AKG PERCEPTION 170 Bedienungsanleitung
PERCEPTION
170
User Instructions.............................p. 2
Please read the manual before using the equipment!
Mode d’emploi .............................p. 14
Veuillez lire cette notice avant d’utiliser le système!
2
AKG PERCEPTION 170
Page
1 Precaution/Unpacking ..........................................................................3
1.1 Precaution ..................................................................................3
1.2 Unpacking ..................................................................................3
2 Description ...........................................................................................3
2.1 Introduction.................................................................................3
2.2 Features .....................................................................................3
2.3 Optional Accessories ...................................................................4
3 Interfacing ............................................................................................5
3.1 General.......................................................................................5
3.2 Pinout.........................................................................................5
3.3 Connecting the Microphone .........................................................5
4 Using Your Microphone.........................................................................6
5 Cleaning................................................................................................6
Page
6 Troubleshooting ....................................................................................7
7 Specifications .......................................................................................8
The International Page ..........................................................................19
Table of Contents
3
AKG PERCEPTION 170
1
Precaution/Unpacking
1.1 Precaution
Please make sure that the piece of equipment
your microphone will be connected to fulfills
the safety regulations in force in your country
and is fitted with a ground lead.
1.2 Unpacking
Check that the packaging contains all of the items
listed below:
• Microphone
• Stand adapter
• Carrying case
• Mini poster
Should any item be missing, please contact your
AKG dealer.
2 Description
2.1 Introduction
Thank you for purchasing an AKG product. This
Manual contains important instructions for setting
up and operating your equipment. Please take a
few minutes to read the instructions below care-
fully before operating the equipment and keep
the Manual for future reference. Have fun and
impress your audience!
The
PERCEPTION 170
is a heavy-duty, rugged true
condenser microphone built to the same strict qual-
ity standards as all other AKG products.
Designed on the basis of AKG’s decades of know-
how and feedback from sound engineers around
the world using AKG studio microphones every day,
this general-purpose small-diaphragm microphone
brings AKG studio quality to the worlds of recording,
live sound, and broadcasting.
2.2 Features
•Cardioid polar pattern: The microphone is
most sensitive to sounds arriving from in front
of it while picking up much less of sounds arriv-
ing from the sides or rear (from monitor speak-
ers or neighboring instruments). This makes the
microphone equally suited for recording and
onstage use.
•Gold-sputtered diaphragm: The diaphragm is
made of a plastic foil that is gold-sputtered on
one side only to prevent shorting to the back
electrode even at extremely high sound pres-
sure levels.
•All-metal body: The all-metal body adds to the
rejection of RF interference so you can use the
microphone near transmitter stations and along
with wireless microphones or other communi-
cations equipment. The extremely rugged,
heavy body and sturdy front grill protect the
microphone from damage from tough handling
on stage.
L
!
4
AKG PERCEPTION 170
•High headroom, minimum distortion:
Capable of handling sound pressure levels up
to 155 dB without introducing perceptible dis-
tortion and built to resist high temperatures and
humidity, the microphone will give excellent
results in a wide range of applications.
•Switchable preattenuation pad: The preat-
tenuation switch (1) on the microphone rear
(refer to fig. 1) lets you increase the headroom
by 20 dB for distortion-free close-in recording.
The preattenuation pad prevents the micro-
phone's output level, particularly at low fre-
quencies, from overloading the miniature
transformers used in many mixer input stages,
etc.
2.3 Optional Accessories
•PF 80 studio pop screen
•ST 305 floor stand
Fig. 1: Preattenuation switch (1) on
PERCEPTION
170
rear.
1
5
AKG PERCEPTION 170
3 Interfacing
3.1 General
The microphone uses a true condenser trans-
ducer designed for 48-volt phantom powering to
DIN 45 596/IEC 268-15. Neither the diaphragm nor
the backplate are permanently polarized, so the
microphone needs an external power supply.
3.2 Pinout
The microphone provides a balanced output on a 3-
pin male XLR connector:
Pin 1: ground
Pin 2: hot
Pin 3: cold
3.3 Connecting the Microphone
Refer to fig. 2 above.
1. Use an XLR cable to connect the microphone to
a balanced XLR input with phantom power.
2. Switch the phantom power on. (Refer to the user
manual of the unit to which you connected your
microphone.)
Fig. 2: Connecting to a balanced input with phantom power.
6
AKG PERCEPTION 170
4 Using Your Microphone
The
PERCEPTION 170
is a general-purpose cardioid
microphone for recording, broadcast, and onstage
use.
Every instrument radiates its sound in a specific
way. Therefore, to get the best sound it is crucial to
experiment with microphone placement.
• When recording wind instruments or vocals,
make sure not to blow or sing directly into
the microphone.
• To avoid unwanted wind and pop noise or mois-
ture problems, place an optional PF 80 pop
screen from AKG between the microphone and
vocalist/instrument.
•Keep the microphone dry. Moisture from
blowing or singing directly at the capsule from
a short distance, or extremely high humidity
may cause the microphone to start crackling or
go very quiet due to partial shorting of the
polarization voltage.
•High volume instruments: You can use this
microphone for close-in recording of very loud
instruments (brass instruments, kick drum,
etc.).
Use a pen or similar pointed object to set the
preattenuation switch to the “-20 dB” position.
This switches the preattenuation pad in, enabling
the microphone to handle sound pressure levels
up to 155 dB.
•Low-frequency noise: To suppress low-fre-
quency noise such as air conditioning rumble,
footfall noise, or traffic sounds, check whether
your mixer provides highpass filters on the
microphone channels. If it does, switch the
appropriate highpass filter in.
5 Cleaning
• To clean the surface of the microphone body,
use a soft cloth moistened with water.
7
AKG PERCEPTION 170
No sound.
Distortion.
Crackling noises or low output.
1. Power to mixer and/or amplifier is off.
2. Channel or master fader on mixer, or volume
control on amplifier is at zero.
3. Microphone is not connected to mixer or ampli-
fier.
4. Cable connectors are seated loosely.
5. Cable is defective.
6. No supply voltage.
1. Channel gain control on mixer set too high.
2. Microphone too close to sound source.
3. Microphone sensitivity set too high.
• Partial short-circuits due to excessive humidity.
1. Switch power to mixer or amplifier on.
2. Set channel or master fader on mixer or volume
control on amplifier to desired level.
3. Connect microphone to mixer or amplifier.
4. Check cable connectors for secure seat.
5.
Check cable and replace if damaged.
6. Switch phantom power on.
Check cable and replace if necessary.
1. Turn gain control down CCW.
2. Move microphone further away from sound
source.
3. Switch preattenuation pad in.
• Place microphone in warm, dry room and allow
to dry.
Problem Possible Cause Remedy
6 Troubleshooting
8
AKG PERCEPTION 170
Type: 0.5-inch diaphragm, externally
polarized condenser microphone
Polar pattern: cardioid
Frequency range: 20 Hz to 20 kHz
(see frequency response graph)
Sensitivity: 12 mV/Pa (-38.5 dBV ±3 dB)
Max. SPL for 0.5% THD: 135 / 155 dB SPL (0 / -20 dB)
Equivalent noise level
to CCIR 468-2: < 32 dB
Equivalent noise level
to IEC 60268-4: < 21 dB-A
Signal/noise ratio
(A-weighted): 73 dB (re 1 Pa)
Preattenuation pad: -20 dB (switchable)
Impedance: ≤ 200 ohms
Recommended load impedance:
≥ 1000 ohms
Supply voltage: 48 V ±4 V phantom power
to DIN 45 596 / IEC 268-15
Current consumption: ≤ 2 mA
Environment: temperature: -14°F to 140°F
humidity: 80% (@ 77°F)
Connector: 3-pin XLR (pin 2 hot)
Dimensions: 22 dia. x 160 mm high
(0.9 x 6.3 in.)
Net weight: 130 g / 0.29 lbs.
FCC Statement
The device complies with part 15 of the FCC rules. Operation is subject to the fol-
lowing two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
7 Specifications
9
AKG PERCEPTION 170
Frequency Response Polar Diagram
7 Specifications
10
AKG PERCEPTION 170
Table des matières
Page
1 Précautions/Déballage
.....................................................................................11
1.1 Précautions ................................................................................................11
1.2 Déballage ...................................................................................................11
2 Description
..........................................................................................................11
2.1 Introduction ................................................................................................11
2.2 Caractéristiques..........................................................................................11
2.4 Accessoires optionnels................................................................................12
3 Raccordement
....................................................................................................13
3.1 Généralités .................................................................................................13
3.2 Brochage....................................................................................................13
3.3 Comment connecter le microphone..............................................................13
Page
4 Utilisation du microphone
...............................................................................14
5 Nettoyage
............................................................................................................14
6 Dépannage
..........................................................................................................15
7 Caractéristiques techniques
...........................................................................17
La page internationale
.........................................................................................19
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Sprachen:
Andere AKG Mikrofon Handbücher
AKG
AKG C 3000 Bedienungsanleitung
AKG
AKG C900 Bedienungsanleitung
AKG
AKG PZM-10 Bedienungsanleitung
AKG
AKG D 5 Bedienungsanleitung
AKG
AKG C 444 Bedienungsanleitung
AKG
AKG C 535 EB Bedienungsanleitung
AKG
AKG D12 VR Bedienungsanleitung
AKG
AKG C900 Bedienungsanleitung
AKG
AKG BBB DFIVE Bedienungsanleitung
AKG
AKG C 4000 B Bedienungsanleitung
AKG
AKG MicroMic C516 ML Bedienungsanleitung
AKG
AKG C5 VOCAL Bedienungsanleitung
AKG
AKG PCC-160 Bedienungsanleitung
AKG
AKG C900 Bedienungsanleitung
AKG
AKG PERCEPTION 120 USB Bedienungsanleitung
AKG
AKG C 680 BL Bedienungsanleitung
AKG
AKG C4174055C Bedienungsanleitung
AKG
AKG C747 V11 Bedienungsanleitung
AKG
AKG D 7 Bedienungsanleitung
AKG
AKG D 65 S Bedienungsanleitung
Beliebte Mikrofon Handbücher anderer Marken
IK Multimedia
IK Multimedia iRig Stream MIC PRO Bedienungsanleitung
DAPAudio
DAPAudio RM-101 Bedienungsanleitung
Sennheiser
Sennheiser evolution wireless series EM 100 Bedienungsanleitung
Sony
Sony C-48 Bedienungsanleitung
GIGAMEDIA
GIGAMEDIA GGM PAMICUHFG Bedienungsanleitung
Shure
Shure WH30TQG Bedienungsanleitung
