Alecto DBX-83 Bedienungsanleitung

DBX-83

USER’S MANUAL

INTRODUCTION

The DBX-83 is a sound-operated baby unit that functions according

to the PMR-446 principle. As soon as the DBX-83 detects any sound,

this will be transmitted on a frequency of 446 MHz. This signal can be

received by the parent unit of the Alecto DBX-82 or by other (Alecto)

PMR-446 baby monitors.

APPLICATION:

Used as an additional baby unit:

DBX-83 baby units in combination with the Alecto DBX-82 can be used

to monitor several babies or spaces simultaneously.

Used as a separate baby unit:

DBX-83 baby units in combination with any (Alecto) PMR-446 baby-

phone can be used as a full-fledged baby monitoring system.

USER INSTRUCTIONS:

Used as an additional baby unit:

If you’ve purchased this baby unit as an expansion unit for your Alecto

DBX-82, you can put this booklet aside. All the functions of this baby

unit are also described in the user manual supplied with the DBX-82.

Used as a separate baby unit:

If you’ve purchased this baby unit in combination with another PMR-446

babyphone to use as a baby monitoring system, please read this user

manual for all baby monitor functions and the user manual of your baby-

phone for the receiver functions.

FUNCTION OVERVIEW

DISPLAY OVERVIEW

Display

Setup buttons

Function

button

Sensitivity

control (rear)

Power switch

Built-in

microphone

External

microphone

input

channel number

illuminates when

the connec-

tion control is

enabled

illuminates while

transmitting

illuminates when

the ‘attention tone’

is enabled

sub-channel

number

illuminates when

the monitor func-

tion is enabled

INSTALLATION

POWER SUPPLY:

The baby unit is powered by the supplied, fixed power adaptor. Plug

this connector into a 230V wall socket.

POSITIONING:

Place the baby unit in the baby room. We recommend you to maintain

a distance of at least 2 meters between the baby and baby unit.

Always make sure that the baby cannot reach the baby unit or adaptor

cable.

WALL-MOUNTING:

The baby unit can also be mounted to a wall by using the keyhole

opening at the rear of the unit.

USE

POWER ON/OFF:

Slide the power switch at the right side to the ‘1’ position to turn on the

baby unit. Slide this switch to the ‘0’ position to turn off the baby unit.

CHANNEL & SUB-CHANNEL:

Check whether the baby unit and your babyphone are set to the same

channel and sub-channel. Refer to the next page if this setting must be

changed in the baby unit.

OPERATION:

As soon as the baby unit detects any sound, the transmitter is acti-

vated and the sound will be transmitted to your babyphone.

SENSITIVITY:

Use the rotary VOXSENS control at the rear of the baby unit to adjust

the sensitivity level. When turned fully anti-clockwise, you set the low-

est level, fully clockwise is the highest sensitivity level.

ADDITIONAL FUNCTIONS AND SETTINGS

CHANGING THE TRANSMITTING CHANNEL:

1. press 1x the MENU button; [CH] will appear following the channel

indication

2. press the or button to select a different channel (1-8)

3. press the MENU button to save the new channel

CHANGING THE SUB-CHANNEL (CTCSS):

1. press 2x the MENU button; the sub-channel indication will be

enlarged, followed by the [Ct]

2. use the or button to select the desired sub-channel (1-38) or to

disable this function by setting sub-channel 00

3. press the MENU button to save the sub-channel

CTCSS code description

Continuous Tone Controlled Squelch System is a tone code, send

along while transmitting. You cannot hear this tone code. Only when

the tone code of the baby unit corresponds to the tone code of your

babyphone, the babyphone will receive the signal. This prevents inter-

ference in the babyphone caused by other devices communication on

the same channel.

MAKE SURE TO SET THE BABY UNIT

AND BABYPHONE TO THE SAME CHANNEL

AND SUB-CHANNEL.

