Argos Sparkle 427/5484 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Sparkle - 3 Door Mirrored Robe

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400800

Issue 1 - 08/06/15

Important - Please read these instructions fully before starting assembly

ALR3195

427/5484

428/4767

395/5640

Width - 105.1cm

Depth - 51.6cm

Height - 182.3cm

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 68kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 1, 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

overbalance protector kit

supplied or, an alternative fixing

method of your choice.

• Dispose of all packaging

carefully and responsibly.

Rule

Tools required

Rule

ScissorsSquare

Spirit

level

Hammer Bradawl

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Step

ladder

Electric drill

(only use

when drilling

into walls)

Components - Panels

Please check you have all the panels listed below

12 3

80%

x 3

If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Shelf (DF3848)

(33.3 x 45cm) x 3

Left Side (DF3837)

(180.8 x 49.4cm)

Large Rail (DF3840)

(66.9 x 8cm)

Right Side (DF3838)

(180.8 x 49.4cm)

Small Rail (DF4400)

(33.3 x 8cm)

Divider (DF3847)

(171.25 x 49.2cm)

Plain Door (DF3842)

(172.4 x 34.5cm) x 2

Mirror Door (DF3842M)

(172.4 x 34.5cm)

Mirror - SG31

172 x 34.1cm

Safety Back SAR

Large Back (X1739-688)

(173.9 x 68.8cm)

Small Back (X1739-352)

(173.9 x 35.2cm)

7Plinth (DF3845)

(101.7 x 8cm)

Top (DF3844)

(105.1 x 51.6cm)

5Base (DF3846)

(101.7 x 49.3cm)

11 12 13 14

Hanging Rail (FHR663)

(66.3cm long)

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

A B

D E F

IG H

P Q

Large locking

nut (F900) x 16

Metal dowel (F901) x 14 Wooden dowel (F22) x 16

Rail Holder

(F891) x 2

13mm Screw (F63) x 28

Hinge plate

(F523) x 12

Strap Screw Washer x 2

Overbalance protector kit (F269) x 1

Nail (F51) x 40 Plastic Nail (F91) x 4

Hinge (F522) x 12

25mm Screw (F50) x 6

Handle (F569) x 2

40mm Screw (F910) x 2

Large wooden dowel (F40) x 1

Double metal dowel (F566) x 1

Shelf stud (F110) x 12

Back holder (F276) x 5

*These can also be round

Nail screw (F277) x 5

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Step 1

80%

x 3

90%

x 1

Finished

front edge

Finished

front edge

Prepare the left side

a: Screw 4 metal

dowels into the left

side .

Note: Tighten the metal

dowels up fully against

the panels.

Insert 2 large locking

nuts into the

left side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Tap 2 wooden dowels

into the left side .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

b: To fit the rail holder

screw through the top

hole with screw and

into the mark hole drilled

in the left side . Make

sure that it is fitted

straight, in line with the

panel edges and then fit

another screw using

the lower hole.

Fit 4 hinge plates onto

the left side , making

sure that the slot is

facing towards the

finished front edge.

10mm

a: A

Assembly Instructions

Step 2C

Finished

front edge

Finished

front edge

Prepare the right side

a: Screw 4 metal

dowels into the right

side .

Insert 2 large locking

nuts into the right

side .

Tap 2 wooden dowels

into the right side .

b: Fit 4 hinge plates

onto the right side ,

making sure that the slot

is facing towards the

finished front edge.

Prepare the base

Insert 4 large locking

nuts into the base .

Tap 4 wooden dowels

into the base .

Step 3

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 4

Fit the base to the

right side

Push the base onto

the right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the base .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Finished

front edge

Prepare the divider

Insert 2 large locking

nuts into the

divider .

Tap 4 wooden dowels

into the divider .

To fit the rail holder

screw through the top

hole with screw and

into the mark hole drilled

in the divider . Make

sure that it is fitted

straight, in line with the

panel edges and then fit

another screw using

the lower hole.

Fit 4 hinge plates onto

the divider , making

sure that the slot is

facing towards the

finished front edge.

Step 5

Assembly Instructions

Step 6

Step 7

Step 8

Note: Support this rail

until the left side has been

fitted in the next step.

Prepare the small rail

Insert 2 large locking

nuts into the small rail

. .

Tap a wooden dowel

into the small rail .

Finished

front edge

Finished

front edge

Fit the small rail

Push the small rail

onto the right side .

Use a screwdriver to

tighten the large locking

nut fitted to the small

rail .

Note: Support the small

rail until the divider has

been fitted in the next

Fit the divider

a: Push the divider

onto the base and

attach it using 2 screws

. .

b: Tap a double metal

dowel through the

divider and into the

small rail until it

‘’bottoms out’’.

Tap a large wooden

dowel through the

divider and into the

small rail until it

‘’bottoms out’’.

c: Use a screwdriver to

tighten the large locking

nut fitted to the small

rail .

Finished

front edge

Assembly Instructions

Step 9

Prepare the plinth

Insert 2 large locking

nuts into the plinth .

Tap 2 wooden dowels

into the plinth .

Step 10

Fit the plinth

Push the plinth onto

the right side .

Use a screwdriver to

tighten the large locking

nut fitted to the plinth

. .

Step 11

Prepare the large rail

Insert 2 large locking

nuts into the large rail

. .

Tap a wooden dowel

into the large rail .

Assembly Instructions

Step 12

Note: Support this rail

until the left side has been

fitted in the next step.

Fit the large rail

Push the large rail

onto the divider .

Use a screwdriver to

tighten the large locking

nut fitted to the large

rail .

9Note: Support the large rail

until the left side has been

fitted in the next step.

Step 13

Fit the left side

Push the left side

onto the assembly.

Use a screwdriver to

tighten the 4 large

locking nuts fitted to

the base , the plinth

. and the large rail .

795

Prepare the top

Screw 6 metal dowels

into the top .

Finished

front edge

Step 14

Finished

front edge

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Malvern 395/6632 Bedienungsanleitung

Argos

Argos 831/8701 Bedienungsanleitung

Argos

Argos WOW BUTTERFLY 6006558 Bedienungsanleitung

Argos

Argos Hygena Genoa 481/2380D Bedienungsanleitung

Argos

Argos 460/9830 Datenblatt

Argos

Argos 402/8583 Bedienungsanleitung

Argos

Argos 184/9198 Bedienungsanleitung

Argos

Argos 4FT6 BED FRAME Bedienungsanleitung

Argos

Argos Henley 428/0369 Bedienungsanleitung

Argos

Argos Winchester 656/7004 Bedienungsanleitung

Argos

Argos 603/1822 Bedienungsanleitung

Argos

Argos Modular Bedienungsanleitung

Argos

Argos Capella Bedienungsanleitung

Argos

Argos New Penton 245/7864 Bedienungsanleitung

Argos

Argos Home Wow Oslo 482/2844 Bedienungsanleitung

Argos

Argos Single Robe 234046 Bedienungsanleitung

Argos

Argos 600/6486 Bedienungsanleitung

Argos

Argos HOME 607/7446 Bedienungsanleitung

Argos

Argos 496/1932 Bedienungsanleitung

Argos

Argos 603/0263 Bedienungsanleitung

Argos

Argos 2463834 Bedienungsanleitung

Argos

Argos Jenson Bedienungsanleitung

Argos

Argos Portabase Bedienungsanleitung

Argos

Argos High Back Sofa Set 743/7377 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung