AT&T SPIRIT 616 Bedienungsanleitung

AT&T

SPIRIT

Communications System

Model 308/616

616 EXPANSION UNIT

INSTALLATION INSTRUCTIONS

The

SPIRIT

Communications System controller provides service for up to three incoming

lines and eight telephones. This expansion unit doubles the line and telephone set capacity of

the system. Installation and wiring of the complete system is explained in your Customer

Installation Instructions.

What You Should Find in The Expansion Unit Box:

Expansion Unit

Three 7’ line cords

■

STEP 1 Unplug the System Controller

IMPORTANT: FAILURE TO UNPLUG THE CONTROLLER AC POWER CORD FROM THE

ELECTRICAL OUTLET BEFORE INSTALLING THE EXPANSION UNIT MAY CAUSE

HARM TO BOTH UNITS.

■

STEP 2 Expose the Interface Connector

The interface connector for the expansion unit is in the 308 controller, protected by a snap-in

cover (see picture). Insert a small screwdriver in the slot at the bottom of the cover and pry

gently to remove. Store the cover for possible future use.

SLOT

■

STEP 3 Connect the Cable

On one end of the expansion unit is a short flat cable. Hold the expansion unit in your left hand,

near the left side of the controller, with the modular jacks positioned at the bottom. With

your right hand plug the cable into the interface connector (see picture). Make sure the cable is

fully inserted.

■ STEP 4 Connect the Grounding Wire

Adjacent to the cable on the expansion unit is a grounding wire. While still holding the

expansion unit in your left hand, insert the grounding wire into the small eyelet hole just

to the right of the interface connector on the control unit. This wire must be connected to

ensure lightning protection.

GROUNDING WIRE

■

STEP 5

Mount Expansion Unit on Controller

Position the expansion unit next to the 308 controller. Carefully insert the four edge tabs of

the expansion unit into the four edge slots on the 308 controller. Slide the expansion unit down

until it locks in place.

■ STEP 6 Record Installation Date

Write the date on the date installed (DATE INST:) label located on the cord labels that came

with the controller. Place the label on the side of the expansion unit.

■

STEP 7

Reconnect Controller to AC Outlet

Plug the controller power cord back into the AC outlet (must be grounded) and your

controller with expansion unit is ready to use.

■

STEP 8

Testing and System Administration

You may test the installation of the expansion unit by performing the test procedures included

in the SPIRIT Communications System Customer Installation Instructions.

System administration of the additional lines and intercom extensions is identical-to the

procedures described in the System Administration Manual for the

SPIRIT

Communications

System.

Removing the Expansion Unit

If you should ever have to remove the expansion unit, first unplug the controller from the

electrical outlet and unplug all the cords from the modular jacks. Be sure the wiring is labeled.

Using your right hand, insert a dime under the tab on the right side of the expansion unit.

While gently prying the tab outward, push upon the right side of the expansion unit with your

left hand. The unit must move up a little over ¼-inch to free the hook tabs at the top and bottom.

Repeat the procedure on the left side of the expansion unit, using your left hand to pry the

tab outward and your right hand to push up on the expansion unit.

Unplug the cable from the interface connector on the controller. If the expansion unit is not

being replaced, the snap-in cover that was removed from the controller when the expansion

unit was installed should be reinstalled.

SPIRIT is a registered trademark of AT&T

Printed in U.S.A.

999-500-227 105772586

Issue 4, June, 1989

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere AT&T Konferenzsystem Handbücher

AT&T

AT&T Merlin Legend MLX-20L Bedienungsanleitung

AT&T

AT&T Merlin 3070 Bedienungsanleitung

AT&T

AT&T StaR Adapter Handbuch

AT&T

AT&T Merlin 1030 Bedienungsanleitung

AT&T

AT&T MERLIN LEGEND Release 2.0 Analog Multiline... Bedienungsanleitung

AT&T

AT&T MERLIN LEGEND Release 2.0 Analog Multiline... Benutzerhandbuch

AT&T

AT&T SPIRIT Attendant Montageanleitung

AT&T

AT&T Merlin 1030 Bedienungsanleitung

AT&T

AT&T Merlin 1030 Bedienungsanleitung

AT&T

AT&T PARTNER II Release 3.1 Kurzanleitung

AT&T

AT&T Spirit Communications System Bedienungsanleitung

AT&T

AT&T MERLIN LEGEND Analog Direct-Line Console Handbuch

AT&T

AT&T Merlin 3070 Bedienungsanleitung

AT&T

AT&T MERLIN Plus Benutzerhandbuch

AT&T

AT&T Lucent Technologies PARTNER Plus Kurzanleitung

AT&T

AT&T Palm Pre PARTNER Plus Communications System Release... Bedienungsanleitung

AT&T

AT&T Merlin Legend BIS22D Bedienungsanleitung

AT&T

AT&T MERLIN 206 Bedienungsanleitung

AT&T

AT&T Spirit Communications System Installationsanleitung

AT&T

AT&T MERLIN 820 Bedienungsanleitung

AT&T

AT&T Merlin 1030 Technisches Handbuch

AT&T

AT&T MERLIN PIus Attendant Montageanleitung

AT&T

AT&T Merlin Legend 10BS Bedienungsanleitung

AT&T

AT&T MERLIN 410 Stücklistenhandbuch

Beliebte Konferenzsystem Handbücher anderer Marken

Kramer

Kramer VIA GO Bedienungsanleitung

ProSoft Technology

ProSoft Technology AN-X4-AB-DHRIO Bedienungsanleitung

Sony

Sony PCS-I150 Bedienungsanleitung

Middle Atlantic Products

Middle Atlantic Products VTC Series Bedienungsanleitung

AVT

AVT MAGIC AC1 Go Bedienungsanleitung

Prentke Romich Company

Prentke Romich Company Vanguard Plus Leitfaden

Speakerbus

Speakerbus iD 712 Bedienungsanleitung

Trelleborg

Trelleborg SafePilot CAT PRO Bedienungsanleitung

Sennheiser

Sennheiser ADN Bedienungsanleitung

ADTRAN

ADTRAN NetVanta 7100 Bedienungsanleitung

AINA

AINA PTT Voice Responder Bedienungsanleitung

Yamaha

Yamaha ProjectPhone PJP-100H Bedienungsanleitung

vissonic

vissonic VLI Series Bedienungsanleitung

Panasonic

Panasonic KX-VC500 Bedienungsanleitung

Poly

Poly Trio 8300 Bedienungsanleitung

Crestron

Crestron Mercury CCS-UCA-SMK Maßzeichnung

Tenveo

Tenveo ALL-IN-ONE Bedienungsanleitung

AXIWI

AXIWI AT-350 Bedienungsanleitung