CONNECTION CONTROL:

You can have the baby unit transmit 3 short beep tones every 30 sec-

onds which will be received by your babyphone. This way, the con-

nection is checked every 30 seconds. You can enable or disable this

function as follows.

1. press 3x the MENU button; the word [BEEP] will appear

2. press the button to enable this function ([ON] in the display) or

press the button to disable this function ([OF] in the display)

3. press the MENU button to save your setting

MONITORING:

You can set the baby unit to transmit for 5 seconds every 5 minutes,

also when the baby unit is not detecting any sound.

1. press 4x the MENU button; the words [AUTO MON] will appear

2. press the button to enable this function ([ON] in the display) or

press the button to disable this function ([OF] in the display)

3. press the MENU button to save your setting

ATTENTION TONE:

You can set the baby unit to first send an attention tone each time the

unit starts transmitting. This signal distinguishes itself from any other

signals you might be receiving.

1. press 5x the MENU button; the word [CA] will appear

2. press the button to enable this function ([ON] in the display) or

press the button to disable this function ([OF] in the display)

3. press the MENU button to save your setting

Remark: these tones are NOT added to the beep tones transmitted for

checking the connection.

EXTERNAL MICROPHONE:

You can connect an external microphone with a 2.5mm plug to the

right side of the baby unit. This will automatically disable the baby

unit’s built-in microphone.

You can use this function to e.g. monitor a space where you cannot

place the baby unit itself.

USER TIPS

GENERAL:

* Only use the baby unit as an additional peace of mind, it can never

serve as a replacement for an adult or human and baby sitter.

* Before every use, always check whether the baby unit is functioning

correctly.

* You are not required to have a license for the use of this baby inter-

com. The system can be freely applied in any domestic situation.

However, an interference-free signal transmission cannot always be

guaranteed.

* When the unit is not in use, please always switch it off.

PLACEMENT TIPS:

* Do NOT place the baby unit in the bed with the baby, but maintain

a minimal distance of 2 meter between the baby and the baby unit.

Make sure the baby cannot touch the adaptor cable.

* Do not expose the baby-unit or parent-unit to direct sunlight or

humid areas.

POWER SUPPLY:

Only use the supplied adaptor. Connecting power adaptors other than

the supplied adaptors can cause damage to the electronics of the

baby unit.

RADIO CONNECTION:

* The DBX-83 is a transmitter working with radio waves on the

446 MHz band. Its signal transmission can be affected by external

influences such as other radiophones, transmitters, wireless phones,

etc. When your radiophone is being interfered with or causes inter-

ference, simply changing the channel usually solves this problem.

* The baby unit has an effective range from up to 3Km. This range

can be affected by local conditions such as high buildings, high volt-

age posts and overhead wires. An optimal range is achieved when

the baby unit has a clear sight of the receiver.

The use of this baby unit is permitted in all the countries of the EU. If

you want to bring the DBX-83 to countries outside the EU, you should

consult the local restrictions on the use of PMR446 equipment.

* Don’t forget that the signal of the baby unit can also be heard by

another 446 MHz baby monitors, radiophones or receivers other

than yours.

* Never use the baby unit outdoors during thunderstorms.

SERVICE & MAINTENANCE:

* Only clean the baby unit with a moist cloth. Always remove the

adaptor from the wall socket before cleaning.

* Prevent water and/or sand from penetrating the baby unit.

* Modifying the electronics or antenna of the baby unit in any way is

not permitted. Servicing must be performed by professional service

personnel.

ENVIRONMENT:

* When discarding your radiophone, please return it to

your dealer. They can guarantee environment-friendly

disposal.

TECHNICAL SPECIFICATIONS

Operating frequency: 446.00625 MHz to 446.09375 MHz

(8 channels, 38 sub-channels)

Channel separation: 12.5 KHz

Power supply: 9V / DC / 300mA, via adapter

Range: Up to 3Km

Conform: EN 300296-2V1.3.1

EN 301489-5V1.3.1(2002-08)

EN60950-1:A12:2011

TROUBLESHOOTING

In case of any problems, always check first whether the DBX-83 does

work correctly on a different location. When suspecting a fault, always

verify the correct operation and settings of your babyphone as well.

