Step 2
Assemble bench using the M8 button head bolts, the power supply for the machine and a
switch block is attached to the rear panel, the NUC (computer) needs to be attached.
Step 3
Lift the machine from the pallet (2 people), and place diagonally across the bench, this will
allow the studding to be screwed into position (3 places), use a nut to lock the stud in
place, then wind on a second nut (face down) as a location stop, once machine is placed
onto the bench, locating on the three studs, depending on age, studs maybe M6,M8 or
M10
Once on the bench, use a third nut to secure
machine to bench
Fasten the NUC with screws
provided, M3 X 12 with plastic
spacer
