AWS PV-650 Bedienungsanleitung
American Weigh Scales
PV-650 (650g x 0.1g)
User Manual
PV-650
Copyright © 2010 American Weigh Scales, Inc.
All rights reserved. Rev. 2.0
PV-650 Manual
Thank you for purchasing the American Weigh PV-650
digital pocket scale. Please read all operating instructions
carefully before use. Scales are precision measuring devices
and should always be handled with proper care. To ensure
years of reliable service, keep these simple tips in mind:
• Do not exceed the scale’s maximum capacity.
Overloading your scale can permanently damage it!
• Avoid exposure to extreme heat or cold. Scales
perform best at normal room temperature. If
temperatures have changed dramatically, calibration
and adjustment may be necessary.
• Allow your scale to warm up for 30-60 seconds before
performing calibration and adjustment(if available).
• Store your scale in a clean, dry location. Dust, dirt,
and moisture can accumulate on the weighing
sensors and electronics causing inaccuracy or
malfunction.
• Avoid using your scale in close proximity to strong
radio wave emitting devices such as computers, cash
registers, and cordless phones.
• Alwaysweighonaatandlevelsurface,freefrom
vibrations and drafts. The corner of a room is usually
the most stable.
• Gently apply all items to be weighed. Do not drop
items onto the weighing platform.
• Avoid dropping your scale. The warranty does not
cover damage due to rough treatment or overload.
• Checkthebatteriesrstifyouarehavinganytrouble
with your scale. This simple step can remedy most
scale issues.
• Do not disassemble your scale. This product contains
no user serviceable parts.
I. Part List
1. Scale
2. Cover/Expansion Tray
3. AAA Batteries (x2)
II. Key Description
III. Battery Installation
1. Beforeusingthescaleforthersttime,check
the battery compartment and remove any plastic
insulation strips or packaging that may be in place to
prevent battery drainage during shipping/storage.
2. If you are replacing the batteries, make sure the
positive and negative contacts are properly aligned.
Mode Key
ON/OFF/
Tare Key
g
PV-650 Manual
IV. Operation
1. Placethescaleonaat,levelsurfaceandpressthe
/T key to turn the scale on.
2. Once the start-up process completes and the scale
goes to zero you are ready to weigh.
3. Place the quantity to be weighed onto the weighing
platform.
4. Wait a couple seconds for the display to stabilize
before taking a weight reading.
V. Changing the Unit of Measure
1. Press the Mkey to change the scales displayed unit
of measure.
2. If the scale is turned off then back on, it will default
to the last unit used.
• PV-650 Units: g (gram) oz (ounce) ozt (troy
ounce) dwt (pennyweight)
VI. Using the Tare Feature
You can use this scale’s tare feature to subtract the weight
of an empty container or vessel for net weight determination.
NOTE: The weight of the container will subtract from the
available capacity.
1. Place the empty container or vessel on the weighing
platform.
2. Press the /Tkey once. The display will then reset
to zero. If the container is removed, it’s weight will
be displayed as a negative number.
3. Youmaynowllthecontainerwiththequantityto
be weighed. The display will show the net weight of
the contents.
4. To return to normal weight display (gross weight),
remove any items from the weighing platform and
press the /T key again to re-zero the scale.
VII. Calibration
Calibration and adjustment are performed at the factory.
However, the weighing range can shift slightly during
shipping. Also, due to changes in local acceleration of gravity
around the world, adjustment is recommended when moving
the scale from one location to another. To check calibration:
1. Place the required calibration weight on the scale
and note the displayed value.
2. If the displayed value is not within acceptable
tolerance (see chart below), adjustment is required.
Model Acceptable
Tolerance (±)
Calibration
Weight
Recommended
Accuracy Class
PV-650 0.2g 500g OIML M2
VIII. Adjustment
1. Turn the scale OFF.
2. Press and hold the Mand /T keys together until
the display shows “CAL”.
3. Press the /Tkeyagain.Thedisplaywillash
“Zero” followed by the calibration weight value (see
chart).
4. Place the calibration weight on the center of the
weighing platform and press /T once more.
5. The display will show “CAL” then “PASS” and return
to normal operation.
PV-650 Manual
IX. Troubleshooting
• Problem: Scale will not turn on
• Solution: Check the batteries
• Problem: Displayedweightuctuatesrandomly
• Solution: Make sure your workspace is stable and
free of any air currents or vibration
• Problem: Displayed weight is inaccurate
• Solution: Perform a calibration adjustment
X. Error Codes
1. OUEZ - Zero range has shifted. Perform calibration
adjustment. If the problem persists, the load cell may
be permanently damaged due to overloading.
2. O_Ld - Maximum capacity exceeded. Remove the
extra weight to avoid damaging the load cell.
3. UNST - Unstable. Use in a more stable position.
PV-650
Max. Capacity 650g
Readability 0.1g
Power 2 x AAA
Dimensions 0.8 x 2.6 x 5.3 in.
Platform Dimensions 2.2 x 2.9 in.
Warranty 10 Year Limited Warranty
PV-650
Capacity 650g / 22.92oz / 20.89ozt / 417.95dwt
Readability 0.1g / 0.01oz / 0.01ozt / 0.1dwt
Inhaltsverzeichnis
Andere AWS Skala Handbücher
AWS
AWS HX-502 Bedienungsanleitung
AWS
AWS Chrome Bedienungsanleitung
AWS
AWS H-11 Bedienungsanleitung
AWS
AWS EDGE Bedienungsanleitung
AWS
AWS ONYX-5K Bedienungsanleitung
AWS
AWS mini PRO-50 Bedienungsanleitung
AWS
AWS V2-600 Bedienungsanleitung
AWS
AWS AMW-500i Bedienungsanleitung
AWS
AWS PB-13 Bedienungsanleitung
AWS
AWS HX Series Bedienungsanleitung
AWS
AWS 330LPG Bedienungsanleitung
AWS
AWS CITRON-5K Bedienungsanleitung
AWS
AWS 330LPW Bedienungsanleitung
AWS
AWS QUANTUM Montageanleitung
AWS
AWS LS-110 Bedienungsanleitung
AWS
AWS AMW-50 Bedienungsanleitung
AWS
AWS AMW-500i Bedienungsanleitung
AWS
AWS MERCURY PRO MPR-180 Bedienungsanleitung
AWS
AWS ACPro-200 Bedienungsanleitung
AWS
AWS BS-100 Bedienungsanleitung
