CoreBlu X3 User Manual
●Soware Test
CoreBlu X3 has a Serial QRCode printed on the side, which maps to the Beacon MAC address. To
verify the CoreBlu X3 is transming packets we have to scan the Barcode via Beacon Manager
applicaon. Once Beacon Manager has been installed in the smartphone, select iBeacons. Aer
that click the no filter selected buon on top le of screen then click QR Code buon, scan the
QRCode on CoreBlu X3 and press apply, if CoreBlu X3 is turned on it will show on the list on the
screen.
Configuraon Seng:
Please refer to the configuraon guide .
Warning:
CoreBlu X3 contains electronic elements and a baery which should be properly disposed of. If a beacon
needs to be disposed of, please contact the manufacturer technical support first.
FCC Cauon:
This device complies with part 15 of applicable FCC Rules. Its operaon is subject to the following two
condions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operaon. Any changes or
modificaons not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against
harmful interference in a residenal installaon. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with The instrucons may cause harmful
interference to radio communicaons. However, there is no guarantee that interference will not occur in
a parcular installaon. If this equipment does cause harmful interference to radio or television
recepon, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separaon between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be
used in portable exposure condions without restricon.
