ZyXEL Communications ZYAIR G-110 Bedienungsanleitung

ZyAIR G-110

802.11g Wireless CardBus Card

Quick Installation Guide

Version 1.10

May 2004

Important Note

Federal Communications Commission (FCC) Interference Statement

The 802.11g Wireless LAN Adapter has been tested to the FCC exposure

requirements (Specific Absorption Rate).

The equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment, under 47 CFR 2.1093 paragraph (d) (2).

This Transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

Refer to the User’s Guide for general FCC statements.

Procedure to View a Product’s Certification(s)

1. Go to www.zyxel.com

2. Select your product from the drop-down list box on the ZyXEL home page to go

to that product's page.

3. Select the certification you wish to view from this page.

About Your ZyAIR

The ZyAIR is an IEEE 802.11g compliant wireless LAN PC card that fits into any

CardBus slot. With the ZyAIR, you can enjoy the wireless mobility within the

coverage area. The IEEE 802.11g technology provides greater range and offers

transmission rate at up to 54 Mbps.

1. Installation Requirements

Before installation, make sure you have the following requirements.

• Pentium II 300MHz or above

• A minimum of 6 MB available hard disk space

• A minimum of 32 MB RAM

• A CD-ROM drive

• A CardBus slot

• Windows 98 SE/Me/2000/XP

• Windows 98 SE users may need the Windows 98 SE CD

2. ZyAIR Utility and Hardware Installation

The installation procedures are similar for all supported Windows versions.

Windows XP screen shots are shown unless otherwise specified.

DO NOT insert the ZyAIR at this point.

1. Insert the support CD into the CD-ROM drive on your computer. The CD

auto runs. Otherwise, locate and double-click on setup.exe.

A Welcome screen displays. Click Next.

2. Click Next to accept

the default file location

or click Browse to

select an alternate

folder.

3. Windows 98 SE/Me: Click Finish to restart the computer.

4. Locate an available CardBus slot on

the computer.

5. With the pin connectors facing the

slot and the LED side facing up,

slide the ZyAIR into the slot. The

LEDs turn on if the ZyAIR is

properly inserted.

Never bend, force or twist the ZyAIR into the slot.

6. Windows 2000: If a warning window displays, click Yes.

7. Windows XP: A Found New Hardware Wizard windows displays. Select

Install the software automatically (recommended) and click Next.

8. Windows XP: If a warning window displays, click Continue Anyway.

Then click Finish to complete the installation process.

After you install the ZyAIR Utility and insert the ZyAIR, an icon

appears in the system tray.

If the ZyAIR Utility icon displays, the ZyAIR is installed

properly. Refer to the ZyAIR Utility User’s Guide to configure

the ZyAIR.

LED Display

LIN

ACT

The following table describes the LEDs on the ZyAIR.

LED COLOR STATUS DESCRIPTION

Blinking The ZyAIR is receiving or sending data.ACT Blue

Off The ZyAIR is not receiving or sending data.

On The ZyAIR has a connection to a wireless LAN.

Blinking The ZyAIR is connecting to a wireless LAN.

LINK Blue

Off The ZyAIR is not connected to a wireless LAN or

not receiving power.

External Antenna Installation

1. Remove the protective

cap from the ZyAIR.

2. Connect one end of the

antenna converter cable

to the external antenna

connector on the

ZyAIR.

3. Connect the other end

of the converter cable to

the Reverse-SMA plug

of the external antenna.

(It is recommended you

use ZyXEL’s external

antenna series.)

Troubleshooting

PROBLEM CORRECTIVE ACTION

Make sure the ZyAIR is inserted into the computer CardBus slot

properly and then restart your computer. Check the LEDs on

the ZyAIR.

Perform a hardware scan by clicking Start, Settings, Control

Panel and double-clicking Add/Remove Hardware. (Steps

may vary depending on the version of Windows).

Follow the on-screen instructions to search for the ZyAIR and

install the driver.

Check for possible hardware conflicts. In Windows, click Start,

Settings, Control Panel, System, Hardware and then click

Device Manager. Verify the status of the ZyAIR under Network

Adapter. (Steps may vary depending on the version of

Windows).

Windows does not

auto-detect the

ZyAIR.

Install the ZyAIR in another computer. If the error persists, you

may have a hardware problem. In this case, you should contact

your local vendor.

Andere Handbücher für ZYAIR G-110

Inhaltsverzeichnis

Andere ZyXEL Communications Netzwerk-Hardware Handbücher

ZyXEL Communications

ZyXEL Communications VES1724-56 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications IES-6000 - ANNEXE 749 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications Prestige 1600 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA450 Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications IES-6000 - ANNEXE 749 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications POE-12 Referenzhandbuch

ZyXEL Communications

ZyXEL Communications Prestige 2602HW Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications NSA-2401 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZyAIR B-320 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications FMG3010-R20A Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications NSA-220 Plus Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ONU-6040BBF-22 - V1.00 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications OLT2406 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications USG FLEX 500 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications Network Storage Appliance NSA-220 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications POE-12 Referenzhandbuch

ZyXEL Communications

ZyXEL Communications POE-12 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZyAir G-100 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications NSA-2400 Referenzhandbuch

ZyXEL Communications

ZyXEL Communications VMG4005-B50B Installationsanleitung

ZyXEL Communications

ZyXEL Communications ZyWALL SSL 10 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications NSA-220 Plus Handbuch

ZyXEL Communications

ZyXEL Communications Network Storage Appliance NSA-220 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZYWALL OTPV2 - Bedienungsanleitung

Beliebte Netzwerk-Hardware Handbücher anderer Marken

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Bedienungsanleitung

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Bedienungsanleitung

Yudor

Yudor YDS-16 Bedienungsanleitung

D-Link

D-Link ShareCenter DNS-320L Bedienungsanleitung

Samsung

Samsung ES1642dc Gebrauchsanweisung

Honeywell Home

Honeywell Home LTEM-PV Montageanleitung

evertz

evertz 7700 Series Bedienungsanleitung

D-Link

D-Link ShareCenter DNS-343 Bedienungsanleitung

Asante

Asante AsanteBridge 1012 Bedienungsanleitung

FireBrick

FireBrick FB2700 Bedienungsanleitung

Audiovox Electronics

Audiovox Electronics ARWH2T Bedienungsanleitung

ADC

ADC DSX-1 Handbuch

NetComm

NetComm NF2 Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 5620 Bedienungsanleitung

Dell EMC

Dell EMC XC6420 Series Bedienungsanleitung

Lanner

Lanner NCA-1020A Bedienungsanleitung

Allied Telesis

Allied Telesis AT-TN121-A Bedienungsanleitung

Lanner

Lanner NCA-1525 Bedienungsanleitung