Argos Seville Bedienungsanleitung

Assembly Instructions - Please keep for future reference

Ruler - Use this ruler to help correctly identify the screws

0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

MADE IN

BRITAIN

If you need help or have damaged or missing parts, call the Customer Helpline: 0870 112 1928

or email: [email protected] (quoting your original order number)

Important - Please read these instructions fully before starting assembly

Dimensions

Width - 69.5cm

Depth - 49.5cm

Height - 175.5cm

Seville - 2 Door Robe

Issue 1 - 08/10/13

ALR2906

166/8843

187/8633

144/6508

157/4803

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 40kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

bracket supplied.

• Dispose of all packaging

carefully and responsibly.

Components - Panels

Please check you have all the panels listed below

If you have damaged or missing components, call the

Customer Helpline: 0870 112 1928 or email:

[email protected] (quoting your original order number

and the reference numbers below)

80%

x 2

Top (D2482A)

(663 x 495mm)

Base (D2485A)

(663 x 480mm)

Plinth (D2486A)

(663 x 80mm)

Door (D2487A)

(1652 x 327mm) x 2

Back (X1666-689)

(1666 x 689mm)

Left Side (D2483A)

(1753 x 496mm)

Right Side (D2484A)

(1753 x 496mm)

Hanging Rail (FHR653)

(653mm long)

Glue Safety - Take care when using glue, please follow the advice below

Skin contact: Remove contami-

nation by washing with soap and

water. This procedure should be

followed prior to aeting and

drinking.

Eye contact: Rinse immediately

with clean water for 15 minutes

and seek medical advice.

If swallowed: Seek medical

advice immediately.

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

• From time to time check that

there are no loose screws on

this unit.

Rule

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Tools required

Rule

ScissorsSquare

Spirit

level

Hammer Bradawl

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Step

ladder

Ruler - Use this ruler to help correctly identify the screws

Electric drill

(only use

when drilling

into walls)

Please check you have all the fittings listed below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Components - Fittings

If you have damaged or missing components, call the

Customer Helpline: 0870 112 1928 or email:

[email protected] (quoting your original order number

and the reference numbers below)

Wooden dowel (F22) x 6

B C

D E F

G H I

Nail (F51) x 32 40mm Screw (F910) x 10

J K

Bracket (F327) x 1

13mm Screw (F79) x 1

Hinge plate

(F523) x 6 Hinge (F522) x 6

13mm Screw (F63) x 14

Rail holder

(F1014) x 2 Handle (F300) x 2

25mm Screw (F95) x 2

Step 1

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 0870 112 1928 or email:

[email protected] (quoting your original order number

and the reference numbers below)

Finished

front edge

Step 2

Prepare the left side

Push a rail holder into

the left side . Make

sure that it is fitted

straight, in line with the

panel edges and then

secure with screw .

Fit 3 hinge plates onto

the left side , making

sure that the slot is

facing towards the

finished front edge.

Prepare the right side

Push a rail holder into

the right side . Make

sure that it is fitted

straight, in line with the

panel edges and then

secure with screw .

Fit 3 hinge plates onto

the right side , making

sure that the slot is

facing towards the

finished front edge.

Step 3

10mm

Prepare the top and

base

Tap 2 wooden dowels

into the top .

Tap 2 wooden dowels

into the base .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Finished

front edge

plain chipboard surface

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 4

Step 5

Fit the top and the

base to the right side

Push the top and the

base onto the right

side and secure them

using 4 screws .

Prepare the plinth

Tap 2 wooden dowels

into the plinth .

Step 6

Fit the plinth

Push the plinth onto

the right side and

secure it using screw .

Plain chipboard

5Note: Support the plinth

until the left side has been

fitted in the next step.

plain chipboard surface

Finished

front edge

Assembly Instructions

Step 7

Fit the left side

Push the left side

onto the assembly and

secure it using 5 screws

. . C

Step 8

Fit the back

a: Square up the unit by

making sure that

measurement x to x

equals y to y.

b: Place the back

onto the unit.

