A.O. Smith ProMax Direct-Vent GDV-40 Bedienungsanleitung

Features

DIRECT-VENT DESIGN

One-pipe, dual-channel closed system draws all make-up air from outside

the home, eliminating problems caused by insufficient indoor

ventilation and is FVIR compliant.

Horizontal air intake and venting on all models up to 80 inches from

outside wall with no electrical power needed.

DYNACLEAN™ DIFFUSER DIP TUBE

Helps reduce lime and sediment buildup, maximizes hot water output.

Made from long-lasting PEX cross-linked polymer.

GREEN CHOICE® GAS BURNER

Patented “Eco-Friendly” design reduces NOx emissions up to 33% and

complies with requirements for less than 40ng/j for low NOx.

PUSH BUTTON PIEZO IGNITOR

Makes lighting pilot fast and easy with one hand push button spark

ignition.

HEAT TRAP NIPPLES

Factory-installed.

DURABLE TAMPER-RESISTANT BRASS DRAIN VALVE

PERMAGLAS®GLASS COATING

Protects steel tank from buildup.

CSA CERTIFIED AND ASME RATED T&P

RELIEF VALVE

6-YEAR LIMITED TANK & PARTS WARRANTY

For complete information, consult written warranty or A. O. Smith Water

Products Company.

CODE COMPLIANCE

UBC, CEC, SBCC, HUD and BOCA National Codes. Meets or exceeds

the thermal efficiency and standby loss requirements of the U.S.

Department of Energy and current edition of ASHRAE/IESNA 90.1.

Meets or exceeds the Federal Energy Efficiency Standards effective

January 20, 2004, according to the National Appliance Energy

Conservation Act (NAECA) of 1992.

DESIGN-CERTIFIED BY CSA INTERNATIONAL

According to ANSI Z21.10.1– CSA 4.1 Standards governing storage-type water

heaters.

AOSRG45700

Residential Gas Water Heaters

Page 1 of 2

DIRECT-VENT

July 2011R

237962_AOSRG45700.indd 1237962_AOSRG45700.indd 1 7/6/11 3:42 PM7/6/11 3:42 PM

www.hotwater.com

For Technical Information and Automated Fax Service, call 800-527-1953. A.O. Smith Corporation reserves the right to make produ ct changes or improvements without prior notice.

MODEL

NUMBER

FIRST

HOUR

RATING

GALLONS

ENERGY

FACTOR GAL.

CAP.

BTU

INPUT

PER HOUR

RECOVERY

90ºF RISE

GALLONS

PER HOUR A B C** D E F

VENT

OUTLET*

APPROX.

SHIPPING

WEIGHT

(LBS)

GDV-40 73 .62 40 38,000 41 68 54-3/4 22-1/4 16 12-1/4 45-1/4 Co-Axial 167

GDV-50 87 .60 50 42,000 45 76 63-3/4 22-1/4 16 12-1/4 54 Co-Axial 185

GDVT-50 88 .59 50 50,000 55 76 64-3/4 22-1/4 16-1/4 12-1/2 55-1/2 Co-Axial 187

GDV-75 131 .59 75 55,000 60 76 65-3/4 26-1/4 16-1/4 12-1/2 55-1/2 Co-Axial 310

Recovery capacities based on actual performance tests.

* Dual-channel system has 3˝ vent pipe inside 6˝ air intake pipe, for the 40 & 50–gallon models.

The 75 gallon model uses a 4” x 7” co-axial pipe.

All Models Have 2” Foam Cavity.

Water connection 3/4” male all models.

75 gallon water connections are 12” on center.

** Allow 25 1/4¨ for 40 and 50–gallon models and 29 1/2¨ for 75–gallon models for

front–to–back dimensions for air intake at the rear of the heater.

GDV–40 Models are ENERGY STAR®qualified.

DIMENSIONS IN INCHES

FRONT

MAX VENT

EXTERIOR

WALL

6 DIA.

MIN VENT

42°

47°

25-1/4

TOP

DRAIN

T&P

Important! Vent Installation and Termination Requirements

Maximum horizontal vent distance is 80” to outside of exterior wall.

Minimum horizontal vent distance is 17” to outside of exterior wall.

Vent pipes may be trimmed (cut) for short vent installations.

For vent installation less than 30” the vent restrictor is required.

Place restrictor over the flue outlet on heater before installing the outlet vent

pipe to the heater.

Recommended installation height for the heater vent pipe should be

68” for 40 gallon models and 76” for the 50-gallon and 75-gallon

models (vent height).

Offset Vent Arrangement

1. When replacing an existing direct vent model,

the new vent pipe may drop from the minimum

vent height as much as 7 1/4” to exit through the

existing vent opening in the exterior wall.

2. Vent may have one horizontal 90 degree turn before

exiting through exterior wall (Do not combine both

offset vent arrangements in one installation) (See

examples in the installation manual)

High Rise Vent Arrangement

3. When vent termination is more than 80” above the

base of the heater. The horizontal vent run must be

a minimum of 22” from the center of the heater to

the outside exterior wall surface. (See example in the

installation manual)

Vent termination clearance hole through the exterior

wall should be approximately 7” diameter.

Snow accumulation and drifting should be considered

when locating the termination.

An optional wire grill vent cap protector is available

through the parts department. Part number 9006627005.

See the installation manual for complete installation

and venting requirements.

Residential Gas Water Heaters

DIRECT-VENT

AOSRG45700

Page 2 of 2

July 2011R

40 & 50 gal.

25-1/4

75 gal.

29-1/2

6” DIA. on 40 & 50 Gal. Models

7” DIA. on 75 Gal. Models

75 gal. vent

termination

cap is not

interchangeable

with vent cap

on 40 & 50 gal.

models

237962_AOSRG45700.indd 2237962_AOSRG45700.indd 2 7/6/11 3:42 PM7/6/11 3:42 PM

Andere Handbücher für ProMax Direct-Vent GDV-40

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere A.O. Smith Boiler Handbücher

A.O. Smith

A.O. Smith Voltex Hybrid Electric PHPT-80 Betriebsanleitung

A.O. Smith

A.O. Smith 101 Series Bedienungsanleitung

A.O. Smith

A.O. Smith XWH 150 Anleitung zur Verwendung

A.O. Smith

A.O. Smith Voltex Produktinformationsblatt

A.O. Smith

A.O. Smith TWI 35-200 Fehlerbehebungshandbuch

A.O. Smith

A.O. Smith BTP-600-2500 Anwendungshandbuch

A.O. Smith

A.O. Smith EQ 115 G Leitfaden

A.O. Smith

A.O. Smith T-M50 ASME Bedienungsanleitung

A.O. Smith

A.O. Smith Cyclone BFC-28 Fehlerbehebungshandbuch

A.O. Smith

A.O. Smith 105 Series Anwendungshandbuch

A.O. Smith

A.O. Smith AOSRG45200 Bedienungsanleitung

A.O. Smith

A.O. Smith 300 Series Bedienungsanleitung

A.O. Smith

A.O. Smith ATI-305-N Bedienungsanleitung

A.O. Smith

A.O. Smith Innovo 12-160 Installations- und Benutzerhandbuch

A.O. Smith

A.O. Smith CEWHR Series Bedienungsanleitung

A.O. Smith

A.O. Smith CONSERVATIONIST BTPV-650A Bedienungsanleitung

A.O. Smith

A.O. Smith LTE 66D Bedienungsanleitung

A.O. Smith

A.O. Smith BTN 120 THRU 400/A Series Bedienungsanleitung

A.O. Smith

A.O. Smith DRE Betriebsanleitung

A.O. Smith

A.O. Smith Residential Gas Water Heaters Bedienungsanleitung

A.O. Smith

A.O. Smith GPVL-50 Anleitung zur Verwendung

A.O. Smith

A.O. Smith FPSH Bedienungsanleitung

A.O. Smith

A.O. Smith BTH 300 Bedienungsanleitung

A.O. Smith

A.O. Smith Vertex GPHE-50 Bedienungsanleitung

Beliebte Boiler Handbücher anderer Marken

Kenmore

Kenmore 153.582400 Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON Eltronom SHU 5 S Bedienungsanleitung

clage

clage E-Mini Series Bedienungsanleitung

Toyotomi

Toyotomi Oil Miser OM-180 Bedienungsanleitung

Bradford White

Bradford White EF Series Bedienungsanleitung

Eccotemp

Eccotemp 40-H Bedienungsanleitung

Dimplex

Dimplex ECSd125-580 Leitfaden

Dux

Dux 32FCR6N Bedienungsanleitung

Noritz

Noritz N-132M Gebrauchsanweisung

TESY

TESY GCV7/4S 10047 Technisches Datenblatt

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Fehlerbehebungshandbuch

Koryo

Koryo KWHZF15Y Bedienungsanleitung

Pentair

Pentair PSC-14-4-02 Bedienungsanleitung

GE 40M06AAG Montageanleitung

Thermor

Thermor AEROMAX SPLIT 2 Bedienungsanleitung

American Hometec

American Hometec AHQ-B03X Bedienungsanleitung

PVI

PVI MAXIM Bedienungsanleitung

Sunerg Solar Energy

Sunerg Solar Energy Calor Top 200D Betriebsanleitung