Installation Manual Brasilia Slim 2023 9
1.4. Installation Requirements
Verify the space required to install the awning; follow steps 1.4.1 to 1.4.3. This will help
you to determine the type of installation needed.
NOTE : If you have 2 Brasilia Slims side by side or if the awning is close to an inside
corner, you willneed at least 3”of clearance toinstall the plastic end caps on themotors’
side and 2”on the other side.
Wall Installation
Some installations may require a wooden or metal support bracket to solidify and
facilitate the installation of the wall hanging supports.
Required Height
Your awning has an adjustable pitch and will be set to a minimum of 18”when opened,
for a 10’projection awning. You may need to give it more slope if your installation or
surface is not perfectly levelled. Take this into consideration when selecting the height
of the installation.
We recommend a mounting height of 108”, with a minimum height requirement of 96”.
Your wall needs to be free of any obstructions such as doors, windows, vents and light
fixtures in an area of 6.5” in height on top of the total height of the awning’s structure
and all along its width.
If your awning is motorized, you will need an AC outlet to plug it in. A regular GFI or
GFCI outlet will work. The power cable is 24’long.
The motor’s amperage requirement is fewer than 2 amps.
Required Width
The Brasilia Slim hanging supports are situated at both ends of the awning. These
supports bear the entire weight of the awning. Consequently, studs or other structural
parts of the house are mandatory at the end of the awning.
NOTE : Awnings of 16’ or more have an additional central support system to prevent
torsion of the aluminum casing by the weight of the arms.
WARNING: The exterior corners of the walls have a few inches without any structural
elements, regardless of the type of exterior cladding. This fact should be considered if
you have limited space to install the wall plates or if your installation is on a narrow wall
or window near the corner.
Many recent constructions have composite " " joists or open joists instead of solid wood
joists. These types of joists cannot be used to anchor the awning.
