Argos Dalton 617/3601 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 120cm

Depth - 44cm

Height - 71.5cm

Dalton - Pedestal Desk

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 3 - 24/09/13

Important - Please read these instructions fully before starting assembly

ALR2816

617/3601

Issue 2 - 06/12/12 - New drawings have now been issued for the Left End and Upright.

These show the hole that was missing for the middle screw on the runner (these screws were in the kit already and the quantity on the components page now shows the correct amount).

The quantity of 6x1/2 C/S screws in the kit has now been increased to 12 and there are now enough to secure the runners.

Steps 9 and 11 altered to show the updated panels and screw quantities.

Issue 3 - 24/09/13 - Argos code added for Walnut - 158/5122

158/5122

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 23kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

bracket supplied.

• Dispose of all packaging

carefully and responsibly.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Top (D1821A)

(1200 x 440mm)

Left End (D1822A)

(700 x 395mm)

Right End (D1823A)

(700 x 395mm)

Upright (D1824A)

(700 x 395mm)

Modesty (D1825A)

(673 x 280mm)

Rail (D1827A)

(350 x 75mm) x 2

2 3

4 5

Shelf (D1826A)

(350 x 394mm)

6 7 Drawer Front (D1828A)

(346 x 196mm) x 2

Left Drawer

Side (W509LH)

(330 x 115mm) x 2

Right Drawer

Side (W509RH)

(330 x 115mm) x 2

Drawer Back (W550)

(301 x 115mm) x 2

Back (X922)

(221 x 378mm)

Drawer Base (T550)

(312 x 327mm) x 2

10 11

12 13

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 4

Metal dowel (F901) x 22

Large locking

nut (F900) x 18

H I

Small locking

nut (F3) x 4

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

19mm Screw (F461) x 4

J K

Knock-in Peg (F171) x 8

13mm Screw (F52) x 12

13mm Screw (F79) x 1

Nail (F51) x 8

Handle (F287) x 2

MR Runner (F160) x 2

L Runner (F161) x 2

L Runner (F159) x 2

R Runner (F162) x 2

13mm Screw (F63) x 12

Bracket (F327) x 1

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

x 2

x 2 x 2

Step 2

Prepare the 2 drawer

fronts

Screw 2 metal dowels

into the holes shown on

the back of each drawer

front .

Note: Tighten metal

dowels up fully against

the panels.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and right drawer

side .

Note: Arrow on locking

nut must point towards

hole in edge of panel.

Step 3

Attach the drawer

sides to the drawer

front

Push the left drawer side

. and right drawer side

. onto the back of the

drawer front .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

Groove

DDD

10 11

Note: Due to the manufacturing process, the holes for the

locking nut can be on either surface of the drawer sides.

Note: The locking nuts can be on either surface of the drawer sides.

Make sure that the groove is on the inside, as shown.

x 2

Assembly Instructions

Step 4

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

Step 5

Fit the drawer back

between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

Step 6

10 11

Attach the handles

Attach a handle to

each drawer front

using 2 screws .

x 2

Assembly Instructions

Step 7

Fit runners to the

drawers

Turn the 2 drawer

assemblies over.

Fit runner , marked

with ‘R’, to the bottom

edge of the right drawer

side , as shown,

making sure that it is

pushed up against the

back of the drawer front

. . Use a bradawl to

mark the fixing positions,

then secure with 2

screws .

Fit runner , marked

‘L’, to the bottom edge

of the left drawer side

using the same method.

M d

M c

M d

Runners must be

pushed up against

the drawer front

M c

Prepare the shelf

Insert 4 large locking

nuts into the shelf .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Fix the bracket in the

middle of the shelf ,

flush to the back edge,

using screw .

Step 8

Finished

front edge

Plain chipboard

surface

x 2

Finished

front edge

Assembly Instructions

Step 9

Prepare the upright

a: Fit 2 runners to

the upright .

The 1st screw uses

the 2nd hole in from the

front of the runner.

