Argos 274/6661 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 38cm

Depth - 40cm

Height - 44.5cm

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 4 - 09/09/14

Important - Please read these instructions fully before starting assembly

ALR3001

274/6661

228/9300

258/1187

1 Drawer Bedside

NEW MK2 VERSION

Issue 2 - 11/06/13 - Rebates taken off,Top Rail removed, panel numbers updated.

Issue 3 - 02/04/14 - Drawer box size increased.

Add 2 drawer wedges.

Add 4 plastinails.

Issue 4 - 09/09/14 - Removed‘Anderson’from the title so it can be used for both Anderson and Normandy.

Added 3 new cat codes for Normandy.

358/9896

331/5929

346/8302

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 10kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: If there is any

chance of this unit being pulled

over by children etc. it is

recommended that the unit is

secured to a wall using suitable

fixings (not supplied).

• Dispose of all packaging

carefully and responsibly.

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Drawer Back (W314-124)

(314 x 124mm)

Drawer Base (T325-367)

(325 x 367mm)

9 10

Left Side (D2350A)

(422 x 372mm)

Drawer Front (D2353A)

(367 x 176mm)

Right Side (D2351A)

(422 x 372mm)

Base (D2352A)

(347 x 368mm)

6Plinth (D2354A)

(347 x 60mm)

Back (X380-373)

(380 x 373mm)

Top (D2349A)

(380 x 396mm)

Left Drawer Side (W370-124LH)

(370 x 124mm)

Right Drawer Side (W370-124RH)

(370 x 124mm)

Please check you have all the fittings listed below

Tools required

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 4

Metal dowel (F901) x 10

Large locking

nut (F900) x 8

Small locking

nut (F3) x 2

Rule Scissors Hammer

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Nail (F51) x 10

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

9mm Screw (F74) x 2

9mm Screw (F73) x 4

Drawer runner (F1004) x 2

see malibu fitment mk2 for large number of panels and fittings

Knock-in Peg (F171) x 4

KHandle (F847a ) x 1

aKHandle Screw (F847b) x 2

NEW MK2 VERSION

Kit not changed but,Top Rail removed and only 4 dowels needed

Plastic Nail (F91) x 4

Wedgefix (F639) x 2

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

Step 2

Prepare the drawer

front

Screw 2 metal dowels

into the holes shown on

the back of the drawer

front .

Note: Tighten metal

dowels up fully against

the panels.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and right drawer

side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 3

Attach the drawer

sides to the drawer

front

Push the left drawer side

. and right drawer side

. onto the back of the

drawer front .

Use a screwdriver to

tighten the 2 small

locking nuts fitted to

the left drawer side

and right drawer side .

Note: Turn the small

locking nuts as far as

they will go - more than

1/2 a turn.

Small groove

Note: Due to the manufacturing process, the holes for the

locking nut can be on either surface of the drawer sides.

Note: The locking nuts can be on

either surface of the drawer sides.

Make sure that the small groove

is on the inside, as shown.

Assembly Instructions

Use 2nd hole in from front of

Runner F1004 to fit 1st F73 then

fit other F73 to match other hole.

Rebated Edge

F73

COVERED EDGE

Use 2nd hole in from front of

Runner F1004 to fit 1st F73 then

fit other F73 to match other hole.

F1004

When you insert F900,

make sure the arrow is

pointing towards the hole

in the edge of the panel.

F900

F73

F1004

COVERED EDGE

Step 4

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

Step 5

Fit the drawer back

between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

Step 6

8 9

Attach the handle

Attach a handle to

the drawer front

using 2 screws .

K a

K b

325mm

Step 7

Fit the wedgefixes

Turn the drawer

assemblies over and

slide 2 wedgefixes

into the front and back

grooves, as shown, and

tighten up the screws.

K b

Assembly Instructions

Step 8

10mm

Finished

front edge

Prepare the left side

a: Place a runner on

the left side as

shown. Slide back the

top of runner and use the

2nd hole from the front

to fit the 1st screw .

b: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the left side .

c: Insert 1 large locking

nut into the left side

. as shown.

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Tap a wooden dowel

into the left side .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Screw 3 metal dowels

into the left side .

Finished front edge

Assembly Instructions

Step 9

Prepare the right side

a: Place a runner on

the right side as

shown. Slide back the

top of runner and use the

2nd hole from the front

to fit the 1st screw .

b: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the right side .

c: Insert 1 large locking

nut into the right side

. .

Tap a wooden dowel

into the right side .

Screw 3 metal dowels

into the right side .

Finished

front edge

Finished front edge

Finished

front edge

Assembly Instructions

Prepare the plinth and

base

a: Insert 2 large locking

nuts into the holes in

the plinth .

Tap 2 wooden dowels

into the ends of the

plinth .

b: Insert 4 large locking

nuts into the base

Step 10

Step 11

Fit the plinth and base

to the right side

Push the plinth and

the base onto the

right side .

Use a screwdriver to

tighten the 3 large

locking nuts fitted to

the plinth and base.

Note: Turn each large

locking nut as far as it

will go - more than 1/2 a

turn.

E4.

Plain

chipboard

surface

Plain

chipboard

surface

Finished

front edge

Rounded

front edge

Assembly Instructions

Step 12

Fit the left side

Push the left side

onto the assembly.

Use a screwdriver to

tighten the 3 large

locking nuts fitted to

the plinth and base

. .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Step 13

Prepare the top

Screw 2 metal dowels

into the top .

Note: Tighten metal

dowels up fully against

the panel.

Step 14

Fit the top

Push the top onto

side panels and .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the inside of the side

panels and .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

1 2

Rounded

front edge

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos 617/3113 Bedienungsanleitung

Argos

Argos 875/4664 Bedienungsanleitung

Argos

Argos Evelyn 340/3790 Bedienungsanleitung

Argos

Argos Solid Wood Linen Bin 8318471 Bedienungsanleitung

Argos

Argos Aspley 459/1261 Bedienungsanleitung

Argos

Argos Hartley 331/1538 Bedienungsanleitung

Argos

Argos SKYE WOOD 481/5136 Datenblatt

Argos

Argos Amersham 881/4968 Bedienungsanleitung

Argos

Argos Lavendon 275473 Bedienungsanleitung

Argos

Argos Phoenix 162/2690 Bedienungsanleitung

Argos

Argos Malibu Bedienungsanleitung

Argos

Argos Seville 151/3297 Bedienungsanleitung

Argos

Argos RETRO 213/3274 Bedienungsanleitung

Argos

Argos Devon 532/7623 Bedienungsanleitung

Argos

Argos Canterbury 4 DR 6 DRW ROBE Bedienungsanleitung

Argos

Argos 875/4334 Bedienungsanleitung

Argos

Argos 620/4721 Bedienungsanleitung

Argos

Argos Oakhampton 391/8333 Bedienungsanleitung

Argos

Argos 642/0110 Bedienungsanleitung

Argos

Argos 346/0348 Bedienungsanleitung

Argos

Argos AVR 4 Seater Patio Set Bedienungsanleitung

Argos

Argos Home Venetia Bedienungsanleitung

Argos

Argos 1589317 Bedienungsanleitung

Argos

Argos Vince 697/1470 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung