Automatic Technology AM-808 Bedienungsanleitung

Transceiver Installation Instructions

Smart Phone Control Kit

TRANSCEIVER KIT NTR-1V1 - ORDER NO. 14825

ITEM DESCRIPTION QTY

1NETWORK TRANSCEIVER NTR-1V1 AY 1

2 TIMING HARNESS 400MM VR12 AY 1

3 TAPTITE SCREW “P” M4 X 12 2

4 VELCRO 20 X 50 1

Garage Door Openers

Important Safety Instructions

WARNING! • DO NOT attempt to disassemble, repair or modify the product. This will invalidate

the warranty.

• Do not allow children to play with the Base Station or your smart phone if the

B&D phone app has been installed.

ELECTROCUTION! • Keep the device away from water and other liquids. In the event that water or

other liquids enter the device, power off he product immediately and clean the

device.

• To reduce the risk of fire or electric shock, do not expose this device to rain or

moisture. The device should not be exposed to dripping or splashing.

• DO NOT remove the cover as there are no user-serviceable parts inside.

CAUTION:

Fall from ladder • Ensure ladder is the correct type for job.

• Ensure ladder is on flat ground.

• Ensure user has 3 points of contact while on ladder.

Doc # 160064_02

Part # N/A

Released 21/07/16

This device allows for unattended operation of the door when not in line-of-sight of the

door opener.

The door may operate unexpectedly, therefore do not allow anything to stay in or near the path of the

door. When the door is not operating automatically, watch the door when it is moving and keep people

away until the door is completely opened or closed. Contact with the moving door can cause serious

personal injury or damage to property.

Your opener must be fitted with SAFETY BEAMS. Safety Beams detect any obstructions in

the door’s path and override automatic operation if one presents. These must be installed as

in accordance with UL 325 and CSA C222.2 No 247.

This is in addition to regular professional servicing, and monthly obstruction tests as detailed in your

opener’s Home Owners Manual.

CLASS B DEVICE CAN ICES-3 (B)/NMB-3 (B)

This equiment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encourage to try to correct the interference by one or

more of the following measures:

•Reorient or relocate the receiving antenna

•Increase the separation between the equipment and receiver

•Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

•Consult the dealer or experienced radio/TV technician for help.

Any changes or modifications not

expressively approved by Automatic

Technology could void the user’s

authority to operate this equipment.

AM-808 Installation Instructions

Preparation of Opener

a. Disconnect the power supply to the opener.

b. Remove the cover or back cover via screw at top.

c. Remove the grommet out of the chassis.

d. Cut (1) one side of the grommet with a knife or scissors.

e. Slide the network timing harness 2into the cut in the grommet.

f. Refit grommet to chassis by sliding the harness through hole before fitting grommet.

g. Connect the harness to the network / programmer pin on the control board.

h. Refit the cover.

Mount and connect Transceiver

a. Plug the other end of the harness into the transceiver 1.

b. Using the velcro 4stick the transceiver 1on the top of the opener as shown.

WARNING: DO NOT drill into the chassis or covers. No screws are

required to secure the transceiver.

Re-setup and Test the Opener

a. Reconnect power and remove the button cover.

b. Setting Limits:

i. If limits have not been set, follow the openers installation sheet to set limits.

ii.If limits were set previously, clear limits and follow openers installation sheet to set

limits.

c. Refer to the Smart Phone Control Kit User Guide to set up network capabilities.

Back cover screw Network /

Programmer Pin

Grommet

ITEM DESCRIPTION QTY

1NETWORK TRANSCEIVER NTR-1V1 AY 1

2 TIMING HARNESS 400MM VR12 AY 1

4 VELCRO 20 X 50 1

AM-808 Door Openers

Aerial slot

Affix with screw here

Preparation of Opener

a. Disconnect the power supply to the opener.

b. Open the side cover on the right hand side (looking from back of unit).

c. Connect the harness 2to the network / programmer pin on the control

board.

d. Place the transceiver 1inside the cover, threading the aerial through the slot

provided and affix with one (1) Taptite Screw 3.

e. Refit the cover.

Re-setup and Test the Opener

a. Reconnect power and remove the button cover.

b. Setting Limits:

i. If limits have not been set, follow the openers installation sheet to set limits.

ii.If limits were set previously, clear limits and follow openers installation sheet

to set limits.

c. Refer to the Smart Phone Control Kit User Guide to set up network capabilities.

AM-888 Installation Instructions

ITEM DESCRIPTION QTY

1NETWORK TRANSCEIVER NTR-1V1 AY 1

2 TIMING HARNESS 400MM VR12 AY 1

3 TAPTITE SCREW “P” M4 X 12 2

AM-888 Door Openers

AM-808 Installation Instructions

To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the antenna(s) used for this transmitter must be

installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with

any other antenna or transmitter.

6 - 8 Fiveways Boulevard, Keysborough, VIC, Australia 3173

P: 1300 133 944 E: sales@automatictechnology.com.au

W: www.automatictechnology.com.au

commitment to product quality we reserve the right to change specification without notice. E&OE.

Inhaltsverzeichnis

Andere Automatic Technology Garagentoröffner Handbücher

Automatic Technology

Automatic Technology Smart Phone Control Bedienungsanleitung

Automatic Technology

Automatic Technology GDO-10v1Toro Bedienungsanleitung

Automatic Technology

Automatic Technology GDO-9 Dynamo Gen 2 Bedienungsanleitung

Automatic Technology

Automatic Technology GDO-7v2 SecuraLift Bedienungsanleitung

Automatic Technology

Automatic Technology SECURALIFT Kurzanleitung

Automatic Technology

Automatic Technology SecuraLift Trio Bedienungsanleitung

Automatic Technology

Automatic Technology GDO-9V1 SecuraLift Bedienungsanleitung

Automatic Technology

Automatic Technology GDO-8 Shed Master Bedienungsanleitung

Automatic Technology

Automatic Technology 62717 Bedienungsanleitung

Automatic Technology

Automatic Technology GDO-11 Ero Bedienungsanleitung

Automatic Technology

Automatic Technology SecuraLift GDO-7V1 Kurzanleitung

Automatic Technology

Automatic Technology GDO-9v2 SecuraLift Bedienungsanleitung

Automatic Technology

Automatic Technology Toro GDO-10V2L2 Bedienungsanleitung

Automatic Technology

Automatic Technology Hiro GDO-12V1 Bedienungsanleitung

Automatic Technology

Automatic Technology GDO-6 EasyRoller Bedienungsanleitung

Automatic Technology

Automatic Technology GDO-6 v2 Bedienungsanleitung

Automatic Technology

Automatic Technology Toro GDO-10v2 Bedienungsanleitung

Automatic Technology

Automatic Technology Axess Pro Series Bedienungsanleitung

Automatic Technology

Automatic Technology GDO-9 ENDURO GEN2 Planungshandbuch

Automatic Technology

Automatic Technology GDO-11v1 Ero Kurzanleitung

Automatic Technology

Automatic Technology GDO-11v1 SecuraLift Bedienungsanleitung

Automatic Technology

Automatic Technology GDO-8 Shed Master Bedienungsanleitung

Automatic Technology

Automatic Technology Axess Pro Series 1101 Bedienungsanleitung

Automatic Technology

Automatic Technology GDO-8v1 EasyRoller II Bedienungsanleitung

Beliebte Garagentoröffner Handbücher anderer Marken

Dorma

Dorma ES 90 Bedienungsanleitung

Garaga

Garaga SECURITY+ 3265GCM 1HP Bedienungsanleitung

Chamberlain

Chamberlain Whisper Drive SECURITY+ WD822K Series Bedienungsanleitung

Chase Doors

Chase Doors DuraShield Bedienungsanleitung

CSI

CSI Classic Bedienungsanleitung

HATO

HATO 120 Bedienungsanleitung

Chamberlain

Chamberlain Elite 3575S Bedienungsanleitung

Richmond

Richmond GTR156 Bedienungsanleitung

Raynor

Raynor 1280RGD Bedienungsanleitung

CAME

CAME F4000 Series Bedienungsanleitung

B&D

B&D Controll-A-Door 5 Bedienungsanleitung

BFT

BFT PRV AA SL Bedienungsanleitung

Craftsman

Craftsman 139.53924 Bedienungsanleitung

Chamberlain

Chamberlain MyQ 940ESTD Bedienungsanleitung

Westfalia

Westfalia 19 36 07 Bedienungsanleitung

Chamberlain

Chamberlain HD520EVP Bedienungsanleitung

Cardin

Cardin BL Series Bedienungsanleitung

Chamberlain

Chamberlain 8355 - 1/2 hp Bedienungsanleitung