The 2nd and 3rd screws

. use the holes that line

up with the other panel

holes.

b: Fit a screw into

the 2nd hole in at the top

of the 2 runners .

Screw 4 metal dowels

into the upright .

Insert 2 large locking

nuts into the upright

. .

Turn the divider over

c: Screw 2 metal

dowels into the

upright .

M b

Turn the

upright over

Finished

front edge

Finished

front edge

M b

Prepare the right side

a: Fit runner to the

right side .

The 1st screw uses

the 2nd hole in from the

front of the runner.

The 2nd and 3rd screws

. use the holes that line

up with the other panel

holes.

b: Fit a screw into

the 2nd hole in at the top

of the runner .

c: Screw 4 metal

dowels into the right

side .

Insert 2 large locking

nuts into the right

side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Fit 3 hinge plates onto

the right side , making

sure that the slot is

facing towards the

finished front edge.

P b

M b

Finished front edge

M b

Finished front edge

J1st

screw

2nd

screw

J3rd

screw

Finished

front edge

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 10

Step 11

Join the shelf to the

upright

Push the shelf onto

the upright .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the shelf .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

plain

chipboard

surface

M a

Prepare the left end

a: Fit 2 runners to

the left end .

The 1st screw uses

the 2nd hole in from the

front of the runner.

The 2nd screw uses

the hole that lines up

with the other panel hole.

b: Fit a screw into

the 2nd hole in at the top

of the 2 runners .

Screw 4 metal dowels

into the left end .

Insert 2 large locking

nuts into the left end

. .

M a

b: 1

M a

Finished front edge

M a

Finished front edge

1st

screw

2nd

screw

3rd

screw

Assembly Instructions

Step 12

Prepare the 2 rails

Tap 2 wooden dowels

into each of the rails .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Insert 2 large locking

nuts into each of the

rails .

Plain chipboard

surface

10mm

x 2

Fit the rails

Push the 2 rails onto

the upright .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the rails .

Step 13

Fit the left side

Push the left side

onto the shelf and

rails .

Use a screwdriver to

tighten the 4 large

locking nuts fitted to

the shelf and the

rails .

Step 14

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Home Midsleeper Brooklyn 8527028 Bedienungsanleitung

Argos

Argos 464/4084 Bedienungsanleitung

Argos

Argos Ohio Ottoman Coffee Table Ottoman 143/6563 Bedienungsanleitung

Argos

Argos 6172884 Bedienungsanleitung

Argos

Argos 0845 6400800 Bedienungsanleitung

Argos

Argos ColourMatch Gas Lift Bar Stool 600/6060 Bedienungsanleitung

Argos

Argos 600/037 Bedienungsanleitung

Argos

Argos 389/6400 Bedienungsanleitung

Argos

Argos Walton 145/0233 Bedienungsanleitung

Argos

Argos Malvern 395/6632 Bedienungsanleitung

Argos

Argos Malibu 621/3310 Bedienungsanleitung

Argos

Argos New Sywell 259/1892 Bedienungsanleitung

Argos

Argos HOME Maine 2 Door 1 Drawer Sideboard Bedienungsanleitung

Argos

Argos 832/9408 Bedienungsanleitung

Argos

Argos Cheval 147/3100 Bedienungsanleitung

Argos

Argos Aruba 614/3837 Bedienungsanleitung

Argos

Argos Hallingford 305/2811 Bedienungsanleitung

Argos

Argos SEAGRASS CHEST 424/3801 Bedienungsanleitung

Argos

Argos OXFORD DINING FURNITURE Produktinformationsblatt

Argos

Argos Oakhampton 391/8333 Bedienungsanleitung

Argos

Argos Aspley 459/1261 Bedienungsanleitung

Argos

Argos Devon 532/7623 Bedienungsanleitung

Argos

Argos 603/1822 Bedienungsanleitung

Argos

Argos Marcell 4ft6 Frame Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung