Argos Malvern 390/9641 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 79.5cm

Depth - 49.5cm

Height - 180cm

Malvern - 1 Drawer 2 Door Robe

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400800

Issue 1 - 11/05/15

Important - Please read these instructions fully before starting assembly

ALR3202

390/9641

392/1131

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 52kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

overbalance protector kit

supplied or, an alternative fixing

method of your choice.

• Dispose of all packaging

carefully and responsibly.

Components - Panels

Please check you have all the panels listed below

1 2

80%

x 2

90%

x 1

If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Left Side (DF100)

(1739 x 474mm)

Top (DF103)

(795 x 492mm)

Base (DF102)

(787 x 474mm)

Right Side (DF3948)

(1739 x 474mm)

Shelf (DF107)

(753 x 473mm)

Drawer Front (DF105)

(778 x 243mm)

Drawer Base (T713-367)

(713 x 367mm)

Left Drawer Side

(W370-165LH)

(370 x 165mm)

Right Drawer Side

(W370-165RH)

(370 x 165mm)

Drawer Back (W702-165)

(702 x 165mm)

Back (X1772-779)

(1772 x 779mm)

Cross Rail (DF106)

(753 x 78mm)

13 14 15

Hanging Rail (FHR745)

(747mm long)

Left Door (DF104)

(1503 x 387mm)

Right Door (DF3949)

(1503 x 387mm)

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

A B

D E F

G H I

M N

Metal dowel (F901) x 12

Wooden dowel (F22) x 14

Small locking

nut (F3) x 2 Large locking

nut (F900) x 10

40mm Screw (F910) x 4

SR Runner (F160) x 1

L Runner (F161) x 1

L Runner (F159) x 1

R Runner (F162) x 1

350mm long

13mm Screw (F63) x 22

Knock-in Peg (F171GY) x 4

Wedgefix (F639) x 4

RStrap

Screw Washer x 2

Overbalance protector kit (F269) x 1

P Q

Hinge plate

(F523) x 6 Hinge (F518) x 6

Nail (F51) x 34

38mm Screw (F81) x 8

9mm Screw (F73) x 6

19mm Screw (F461) x 6

Rail Holder

(F891) x 2

Foot

(F233) x 4

Handle (FBARHANDLE) x 3

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Step 1

Step 2

Prepare the drawer

front

Screw 2 metal dowels

into the drawer front .

Note: Tighten the metal

dowels up fully against

the panels.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and the right

drawer side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 3

Attach the drawer

sides to the drawer

front

Push the left drawer side

. and right drawer side

. onto the back of the

drawer front .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

Assembly Instructions

Step 4

Fit the wedgefixes

Turn the drawer

assembly over and slide

4 wedgefixes into the

front and back grooves,

as shown, and tighten up

the screws.

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

Step 5

Step 6

Attach the handle

Attach the handle to

the drawer front

using screws .

Fit the drawer back

between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

8 9

Step 7

Assembly Instructions

Step 8

S d

Fit the runners

Fit a runner ,

marked with ‘R’, to the

bottom edge of the right

drawer side , as

shown, making sure that

it is pushed up against

the back of the drawer

front . Use a bradawl

to mark the fixing

positions, then secure

with 2 screws .

Fit runner , marked

‘L’, to the bottom edge

of the left drawer side

using the same method.

S d

S c

Runners must be

pushed up against

the drawer front

Step 9

Prepare the shelf

Tap 4 wooden dowel

into the shelf .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Insert 4 large locking

nuts into the shelf .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Finished

front edge

10mm

Finished

front edge

Finished

front edge

Assembly Instructions

Step 10

S a

Finished

front edge

S a

I I

1st

screw

2nd

screw I

3rd

screw

Finished

front edge

Prepare the left side

a: Fit a runner to

the left side .

The 1st screw uses

the 1st hole in from the

front of the runner.

The 2nd and 3rd screws

. use the holes that line

up with the other panel

holes.

Fit 3 hinge plates onto

the left side , making

sure that the slot is

facing towards the

finished front edge.

To fit the rail holder ,

screw through the top

hole with screw and

into the mark hole drilled

in the left side . Make

sure that it is fitted

straight, in line with the

panel edges and then fit

another screw using

the lower hole.

b: Fit a screw into

the 2nd hole in at the top

of the runner .

Insert 2 large locking

nuts into the left side

. .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Tap 4 wooden dowels

into the left side .

Screw 3 metal dowels

into the left side .

S a

Assembly Instructions

Step 11

S a

Finished

front edge

Finished

front edge

Prepare the right side

a: Fit a runner to

the right side .

The 1st screw uses

the 1st hole in from the

front of the runner.

The 2nd and 3rd screws

. use the holes that line

up with the other panel

holes.

Fit 3 hinge plates onto

the right side , making

sure that the slot is

facing towards the

finished front edge.

To fit the rail holder ,

screw through the top

hole with screw and

into the mark hole drilled

in the right side .

Make sure that it is fitted

straight, in line with the

panel edges and then fit

another screw using

the lower hole.

b: Fit a screw into

the 2nd hole in at the top

of the runner .

Insert 2 large locking

nuts into the right

side .

Tap 4 wooden dowels

into the right side .

Screw 3 metal dowels

into the right side .

S b

Finished

front edge Finished

front edge

S b

II 1st

screw

2nd

screw

I3rd

screw

S b

Finished

front edge

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 12

Fit the shelf to the

right side

Push the shelf onto

the right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the shelf .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Step 13

Prepare the cross rail

Tap 2 wooden dowels

into the cross rail .

Insert 2 large locking

nuts into the back rail

. .

Step 14

Note: Support the

cross rail until the left

side has been fitted

in the next step.

Fit the cross rail

Push the cross rail

onto the right side .

Use a screwdriver to

tighten the large locking

nut fitted to the cross

rail .

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Asha Bedienungsanleitung

Argos

Argos Le Marais Tall Boy 945/3225 Bedienungsanleitung

Argos

Argos Alicia 188/8379 Bedienungsanleitung

Argos

Argos Ottawa 194803 Bedienungsanleitung

Argos

Argos Scandinavia Bedienungsanleitung

Argos

Argos New Hallingford 3 Door 3 Drawer Wardrobe Bedienungsanleitung

Argos

Argos Retro 226/2877 Bedienungsanleitung

Argos

Argos 617/1799 Bedienungsanleitung

Argos

Argos Amelie 247/9873 Bedienungsanleitung

Argos

Argos Merrick 184/6335 Bedienungsanleitung

Argos

Argos Home 482/2844 Bedienungsanleitung

Argos

Argos Verona Beech Bedienungsanleitung

Argos

Argos Perth 392/9652 Bedienungsanleitung

Argos

Argos White Tongue & Groove 2 Drawer Unit Bedienungsanleitung

Argos

Argos Chrome Tidy Rail 875/8457 Bedienungsanleitung

Argos

Argos Marlow 424/1195 Bedienungsanleitung

Argos

Argos Amy white bunk Trundle Bedienungsanleitung

Argos

Argos 346/4423 Bedienungsanleitung

Argos

Argos New Sywell 282/4150 Bedienungsanleitung

Argos

Argos 2FT6 Josie Shorty Bunk Bed 436/6733 Bedienungsanleitung

Argos

Argos Swanley 120 307/0013 Bedienungsanleitung

Argos

Argos Stroud scroll back pair chair 549/5737 Bedienungsanleitung

Argos

Argos 600/037 Bedienungsanleitung

Argos

Argos Miami 654/4986 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung