Baxi Churchill II 347 Bedienungsanleitung

5110947/01

This guide to be left with the owner

OWNER GUIDE

THIS APPLIANCE IS FOR USE WITH NATURAL GAS (G20)

THIS APPLIANCE IS SUITABLE ONLY FOR INSTALLATION IN THE UNITED

KINGDOM (GB) AND THE REPUBLIC OF IRELAND (IE) ONLY.

Manufactured exclusively for British Gas & Scottish Gas by Valor Heating

For Service Phone 0845 950 0400

CHURCHILL II

Radiant / Convector Gas Fire

Model 347

(G. C. Number 32-032-62)

Safety First.

This gas fire is CE Approved and designed to meet the appropriate British Standards and

Safety Marks.

Quality and Excellence.

This fire has been manufactured to the highest standards of quality and excellence and

was manufactured under a BS EN ISO 9001 quality system accepted by the British

Standards Institute.

The Highest Standards

The manufacturer is a member of the Society of British Gas Industries which works to

ensure high standards of safety, quality and performance.

Careful Installation

The manufacturer is a CORGI registered company. This gas fire must be

installed by a competent CORGI Registered Installer in accordance

with our Installer Guide and should not be fitted directly on to a

carpet.

Valor Heating, Erdington, Birmingham B24 9QP

www.valor.co.uk

Because our policy is one of constant development and improvement, details may vary slightly from those

given in this publication

Page 2

OWNER GUIDE

LIST OF CONTENTS

Section

Page

SAFETY 3

APPLIANCE DIMENSIONS 5

GAS CONSUMPTION 5

OPERATING YOUR FIRE 6

CLEANING YOUR FIRE 8

REPLACING THE RADIANTS 8

MAINTENANCE 9

This gas fire is designed to meet the most stringent quality, performance and safety

requirements to provide you with many years’ trouble-free service.

This guide aims to improve your understanding and appreciation of your gas fire by

providing simple and informative instructions to ensure that you benefit from the

excellent performance and features it has to offer.

SAFETY

Do have the fire installed by a competent person. In the United Kingdom, installation

must be in accordance with the latest edition of the Gas Safety (installation & use)

Regulations. In the Republic of Ireland, installation must be in accordance with all

national and local regulations in force.

have the chimney swept prior to installation if it was previously used for solid fuel.

Do have the fire installed in accordance with the installation instructions

Do allow a minimum clearance of 95mm from the top of the appliance fascia to the

underside of any shelf whether it is made from combustible or non-combustible

materials. This clearance is necessary to allow the fascia to be lifted off for servicing

and also allows sufficient access to operate the control knob. For a shelf made from

wood or other combustible materials deeper than 150mm add 12.5mm to the clearance

for every 25mm of additional shelf depth (See graph 1). Please bear this in mind if ever

you add a shelf.

Page 3

OWNER GUIDE

IF YOU SMELL GAS

DON’T SMOKE

EXTINGUISH ALL NAKED FLAMES

DON’T TURN ELECTRICAL SWITCHES ON OR OFF

TURN OFF THE GAS SUPPLY AT THE METER

OPEN DOORS AND WINDOWS TO GET RID OF THE GAS

IMMEDIATELY CALL THE GAS EMERGENCY SERVICE – SEE YOUR LOCAL TELEPHONE

DIRECTORY

Do provide a suitable guard that complies with BS 8423 for the protection of young

children, the elderly and the infirm. Such a guard is also recommended for the protectio

of pet animals. (

Although this fire conforms to all the applicable standards, it is a heating

appliance and certain parts of its surface will become hot).

Note: The guard supplied with the fire acts as a fireguard conforming to BS1945:1971

and satisfies the Heating Appliance (Fireguard) (Safety) Regulations 1991.

Do wait three minutes before attempting to relight if the fire is switched off or the

flames are extinguished for any reason. (Your fire is fitted with a safety device that will

automatically shut off the gas supply to the fire if, for any reason, the flames go out).

Do get advice about the suitability of any wall covering near your fire. Soft wall

coverings (e.g. embossed vinyl, etc.) which have a raised pattern are easily affected by

heat. They may, therefore, scorch or become discoloured when close to a heating

appliance. Please bear this in mind whenever you are considering redecorating.

Do provide a minimum clearance of 48

mm between the fascia sides and any corner wall

having combustible material or other combustible surface which projects beyond the

front of the fire (See figure 1). Please bear this in mind if ever you are considering

altering the room.

Don’t hang clothing, towels or any other fabrics over the fire.

Don’t fill in the space behind the fascia.

Don’t use the fire without the dress guard being in position.

Don’t

attempt to clean or service the fire until it has been switched off and allowed to

cool completely.

Don’t use the fire with damaged radiants.

Page 4

OWNER GUIDE

Graph 1. Shelf clearances

APPLIANCE DIMENSIONS

GAS CONSUMPTION

Has a maximum natural gas input of 5.6kW (Gross)

Has a maximum natural gas output of 4.0kW

Has a minimum natural gas input of 1.57kW (Gross)

Has a minimum natural gas output of 1.0kW

Page 5

OWNER GUIDE

Figure 1 Dimensions and clearances

OPERATING YOUR FIRE

The Oxysafe flame sensing and flue blockage safety system.

For your safety, this appliance is fitted with a flue blockage safety device that will shut

down the appliance in the event of abnormal flue conditions. This device is NOT a

substitute for an independently mounted Carbon Monoxide detector.

The device will also automatically shut off the gas supply to the fire if the pilot flame

goes out due to lack of oxygen or for any other reason.

If this device starts to repeatedly shut off the gas, get expert advice.

This device incorporates a probe that senses that the heat from the pilot flame is correct.

If this probe is cool, the device will prevent any gas flow unless the control knob is held

down at the ignition position.

If, for any reason, the flames go out when the fire is hot or if the fire is turned off when

hot, always wait at least three minutes before attempting to relight.

To light the fire.

The control is shown in figure 2.

Depress the control knob and turn anticlockwise

towards the 1 position. A spark should be generated

at the pilot while turning. The spark should ignite the

pilot. If it does not, keeping the knob depressed,

continue to turn the knob anticlockwise. A second

spark should ignite the pilot. The pilot flame can be

seen through the opening immediately below the right

hand centre radiant (See figure 3). If the pilot does not

light, turn the knob back to ‘OFF’ and try again.

In the unlikely event of failure of the ignition

mechanism the pilot can be lit with a long match or

taper – See the next page.

When the pilot has lit keep the knob depressed for about ten seconds to allow the flame

sensing probe to warm up.

Page 6

OWNER GUIDE

Figure 2.

PLEASE NOTE

When operating your fire for the first time, some vapours may be given off which may

cause a slight odour and could possibly set off any smoke alarms in the immediate

vicinity. These vapours are quite normal with new appliances. They are totally harmless

and will disappear after a few hours use.

The control knob can then be set to your preferred heat level. The settings are:

To turn off partially depress the knob and turn clockwise to off. Wait at least three

minutes before attempting to relight.

Lighting with a match or taper

Depress the control knob and turn

anticlockwise towards the 1 position.

While keeping the knob depressed, light the

pilot by inserting a long match or taper into

the opening to the right side of the brass

handle (See figure 3).

When the pilot is alight, keep the knob

depressed for about ten seconds to allow the

flame sensing probe to warm up before setting

to your preferred heat level.

For your own convenience, have the heater

serviced as soon as possible.

Page 7

OWNER GUIDE

Figure 3.

Control Knob

Position Radiants Condition

Centre radiants on low. Outer radiants off.

(The right hand centre radiant will glow slightly

more than than the left hand centre radiant due

to the pilot flame)

3Centre radiants fully on. Outer radiants off.

4Centre radiants fully on. Outer radiants on low.

5 All radiants fully on.

Page 8

CLEANING YOUR FIRE

Turn the fire off and allow it to cool before attempting any cleaning.

Normally the fire will only need dusting. The bright metal trims may be cleaned with a

damp cloth and dried with a soft duster. Obstinate marks can be removed from the guard

and trims using soapy water. Never use abrasive cleaners.

The radiants can be cleaned with a soft brush - see below for how to remove the

radiants.

REPLACING THE RADIANTS

(See figure 4).

Always use the correct type of replacement radiant. Ask for part number 5110472.

Turn the fire off and allow it to cool before attempting to remove the radiants.

Remove the dress guard by pressing down the two hooks at the top. Tilt the guard

forward and lift out.

! Lift the radiant upward to clear the metal retaining bar then pull out bottom first.