Nail around the

outside edges of the

back .

Note: Nails should

be spaced about

150mm apart.

Stand the unit up for

the next step.

The measurement from top corner X to bottom corner X must be

equal to the measurement from top corner Y to bottom corner Y

Assembly Instructions

Step 9

Step 10

Fit the hanging rail

Push hanging rail into

the rail holders fitted

to the side panels.

Prepare the 2 doors

Push fit 3 hinges into

each of the the doors

Secure each hinge with

2 screws .

Note: Before securing

with the screws, make

sure that the hinges are

positioned at 90 degrees

with the edge of the

door.

.x 2

Assembly Instructions

Step 11

Fit doors and handles

Note: The easiest way to

attach each door is

to fit the top hinge first,

then align and fit the

other hinges.

a: Push the hinge

onto the front part of the

hinge plate .

The recess at the bottom

of screw B goes into the

slot in the hinge plate.

b: Keep the hinge

FLAT against the hinge

plate as you slide it

across as far as it will go.

Tighten screw A.

c: The hinge must be

flat against the hinge

plate prior to any

adjustment.

d: The hinge must

NOT be AT AN ANGLE

to the hinge plate

when assembled.

This would indicate that

the recess at the bottom

of screw B had not

located in the slot in the

hinge plate and the hinge

would not be secure.

Remove the hinge from

the hinge plate and then

re-assemble being

careful to follow

instructions a-c.

e: Attach a handle to

each door using

screw .

a: b:

c: d:

Assembly Instructions

Step 12

Adjust the doors if

needed

a: Before adjusting the

doors, use a spirit level

to check the base (or

top) of the unit is level,

front-to-back and

side-to-side in the 3

positions shown.

Use suitable packing

pieces (not supplied) to

make the unit level

BEFORE making any

adjustment to the hinges,

as shown.

b: Height adjustment.

Loosen screws A on

hinge plates and move

door up or down as

required.

Retighten screw A.

c: Forward and Back

adjustment.

Loosen screw B on hinge

plate and move door in

or out as required.

Retighten screw B.

d: Sideways

adjustment.

To move door ‘out’

loosen screw C.

To move door ‘in’ tighten

screw C.

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Misaki 632/4546 Bedienungsanleitung

Argos

Argos Devon 532/7623 Bedienungsanleitung

Argos

Argos Montana 412/3653 Bedienungsanleitung

Argos

Argos Iceland 276107 Bedienungsanleitung

Argos

Argos Sophia 5 Drawer Chest Bedienungsanleitung

Argos

Argos 408/5935 Bedienungsanleitung

Argos

Argos Malibu 621/3310 Bedienungsanleitung

Argos

Argos Eden 414/1594 Bedienungsanleitung

Argos

Argos 619/1834 Bedienungsanleitung

Argos

Argos Bolitzo 780/3066 Bedienungsanleitung

Argos

Argos 837/9221 Bedienungsanleitung

Argos

Argos Aspley 498/9622 Bedienungsanleitung

Argos

Argos Mix Bedienungsanleitung

Argos

Argos Winchester 656/7004 Bedienungsanleitung

Argos

Argos 603/1822 Bedienungsanleitung

Argos

Argos TC Marston White Shake XL Blanket Box... Bedienungsanleitung

Argos

Argos 213/7816 Bedienungsanleitung

Argos

Argos Home 2FT6 Josie 404/9373 Bedienungsanleitung

Argos

Argos Marcell 4ft6 Frame Bedienungsanleitung

Argos

Argos RONDA 7592573 Bedienungsanleitung

Argos

Argos Malibu 259/7937 Bedienungsanleitung

Argos

Argos Malvern 390/9641 Bedienungsanleitung

Argos

Argos Rattan Bedienungsanleitung

Argos

Argos Henley End Table 614/3150 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung