Albatron PM945GC Bedienungsanleitung

PM945GC

All rights are reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a

retrieval system or translated into any language or computer language, in any form or by any means,

electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written

permission of the company. Brands and product names are trademarks or registered trademarks of their

respective companies.

The vendor makes no representations or warranties with respect to the contents herein and especially

disclaim any implied warranties of merchantability or fitness for any purpose. Further the vendor reserves

the right to revise this publication and to make changes to the contents herein without obligation to notify

any party beforehand. Duplication of this publication, in part or in whole, is not allowed without first

obtaining the vendor’s approval in writing.

Trademark

All the trademarks or brands in this document are registered by their respective owner.

Disclaimer

We make no warranty of any kind with regard to the content of this user’s manual. The content is subject

to change without notice and we will not be responsible for any mistakes found in this user’s manual. All

the brand and product names are trademarks of their respective companies.

FCC Compliance Statement

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at his own expense.

However, there is no guarantee that interference will not occur in a particular installation.

CE Mark

The device is in accordance with 89/336 ECC-ENC Directive.

er: EG10

PM945GC

Intel®945GC & ICH7

Support Socket 775 Intel®CoreTM 2 Duo/ Pentium®D/

Pentium®4/ Celeron®D/ Celeron®Processor

User Manual

Enabling the Hyper-Threading Technology, your computer system is

required to have components as the following:

CPU: An Intel®Pentium®4 Processor with HT Technology

Chipset: An Intel®Chipset that supports HT Technology

BIOS: A BIOS that supports HT Technology must be enabled

OS: An operating system that supports HT Technology

For more information on Hyper-Threading Technology, go to:

http://www.intel.com/info/hyperthreading

Dimensions (Micro-ATX form-factor):

210mm x 244mm ( W x L )

Operating System:

Windows®Vista/ XP/ 2000

Attention- Im

ortant Information

Follow the procedures below…

Troubleshooting Tips

Refer to other sections in this manual…

Things You Have To Know

0The images and pictures in this manual are for reference only and may vary from the

product you received depending on specific hardware models, third party components

and software versions.

0This mainboard contains very delicate IC chips. Always use a grounded wrist strap

when working with the system.

0Do not touch any IC chip, lead, connector or other components.

0Always unplug the AC power when you install or remove any device on the mainboard

or when confuguring pins and switches.

Packing List

PM945GC Mainboard

IDE Cable

SATA Cable

I/O Bracket

Mainboard Setup Driver & User Manual CD

Mainboard Quick Installation Guide

Symbols

Table of Contents

CHAPTER 1. GETTING STARTED ..................................................................1

INTRODUCTION....................................................................................................... 1

SPECIFICATION ....................................................................................................... 2

CONFIGURATION .................................................................................................... 5

Layout of PM945GC ....................................................................................... 5

HARDWARE INSTALLATION ................................................................................... 6

CPU Processor Installation.............................................................................. 6

Memory Installation: DIMM1/DIMM2........................................................... 7

Back Panel Configuration................................................................................ 9

Front Panel Headers: JW_FP, PWRLED, SPEAK ........................................ 11

Connectors..................................................................................................... 12

Headers & Jumpers........................................................................................ 13

Audio Configuration...................................................................................... 14

Slots ............................................................................................................... 15

Power Supply Attachments............................................................................ 16

CHAPTER 2. BIOS SETUP............................................................................ 17

INTRODUCTION..................................................................................................... 17

MAIN MENU ......................................................................................................... 18

CHAPTER 3: SOFTWARE SETUP ............................................................... 20

SOFTWARE LIST ................................................................................................... 20

SOFTWARE INSTALLATION ................................................................................... 20

CHAPTER 4: TROUBLESHOOTING ............................................................ 24

APPENDIX I: 8/6/4/2 CHANNEL AUDIO EFFECT SETUP......................................... 26

Mainboard PM945GC

Chapter 1. Getting Started

Introduction

Thanks for choosing PM945GC Mainboard. It is based on Intel®945GC Northbridge chipset

and Intel®ICH7 Southbridge chipset. In addition, it also supports integrated Graphics Media

Accelerator 950 for onboard graphics feature. It supports Intel®CoreTM 2 Duo/ Pentium®D/

Pentium®4/ Celeron®D/ Celeron®Processors with FSB (Front Side Bus) frequencies of 1066

MHz (by overclocking)/ 800 MHz/ 533 MHz.

The PM945GC provides two DIMM (Dual In-Line Memory Modules) sockets which allowing

you to install 240-pin, unbuffered non-ECC, DDRII 667 (by overclocking)/ DDRII 533/ DDRII

400 SDRAMs. It also supports Dual Channel Technology and allows you installing a total

memory capacity of 2 GB.

This mainboard provides one PCI-Express interface slot up to x16 mode which is

recommended that insert a graphics card onto the PCI-Espress x16 slot. In addition, two

standard PCI slots for use with standard PCI expansion cards are also allowed.

The PM945GC provides one floppy disk drive connector that can be used with

360KB/720KB/1.2MB/1.44MB/2.88MB drives. It also has one IDE connector for IDE hard

drives supporting Ultra ATA 100/66/33. Moreover, this mainboard comes with Serial ATA II

support with four SATA II connectors which provide up to 3 Gbps data transfer rates.

The onboard High Definition Audio CODEC (ALC861) supports high quality performance

8-channel audio play (Super 7.1 Channel Audio Effect) <See Appendix I>.

The PM945GC also comes with an onboard 10/100 Mbps Ethernet LAN chip. There is a LAN

port on the back panel of your case that you can directly plug into an Internet cable.

There are maximal eight USB2.0/ 1.1 ports which can be set up on this mainboard.

All the information (including hardware installation and software installation) in this manual are

for reference only. The contents in this manual may be updated without notice. The company

will not assume any responsibility for any errors or mistakes within.

Mainboard PM945GC

Specification

CPU:

Support Socket 775

Support Intel®CoreTM 2 Duo/ Pentium®D/ Pentium®4/ Celeron®D/ Celeron®

Processors

Support Hyper-Threading Technology

Support 1066 MHz (by overclocking)/ 800 MHz/ 533 MHz FSB (Front Side Bus)

Frequencies

Chipset:

Northbridge Chipset – Intel®945GZ

Southbridge Chipset – Intel®ICH7

I/O Controller –Fintek®F71882FG

High Definition Audio Codec – Realtek®ALC861

LAN Controller – Realtek®RTL 8100C

Memory:

Two DIMM sockets

Supports unbuffered & non-ECC DDRII 667 (by overclocking)/ DDRII 533/ DDRII 400

SDRAM

Supports a total memory capacity of up to 2 GB

Supports Dual Channel data bus

Onboard HD Audio Codec (ALC 861):

High performance Codec with high S/N ratio (>90 db)

Supports 8/6/4/2 channel playback capability

Supports jack sensing and re-tasking function

Built-in Dolby Digital Live Technology

Slots:

One PCI-Express x16 interface slot for graphics card or expansion card

Two standard PCI slots for PCI standard expansion cards

FDD Connector:

Mainboard PM945GC

Supports one FDD connector to set up to two floppy disk drives

Supports 360KB/ 720KB/ 1.2MB/ 1.44MB/ 2.88MB

IDE Connector:

One IDE connector

Supports up to two IDE devices

Supports Ultra ATA 33/66/100

Supports high capacity hard disk drives

Serial ATA II Connector:

Four SATA II connectors

Supports SATA 2.0 specification and with transmit rate up to 3 Gbps

One SATA connector can only support one SATA HDD

Onboard LAN Chip:

10/100 Mbps Ethernet LAN supported

I/O facility Connectors

One multi-mode Parallel Port is capable to support as the following:

1. Standard & Bi-direction Parallel Port

2. Enhanced Parallel Port (EPP)

3. Extended Capabilities Port (ECP)

Supports one serial port

Supports one VGA port (=D-Sub)

Supports one PS/2 mouse port and one PS/2 keyboard port

Universal Serial Bus:

Four onboard USB 2.0/ 1.1 ports

Two front USB headers come with this mainboard for additional four USB ports

Support a maximum of eight USB ports to connect USB compliant devices

BIOS:

Phoenix-Award™ BIOS

Support APM1.2

Support ACPI 2.0 power management

Mainboard PM945GC

Green Function:

Supports Phoenix-Award™ BIOS power management function

Supports system-wake-from-power-saving-mode by keyboard or mouse touching

Shadow RAM:

Integrated memory controller provides shadow RAM functionality and supports ROM

BIOS

Flash Memory:

Supports flash memory functionality

Supports ESCD functionality

Hardware Monitor Function:

Monitors CPU/ Chassis Fan Speed

Monitors CPU and system temperature

Monitors system voltages

Mainboard PM945GC

Configuration

Layout of PM945GC

Mainboard PM945GC

Hardware Installation

This section will assist you in quickly installing your system hardware. Wear a wrist ground strap before

handling components. Electrostatic discharge may damage the system’s components.

CPU Processor Installation

This mainboard supports Intel®CoreTM 2 Duo/ Pentium®D/ Pentium®4/ Celeron®D/ Celeron®Processors

using a Socket 775. Before building your system, we suggest you to visit the Intel website and review the

processor installation procedures. http://www.intel.com

CPU Socket 775 Configuration Steps:

1. Locate the CPU socket 775 on your

mainboard and nudge the lever away

from the socket as shown. Then lift the

lever to a 140-degree angle (A). Next, lift

up the iron cover (B).

2. There are 2 distinctive marks located

near the corners of the socket on the

same side as the lever as shown (C).

Match these marks with the marks on the

CPU and carefully lower the CPU down

onto the socket (D).

3. Replace the iron cover and then lower

the lever until it snaps back into position

(E). This will lock down the CPU (F).

4. Smear thermal grease on the top of the

CPU. Lower the CPU fan onto the CPU/CPU socket and secure it

using the attachments or screws provided on the fan. Finally,

attach the fan power cord to the CPUFAN header.

Attention

DO NOT touch the CPU pins in case they are damaged. Also, make sure

that you have completed all installation steps before powered on the

system. Finally, double-check that the cooling fan is properly installed and

the CPU fan power cord is securely attached, in case your CPU and other

sensitive components are damaged because of high temperatures.

Andere Handbücher für PM945GC

Inhaltsverzeichnis

Andere Albatron Hauptplatine Handbücher

Albatron

Albatron KM18G PRO Bedienungsanleitung

Albatron

Albatron ABOX 865G SERIES Bedienungsanleitung

Albatron

Albatron PX845PE Series Bedienungsanleitung

Albatron

Albatron KX18D PRO II Bedienungsanleitung

Albatron

Albatron K8SLI Bedienungsanleitung

Albatron

Albatron KI51PV-754 Bedienungsanleitung

Albatron

Albatron P4M800-775 Bedienungsanleitung

Albatron

Albatron KX400-8XV Pro Bedienungsanleitung

Albatron

Albatron PX845PEV-800 Gebrauchsanweisung

Albatron

Albatron PXP35 Bedienungsanleitung

Albatron

Albatron PXP35 Bedienungsanleitung

Albatron

Albatron PI960GLE Bedienungsanleitung

Albatron

Albatron KM400T-8X Pro Bedienungsanleitung

Albatron

Albatron PXP43 Bedienungsanleitung

Albatron

Albatron PXP965 (V2.0) Bedienungsanleitung

Albatron

Albatron PM73V Bedienungsanleitung

Albatron

Albatron PX865PE7 Bedienungsanleitung

Albatron

Albatron K8X890 Series Bedienungsanleitung

Albatron

Albatron K8Ultra-U Series Bedienungsanleitung

Albatron

Albatron K8X250GB PRO Bedienungsanleitung

Albatron

Albatron PX865PEC PRO(2.0) Bedienungsanleitung

Albatron

Albatron KX550 Bedienungsanleitung

Albatron

Albatron PM800 Series Bedienungsanleitung

Albatron

Albatron PX925XE Series Bedienungsanleitung

Beliebte Hauptplatine Handbücher anderer Marken

DFI

DFI SD170 Bedienungsanleitung

ASROCK

ASROCK ROMED8-2T Bedienungsanleitung

Asus

Asus P2L97A Bedienungsanleitung

Winmate

Winmate IC70 Bedienungsanleitung

Asus

Asus MES-B Bedienungsanleitung

Grantech

Grantech SYS8F377VGGA-3OMN Bedienungsanleitung

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Bedienungsanleitung

Texas Instruments

Texas Instruments ADS8372EVM Bedienungsanleitung

Commell

Commell MS-C73 Bedienungsanleitung

Gigabyte

Gigabyte GA-9IVDT Bedienungsanleitung

IBT Technologies

IBT Technologies MB860 Bedienungsanleitung

Nvidia

Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung

Intel

Intel D33217CK Bedienungsanleitung

Asus

Asus F1A55-M LX PLUS R2.0 Bedienungsanleitung

EPC

EPC EPC9147C Bedienungsanleitung

Asus

Asus EX-B760M-V5 D4 Bedienungsanleitung

EPOX

EPOX MU-8KHA0010 Bedienungsanleitung

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Bedienungsanleitung