Argos Walton 145/0233 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 80.5cm

Depth - 59.5cm

Height - 74cm

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Important - Please read these instructions fully before starting assembly

ALR2913

145/0233

Walton - 2 Door Cupboard

Issue 1 - 16/10/13

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 31kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: If there is any

chance of this unit being pulled

over by children etc. it is

recommended that the unit is

secured to a wall using suitable

fixings (not supplied).

• Dispose of all packaging

carefully and responsibly.

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Left Side (D2255A)

(718 x 570mm)

Top (D2254A)

(802 x 593mm)

Base (D2257A)

(767 x 567mm)

Door (D2259A)

(678 x 396mm) x 2

Back (X793-708)

(793 x 708mm)

Right Side (D2256A)

(718 x 570mm)

Shelf (D2258A)

(767 x 564mm)

Please check you have all the fittings listed below

Tools required

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 8

Metal dowel (F901) x 8

D E

Large locking

nut (F900) x 8

Rule Scissors Hammer

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Nail (F51) x 20

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Electric drill

(do not use for

fitting screws)

13mm Screw (F63) x 8

I J

Hinge (F518) x 4

Hinge plate

(F523) x 4

Shelf stud (F110) x 4

19mm Screw (F461) x 4

Handle (FWALTON) x 2

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

Prepare the left side

Tap 2 wooden dowels

into the left side .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Screw 2 metal dowels

into the left side .

Note: Tighten metal

dowels up fully against

the panels.

Insert 2 large locking

nuts into the left side

. .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Fit 2 hinge plates onto

the left side , making

sure that the slot is

facing towards the front

edge.

Finished

front edge

10mm

Prepare the right side

Tap 2 wooden dowels

into the right side .

Screw 2 metal dowels

into the right side .

Insert 2 large locking

nuts into the right

side .

Fit 2 hinge plates onto

the right side , making

sure that the slot is

facing towards the front

edge.

Step 2

Finished

front edge

80%

x 2

Finished

front edge

Assembly Instructions

Step 3

Step 4

Prepare the left side

Refer to step 1 and, if

required, fit 2 hinge

plates onto the left

side , making sure

that the slot is facing

towards the front edge.

Tap 2 wooden dowels

into the left side as

shown .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Screw 2 metal dowels

into the left side .

Note: Tighten metal

dowels up fully against

the panels.

Insert 2 large locking

nuts into the left side

. .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Prepare the base

Tap 4 wooden dowels

into the base .

Insert 4 large locking

nuts into the base

Finished

front edge

Join the right side and

base

Push the base onto

the right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the base .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

plain

chipboard

surface

plain

chipboard

surface

Finished

front edge

Assembly Instructions

Step 5

Fit the left side

Push the left side

onto the base .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the base .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Step 6

Prepare the top

Screw 4 metal dowels

into the top .

plain

chipboard

surface

Finished

front edge

Finished

front edge

Assembly Instructions

Step 7

Prepare the left side

Refer to step 1 and, if

required, fit 2 hinge

plates onto the left

side , making sure

that the slot is facing

towards the front edge.

Tap 2 wooden dowels

into the left side as

shown .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Screw 2 metal dowels

into the left side .

Note: Tighten metal

dowels up fully against

the panels.

Insert 2 large locking

nuts into the left side

. .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 8

Fit the top

Push the top onto

the left side and right

side .

Use a screwdriver to

tighten the 4 large

locking nuts fitted to

the left side and right

side .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Fit the back

a: Square up the unit by

making sure that

measurement x to x

equals y to y.

b: Place the back

onto the unit.

Nail around the

outside edges of the

back .

Note: Nails should be

spaced about 150mm

apart.

Stand the unit up for

the next step.

The measurement from top corner X to bottom corner X must be

equal to the measurement from top corner Y to bottom corner Y

Warning: The

unit is heavy.

Lift with care.

Assembly Instructions

Step 9

Step 11

Prepare the 2 doors

Push fit 2 hinges into

each of the doors .

Secure each hinge with

2 screws .

Note: Before securing

with the screws, make

sure that the hinges are

positioned at 90 degrees

with the edge of the

door.

Step 10

Fit the shelf

Lower the shelf down

onto the shelf studs .

Fit the shelf studs

Insert 4 shelf studs at

the required height.

x 2

Fx 4

Finished

front edge

Assembly Instructions

Step 12

Fit doors and handles

Note: The easiest way to

attach each door is

to fit the top hinge first,

then align and fit the

other hinge.

a: Push the hinge

onto the front part of the

hinge plate .

The recess at the bottom

of screw B goes into the

slot in the hinge plate.

b: Keep the hinge

FLAT against the hinge

plate as you slide it

across as far as it will go.

Tighten screw A.

c: The hinge must be

flat against the hinge

plate prior to any

adjustment.

d: The hinge must

NOT be AT AN ANGLE

to the hinge plate

when assembled.

This would indicate that

the recess at the bottom

of screw B had not

located in the slot in the

hinge plate and the hinge

would not be secure.

Remove the hinge from

the hinge plate and then

re-assemble being

careful to follow

instructions a-c.

e: Attach a handle

to each door using 2

screws .

a: b:

c: d:

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Chicago Dining Set Bench Bedienungsanleitung

Argos

Argos 617/9447 Bedienungsanleitung

Argos

Argos Zest 245/7558 Bedienungsanleitung

Argos

Argos hygena Hamlin 143/4235 Bedienungsanleitung

Argos

Argos Gloss Double HOME Wall Cabinet Grey Bedienungsanleitung

Argos

Argos SAVANNA 476/9086 Bedienungsanleitung

Argos

Argos Puerto Rico 658/3129 Bedienungsanleitung

Argos

Argos Wow 481/8401 Bedienungsanleitung

Argos

Argos 497/1630 Bedienungsanleitung

Argos

Argos 617/3113 Bedienungsanleitung

Argos

Argos Capella Bedienungsanleitung

Argos

Argos 3279515 Bedienungsanleitung

Argos

Argos 600/5580 Bedienungsanleitung

Argos

Argos RONDA 8 SEATER CORNER DINING SET 7473441 Bedienungsanleitung

Argos

Argos Nordic 1475902 Bedienungsanleitung

Argos

Argos Malibu 256/0029 Bedienungsanleitung

Argos

Argos TOBY 8559230 Bedienungsanleitung

Argos

Argos 548/7903 Bedienungsanleitung

Argos

Argos 831/8701 Bedienungsanleitung

Argos

Argos BALI TV UNIT OMO Bedienungsanleitung

Argos

Argos 184/9198 Bedienungsanleitung

Argos

Argos Zest 280/6769 Bedienungsanleitung

Argos

Argos Montana 397/6571 Bedienungsanleitung

Argos

Argos Alex Headboard 634/1880 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung