Bang & Olufsen BeoLab 7-6 Bedienungsanleitung

BeoLab 7-6

Guide

WARNING: To reduce the risk of fire or

electric shock, do not expose this appliance

to rain or moisture. Do not expose this equip-

ment to dripping or splashing and ensure

that no objects filled with liquids, such as

vases, are placed on the equipment.

To completely disconnect this equipment

from the AC Mains, disconnect the mains

plug from the wall socket. The disconnect

device shall remain readily operable.

The lightning flash with arrowhead symbol

within an equilateral triangle, is intended

to alert the user to the presence of un-

insulated “dangerous voltage” within the

product’s enclosure that may be of sufficient

magnitude to constitute a risk of electric

shock to persons.

The exclamation point within an equilateral

triangle is intended to alert the user to the

presence of important operating and main-

tenance (servicing) instructions in the

literature accompanying the product.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: To reduce the risk of

electric shock, do not remove

cover (or back).

No User-serviceable parts inside.

Refer servicing to qualified service

personnel.

Daily use

When you have nished setting

up the loud speaker as described

on the following pages, connect

the entire system to the mains.

Loudspeaker protection

The loudspeaker is equipped with a

thermal protection system which

prevents damage from overheating.

If an error occurs – or the speaker

units become overheated – the

system automatically switches the

loudspeaker to standby.

To restore the sound:

> Disconnect the loudspeaker from

the mains supply.

> Allow the system time to reset or

cool down (approximately 3–5

minutes).

> Reconnect the loudspeaker to

the mains supply.

Should the problem persist, contact

your Bang & Olufsen retailer.

To clean the loudspeaker

Clean dusty surfaces using a dry,

soft cloth. If necessary, remove

grease stains or persistent dirt with

a lint-free, rmly wrung cloth,

dipped in a solution of water

containing only a few drops of mild

detergent, such as washing-up

liquid.

The loudspeaker front grill may be

cleaned with a vacuum cleaner with

a soft brush nozzle, and set to the

lowest level.

Never use alcohol or other solvents

to clean any parts of the loud-

speaker!

To switch on and off

When you switch on your Bang &

Olufsen system, the loudspeaker

switches on simultaneously, and

when you switch the system off

again the loudspeaker also switches

to standby.

Caution: Handle the loudspeaker

front grill with great care. Dents

and scratches are not covered by

the guarantee!

Set up the loudspeaker

We recommend that you follow

this procedure:

– Disconnect your Bang & Olufsen

system from the mains supply.

– Fasten the loudspeaker as

explained on the next page.

– Connect the loudspeaker and set

the position switch as explained

in ‘Cable connections’ (pp. 6–7).

– Connect the entire system to the

mains again.

Cautions!

– Make sure that the loudspeaker

is placed and connected in

accordance with the instructions

in this Guide. To prevent injury,

use Bang & Olufsen approved

stands and wall brackets only!

– The loudspeaker can only be

switched off completely by

disconnecting it from the wall

socket.

– Do not attempt to open the loud-

speaker. Leave such operations

to qualied service personnel!

– The loudspeaker is designed for

indoor use in dry, domestic

environments only, and for use

within a temperature range of

10–40º C (50–105º F).

– Always place the loudspeaker in

a horizontal position, and do not

place any items on it.

– In order not to block the sound

emitting from the rear bass

reex ports and the bass units

on the bottom, leave a minimum

of 6 cm (2½”) free space behind

and below the loudspeaker.

– Prolonged listening at high

volume levels may cause hearing

damage!

Handling the loudspeaker: In

order not to dent or scratch the

loudspeaker front grill, we

recommend that you lift the loud-

speaker by holding on to the two

bass units on the bottom. Do not

support the loudspeaker holding

the loudspeaker front grill!

To fasten the loudspeaker

Here is explained how to fasten the

loudspeaker to a Bang & Olufsen

stand.

aRemove the two small covers (if

any) on the stand. Press each

cover as shown, and they will

come loose.

bFasten the bracket to the stand.

Use the four longest screws

(M5 × 25 mm).

cFasten the loudspeaker to the

bracket. Use the two short screws

(M5 × 8 mm). However, do not

fully tighten the screws before

you have made the adjustments

mentioned below (d).

Adjustments: First, make sure that

the television is adjusted to a level

position on its stand! Then use the

two screws (d) to adjust the loud-

speaker so that it is parallel to the

lower edge of the television. Align

the loudspeaker front with the tele-

vision and tighten the two screws

(c).

d d

Cable connections

In this Guide is explained how

to set up the loudspeaker in a

setup with BeoVision 7. If used in

a setup not including BeoVision 7,

you will require a mains cord

and a Power Link cable. These

cables are avail able as optional

accessories from your Bang &

Olufsen retailer.

The socket panel is located on the

rear of the loudspeaker. For

information about the sockets on

your Bang & Olufsen system, refer

to the Guides enclosed with the

system.

