2martcart.com •
1-800-548-3373
— IMPORTANT INFORMATION —
Please read before operating.
CONGRATULATIONS!
You have just purchased the best electric shopping cart on the market
today. This Mart Cart incorporates the very latest in technological
advances. To assure you of the best and safest performance as well
as longest life, please read the enclosed information. After reading this
manual, should you have a service problem or need help, please call
our Customer Service Department with the serial number of your cart, at
our toll free number: 1-800-548-3373 or (479) 636-5776.
DAMAGE: Check the shipping carton for any visible damage. Report
the damage to the freight carrier immediately. File a claim with the
carrier if actual damage to your cart has occurred. Check the contents
of the carton. The contents should agree with the information listed on
the packing list. Report any discrepancy to the carrier and the factory
immediately.
TO ORDER PARTS: Call 1-800-548-3373 or (479) 636-5776. Be sure
to give the serial number to the Service Department personnel. The
Mart Cart serial number is located on the seat support tube under the
seat as shown in parts list portion of this manual.
TERMS: All parts will be shipped with approved credit card, check in
advance or C.O.D. Commercial accounts are allowed 15 day terms from
date on invoice with approved credit.
FREIGHT: All freight will be paid by the customer. Special consideration
will be given to items under warranty coverage.
ATTENTION: It is the responsibility of the owner of this cart to maintain
the cart in a safe and reliable operating condition at all times.
NOTE: Specications found in this manual subject to change without
notice.
— IMPORTANT SAFETY INSTRUCTIONS —
Please read before operating.
WARNINGS
• Never attempt to charge the batteries in this cart without using an
electrical outlet that is protected by a GFCI.
• Replace charging cord if plug is damaged or if the cord is worn or
frayed. Never use the charging cord without proper grounding. Do
not use if plug does not have three prongs.
• Never allow the cart to be used out-of-doors or on any surface
that is not level.
• Always disconnect power before servicing.
• See “Daily Maintenance Checklist,” and follow instructions.
• Cart can roll. Enter and exit cart with care.
OPERATING PROCEDURES
• New carts will need charging! Charge batteries for 24 hours prior
to rst use.
• THIS CART IS FOR USE INDOORS ON A FLAT, LEVEL
SURFACE ONLY.
• DO NOT STAND ON CART. (See “Operating & Warning
Instructions” on cart).
• After batteries are charged, disconnect power supply cord
BEFORE operating cart.
• DO NOT exceed the load limitations as shown on the cart.
• Return power cord to circular cavity when not charging
• DO NOT allow children to operate or play on cart. Keep cart
secured with key (if applicable), at service counter.
DAILY MAINTENANCE CHECK LIST
For optimum cart availability and performance, the following items
should be checked daily:
• ELECTRIC CORD—Replace cord if cord is worn or frayed,
3-prong plug is broken or reel (optional) will not retract. Be sure
power outlet provides protection through an operating “Ground
Fault Circuit Interrupter” (GFCI).
• SEAT AND MOUNTING—Tighten if necessary. If cracks or rust
occur, or if seat rocks loosely, replace at once.
• SEAT SWITCH—Test and replace if not working properly. Cart
must stop when weight is removed from seat.
• THROTTLE—Test for smooth “start, acceleration, deceleration,
and stop.” Repair if necessary. Charge or replace batteries if
needed.
• ANTI-TIP CASTERS—Replace if broken. Maintain height
adjustment of 1/8” to 1/2” above oor level.
• GENERAL—Repair or replace any component that may cause a
potential safety concern.
• APPEARANCE—Wipe o and clean as needed for customer
satisfaction and for store’s public image.
— BATTERY CHARGING INSTRUCTIONS —
Please read before charging.
Your cart is equipped with the Intelli-Charge™ system. While operating
the cart, the LED will be solid green until the batteries fall below 24.8
volts and then turns solid amber. When the batteries charge falls below
21.0 volts, the LED will begin ashing red. The person riding the cart
should have ample time to return the cart for charging. When the rider
exits the cart, the horn will start beeping in unison with the red ashing
LED. This will alert those responsible for maintaining the cart to plug
in the charger. When plugged into a 120v AC wall socket, the LED will
ash amber and the horn will silence. When charging is complete the
LED will start ashing green. The charger may be left plugged in even
longer as it will NOT harm the batteries.
LED Color Status Description while operating
LED O O/On rocker switch is set to “O” position
Green (solid) O/On rocker switch is set to “On” position - seat
switch is engaged - batteries are fully charged
Amber (solid) O/On rocker switch is set to “On” position - seat
switch is engaged - batteries are below 24.8 volts
Red - Flashing Batteries need to be charged - below 21.0 volts
LED Color Status Description while charging
Amber - Flashing
Charger is plugged in and batteries are charging
Green - Flashing
Charger is plugged in and batteries are charged
• Install a Ground Fault Circuit Interrupter (GFCI) in the electrical
circuit wherever the cart is to be charged. This is to protect against
any possible shock hazard.
• AC voltage required is 100-240 VAC (50/60 Hz). The current draw is
3.5 amps maximum.
• Charge batteries every night, all night, and at every opportunity.
When the batteries are fully charged, the charger will maintain a
“oat voltage” which will not damage the batteries.
• Do not allow the batteries to fully discharge by skipping the nightly
charging cycle. Fully discharged batteries will take 7 hours to fully
charge, so it is best not to let the batteries become completely
discharged.
• Do not store the cart with discharged batteries. This can cause
premature battery failure. Fully charge the batteries at least every 30
days if in a low usage location.
• No maintenance of batteries is required. The AGM batteries are
maintenance free and water cannot be added.
