P O Box 159 • Crestwood, KY 40014 • (502) 243-0042 •(502) 243-0039 fax
Setting up wired sensors
1. Plug any wired sensor into any socket on the monitor.
2. After a few seconds, the TV2 will recognize the sensor and change the display to the
Sensor Setup menu. The hour area of the sample data field will be highlighted.
3. This is how often you want the sensor to store a temperature. You may scroll to any
value between 1 min and 24 hrs with 'Up' or 'Down', touching 'Enter' to move to the
minute and second field, or accept the default by touching 'Enter'. The default value is
ten minutes (00:10:00). Changing the logging interval will erase any previously saved
temperatures.
4. Select the type of averaging with 'UP', or 'Down' and touch 'Enter'. There are three
possible selections.
a. Fast – no averaging occurs. The exact measurement at the time of sampling will
be stored and displayed. (Not normally used except during calibration)
b. Medium- some averaging will take place so that minor temperature fluctuations
will be filtered out. (This is the default value).
c. Slow – additional averaging will occur. (Not normally used).
5. Set the chart display (Y axis) with ‘Up’ and ‘Down’.This does not set the alarm.
Setting these values has no effect on the alarm, what data is collected, or what is
stored. It simply sets the upper and lower point of the Y-axis of the temperature
chart shown on the TV2. Any temperature that cannot be displayed on the chart
because it falls outside these limits will show as a point at the top or bottom of the
display.
Note: These limits can be adjusted at any time without affecting your data.