No function:

- the adaptor of the baby unit is not connected to a wall socket or this

wall socket is not providing power, please check this

Weak or no reception:

- incorrect setting of channel or sub-channel (the baby unit and baby-

phone must be set to the same channel, with the same sub-channel)

- the distance between the transmitter and receiver is too large,

please reduce the distance

Noise:

- presence of other transmitter, please change the channel

- interference from other devices, turn these devices off (if possible)

High whistle:

- the transmitter is too close to the receiver of the volume of the

receiver is set too high, please increase the distance or decrease

the volume

If you cannot resolve the issue with the above suggestions, please

remove the batteries from the radio and the baby unit after several

minutes. If this still doesn’t resolve the issue, please contact Alecto

customer service on the phone number 073 6411 355

DECLARATION OF CONFORMITY

The declaration of conformity is available on the

website WWW.ALECTO.INFO

Inhaltsverzeichnis

Andere Alecto Babyphone Handbücher

Alecto

Alecto DBX-20 Bedienungsanleitung

Alecto

Alecto DBX-89 Bedienungsanleitung

Alecto

Alecto DVM-80 Bedienungsanleitung

Alecto

Alecto DIVM-550 Bedienungsanleitung

Alecto

Alecto DVM-73 Bedienungsanleitung

Alecto

Alecto DVM-67 Bedienungsanleitung

Alecto

Alecto DBX-88eco Bedienungsanleitung

Alecto

Alecto DVM-50 Bedienungsanleitung

Alecto

Alecto DBX-77 Bedienungsanleitung

Alecto

Alecto DVM-65 Bedienungsanleitung

Alecto

Alecto DBX-115 Bedienungsanleitung

Alecto

Alecto DBX-92 Bedienungsanleitung

Alecto

Alecto DBX-85GS Bedienungsanleitung

Alecto

Alecto DBX-33 Bedienungsanleitung

Alecto

Alecto DVM-190 Bedienungsanleitung

Alecto

Alecto DVM-700 Bedienungsanleitung

Alecto

Alecto DBX-62 Bedienungsanleitung

Alecto

Alecto DBX-99 Bedienungsanleitung

Alecto

Alecto DOS-150 Bedienungsanleitung

Alecto

Alecto DBX-90 Bedienungsanleitung

Alecto

Alecto DBX-10 Bedienungsanleitung

Alecto

Alecto DVM-260+ Bedienungsanleitung

Alecto

Alecto CYHA050100VWEU Bedienungsanleitung

Alecto

Alecto DVM-77 Bedienungsanleitung

Beliebte Babyphone Handbücher anderer Marken

Philips

Philips SCD 469 Bedienungsanleitung

Oricom

Oricom Babysense 7 Bedienungsanleitung

Levana

Levana TW502 Bedienungsanleitung

Luvion

Luvion Essential Bedienungsanleitung

Philips

Philips AVENT SCD841 Bedienungsanleitung

NUK

NUK Eco Control Video Display 550VD Bedienungsanleitung

Lorex

Lorex sweet peek mini Bedienungsanleitung

Mondevices

Mondevices MonBaby 2 Bedienungsanleitung

Famidoc

Famidoc FDBB-V2 Bedienungsanleitung

Graco

Graco iMonitor 2797 Bedienungsanleitung

babymoov

babymoov High Care A014001 Bedienungsanleitung

Ramili

Ramili RV1000 Bedienungsanleitung

Philips

Philips SBC SC364 Bedienungsanleitung

Swann

Swann SW231-FLO Bedienungsanleitung

Badabulle

Badabulle Baby Online 300 m+ Bedienungsanleitung

Philips AVENT

Philips AVENT SCD526/00 Bedienungsanleitung

Uniden

Uniden Guardian UBR223 Bedienungsanleitung

Summer

Summer Day & Night 28470A Bedienungsanleitung