Before you make any connections,

disconnect your Bang & Olufsen

system from the mains supply!

POWER LINK socket: Use this

socket to connect the loudspeaker

to one of the Power Link sockets

on the Bang & Olufsen system.

Note: Do not use a Power Link cable

of the older type, as this will cause

noise, and therefore not give

optimum sound quality! The new

type has a triangular mark on the

plug.

Cable clamp: For safety reasons,

the mains cord from the wall outlet

must be secured to the loudspeaker.

To do so, tug the cord behind the

clamp.

Mains cord: The supplied mains

cord and plug are specially designed

for the product. If you change the

plug or damage the mains cord, you

must buy another from your Bang &

Olufsen retailer!

Power Link

Mk 3

Position switch

Cable clamp

POWER LINK

socket

The position switch

When a loudspeaker is placed in a

corner or close to a wall, the bass

level is boosted compared to the

bass level from a loudspeaker

placed in a more free-standing

position.

To remove this excessive bass boost,

use the position switch to ensure

that the bass level suits the place-

ment of the loudspeaker. The

appropriate switch setting depends

on the distance from the loud-

speaker to the walls and corners of

the room.

The switch has two settings:

F – Free-standing position

Use this setting if the loudspeaker

is placed so that the front grill is

more than 50 cm (20”) from the

rear wall.

W – Wall position

Use this setting if the loudspeaker

is placed so that the front grill is less

than 50 cm (20”) from the rear

wall.

If the loudspeaker is tted to a low

stand – and you have chosen to

place it on the oor – you should

set the position switch to W. The position switch is located on

the loudspeaker socket panel.

F W

To get access to the approval

labels, remove the loudspeaker

front grill

Push the front grill towards the left

(~ 10 mm). The front grill can now

be removed.

Note: When attaching the front

grill again, make sure that all five

‘attach-points’ engage with the

corresponding brackets on the

loudspeaker. Do not attempt to

mount the front grill upside down

(marked on the rear by ).

Caution: Handle the loudspeaker

front grill with great care. Dents

and scratches are not covered by

the guarantee!

For your information …

This product is in conformity

with the provisions of the

Directives 2004/108/EC and

2006/95/EC.

Technical specications, features

and the use thereof are subject to

change without notice!

Waste Electrical and Electronic

Equipment (WEEE) –

Environmental protection

Electrical and electronic equipment,

parts and batteries marked with

this symbol must not be disposed

of with normal household wastage;

all electrical and electronic

equipment, parts and batteries

must be collected and disposed of

separately.

When disposing of electrical and

electronic equipment and batteries

by use of the collection systems

available in your country, you

protect the environment, human

health and contribute to the

prudent and rational use of natural

resources. Collecting electrical and

electronic equipment, batteries

and waste prevents the potential

contamination of nature with the

hazardous substances which may

be present in electrical and

electronic products and equipment.

Your Bang & Olufsen retailer will

advise you of the correct way of

disposal in your country.

If a product is too small to be

marked with the symbol, it will

appear in the User Guide, on the

Guarantee certicate, or on the

packaging.

All Bang & Olufsen products comply with applicable environmental

legislation throughout the world

For the US-market only!

NOTE: This equipment has been

tested and found to comply with

the limits for a class B digital device,

pursuant to part 15 of the FCC Rules.

These limits are designed to provide

reasonable protection against

harmful interference in a residential

installation.

This equipment generates, uses and

can radiate radio frequency energy

and, if not installed and used in

accordance with the instructions,

may cause harmful interference to

radio communications. However,

there is no guarantee that inter-

ference will not occur in a particular

installation. If this equipment does

cause harmful interference to radio

or television reception, which can be

determined by turning the equip-

ment off and on, the user is

encouraged to try to correct the

interference by one or more of the

following measures:

– Reorient or relocate the receiving

antenna.

– Increase the separation between

the equipment and receiver.

– Connect the equipment into an

outlet on a circuit different from

that to which the receiver is

connected.

– Consult the retailer or an

experienced radio/TV technician

for help.

For the Canadian market only!

This class B digital apparatus meets

all requirements of the Canadian

Interference-Causing Equipment

Regulations.

Inhaltsverzeichnis

Andere Bang & Olufsen Sprecher Handbücher

Bang & Olufsen

Bang & Olufsen BeoSound 35 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoLab 20 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen Beolit 15 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoLab 4 PC Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoPlay S8 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoLab 1 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BEOLAB 28 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoLab 2000 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen Beosound A1 2nd Generation Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BOHBLR Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoPlay A1 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoPlay S3 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen Beolab 4000 MKII 6642 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoLab 4 PC Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoLab 10 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen Beovox CX50 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen Beosound A1 2nd Gen Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoLab 18 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen Beosound Level Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoLab 20 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoLab 19 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BeoLab 7-4 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen Beolit 17 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen Balance Beosound Bedienungsanleitung

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung