a new Internet account, contact

your ISP to make sure it is active. If you are trying to access

the Internet wirelessly, make sure the wireless and security

settings in your wireless client are the same as the settings

in the P-870HW-51a v2.

Wireless Setup

To create a wireless network the P-870HW-51a v2 and your wireless

computer(s) must all use the same SSID (network name), channel and

security settings.

1. Go to Network > Wireless LAN.

2. Enable wireless LAN, enter a name to identify your wireless network

(such as “ZyXEL“) in the SSID field, and select a channel which is not

used by neighboring wireless devices.

3. Select your security mode and configure wireless security settings. In

this example, the P-870HW-51a v2 uses WPA2-PSK for data

encryption.

If you do not set wireless security, any one within range could use your

P-870HW-51a v2 to access your network and the Internet.

ENGLISH

Make sure your wireless security settings are compatible with your

existing wireless devices. See the User's Guide for more information on

wireless networks.

Setting Up a Wireless Network

with WPS

You can use Wi-Fi Protected Setup (WPS) to set up

a secure wireless network and add wireless devices

to your wireless network at the touch of a button.

The other wireless devices must also support WPS.

Look for the WPS logo on the housing of your device.

1. Place a WPS-enabled device within range of the P-870HW-51a v2.

2. Press the WPS WLAN ON/OFF button ( ) on the P-870HW-51a v2

for five seconds. Press the WPS button on another WPS-enabled

device. It doesn’t matter which button is pressed first. You must press

the second button within two minutes of pressing the first one.

Your P-870HW-51a v2 allows the PBC (Push Button Configuration)

method, as well as the PIN (Personal Identification Number)

configuration via the web configurator. See your User’s Guide for more

information. Other WPS-enabled devices should provide at least one

similar method.

3. The WLAN/WPS LED ( ) on the P-870HW-51a v2 blinks for a few

seconds, then shines steadily, indicating your devices are connected.

4. To add another WPS-enabled device to your wireless network, press

the WPS buttons on your P-870HW-51a v2 and your next WPS-

enabled device.

Congratulations! You are now ready to connect to the Internet wirelessly

through your P-870HW-51a v2.

Andere Handbücher für P-870HW-51A V2

Inhaltsverzeichnis

Andere ZyXEL Communications Tor Handbücher

ZyXEL Communications

ZyXEL Communications PRESTIGE 660 HW Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications Unified Security Gateway ZyWALL 300 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications p-2302r series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications p-661hw series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ADSL 2+ Security Gateway Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PRESTIGE 324 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-660H-61 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZyXEL ZyWALL 5 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications SBG3300 series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PK5001Z Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-2302HWL-P1 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ADSL2+ 4-port Gateway P-660H-D Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-661HW-D Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-794H Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-660HN series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-660HW-D Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications MAX-200M1 Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-660H-D Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-661H-D Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-660HW-Tx v3 Series Handbuch

ZyXEL Communications

ZyXEL Communications AMG1312-T Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-661HNU Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications P-2302HW-P1 Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications LTE3301 Series Bedienungsanleitung

Beliebte Tor Handbücher anderer Marken

LST

LST M500RFE-AS Bedienungsanleitung

Kinnex

Kinnex Media Gateway Bedienungsanleitung

2N Telekomunikace

2N Telekomunikace 2N StarGate Bedienungsanleitung

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Bedienungsanleitung

Telsey

Telsey CPVA 500 - SIP Bedienungsanleitung

RTA

RTA 460A-NNA4 Technisches Datenblatt

Shaw

Shaw Gateway HDPVR Bedienungsanleitung

ABB

ABB VSN900 Kurzanleitung

Commander

Commander Pulse Bedienungsanleitung

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Bedienungsanleitung

NETGEAR

NETGEAR C6300BD Bedienungsanleitung

Amit

Amit CDW531AM Bedienungsanleitung

HMS

HMS Netbiter EasyConnect EC150 Bedienungsanleitung

Huawei

Huawei EchoLife HG620 Bedienungsanleitung

AT&T

AT&T U-verse 3801 Gebrauchs- und Pflegehandbuch

Logic IO

Logic IO RTCU MX2 turbo Bedienungsanleitung

Suttle

Suttle MediaMAX MXM-521 Bedienungsanleitung

RTA

RTA 460MCBC-N2E Technisches Datenblatt