! Fit the new radiant by inserting its top under the top lip of the radiant box then

swing the bottom of the radiant over and behind the retaining bar.

It is important that

that the rear face of the radiants rest against the horizontal ribs in the rear panel.

There will be a small gap between their bottom front edges and the retaining

OWNER GUIDE

Figure 4. Replacing radiant(s)

channel at the front of the radiant box.

Replace the dress guard. Locate the bottom of the dress guard in the two holes in the

bottom panel apron. Push the guard back so that the two spring projections at the top of

the guard engage in the slots under the front decorative canopy.

MAINTENANCE

Regular maintenance.

In order to achieve and maintain high levels of personal safety and performance

efficiency, it is essential that the opening at the back of the fire and the flue are kept

clear of any form of obstruction. It is possible that deposits of mortar or soot could fall

and accumulate causing the flue to be blocked or restricted and so preventing proper

clearance of dangerous exhaust fumes.

In the United Kingdom it is the law that a landlord must have any gas appliance, flue

and pipework which is situated in a tenant’s premises checked for safety at least every

twelve months by a competent person (In the U.K., a CORGI registered installer).

We recommend that all gas appliances and their flues, wherever situated, are checked

annually.

Servicing.

If you require your fire to be serviced, please contact British Gas or Scottish Gas

TELEPHONE 0845 950 0400 and please quote the following details:

Model name and number.

Appliance serial number (To be found on a label near the bottom left side of the

fascia).

! If you wish to replace any radiants, spare parts are available nationwide via the

‘interpart stockist network

’. For your local stockist consult Yellow pages under

Central Heating.

Page 9

OWNER GUIDE

Inhaltsverzeichnis

Andere Baxi Kamin im Innenbereich Handbücher

Baxi

Baxi BR660VA Bedienungsanleitung

Baxi

Baxi Cavendish Deluxe PCF Betriebsanleitung

Baxi

Baxi Bermuda GF3 Betriebsanleitung

Baxi

Baxi 740FS Bedienungsanleitung

Baxi

Baxi 941 Bedienungsanleitung

Baxi

Baxi 939 Bedienungsanleitung

Baxi

Baxi 946 Montageanleitung

Baxi

Baxi 751 Bedienungsanleitung

Baxi

Baxi Bermuda Inset 3 Super Bedienungsanleitung

Baxi

Baxi Gallery Series Montageanleitung

Baxi

Baxi Bermuda Inset 3 Series Handbuch

Baxi

Baxi 750FS Bedienungsanleitung

Baxi

Baxi 746 Montageanleitung

Baxi

Baxi 739 Bedienungsanleitung

Baxi

Baxi Wonderfire AF16NV Bedienungsanleitung

Baxi

Baxi EBONY SUPER Benutzerhandbuch

Baxi

Baxi Classic 2 719 Bedienungsanleitung

Baxi

Baxi 748 Montageanleitung

Baxi

Baxi 940 Gebrauchsanweisung

Baxi

Baxi 748 Bedienungsanleitung

Baxi

Baxi 946 Bedienungsanleitung

Baxi

Baxi 750M Bedienungsanleitung

Baxi

Baxi 949 Montageanleitung

Baxi

Baxi BERMUDA BBU HE Bedienungsanleitung

Beliebte Kamin im Innenbereich Handbücher anderer Marken

Brigantia

Brigantia 35-DVRS31N-2 Betriebsanleitung

Nordpeis

Nordpeis Bergen Bedienungsanleitung

Superior

Superior BCT2536TMN Bedienungsanleitung

Quadra-Fire

Quadra-Fire 5100I-GD-B Bedienungsanleitung

Renaissance

Renaissance RUMFORD 1000 Bedienungsanleitung

Lacunza

Lacunza IV-800 Bedienungsanleitung

Dru

Dru Maestro 60/2 Tall RCH Bedienungsanleitung

Diamond Fireglass

Diamond Fireglass SS-O22 Bedienungsanleitung

HearthStone

HearthStone Windsor Bay 8830 Programmierhandbuch

Napoleon

Napoleon ASCENT B42 Bedienungsanleitung

Enviro

Enviro E33GI Bedienungsanleitung

Smeg

Smeg L30 FABE Montageanleitung

KEDDY

KEDDY K700 Bedienungsanleitung

Godin

Godin 3451 Bedienungsanleitung

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Bedienungsanleitung

Desa

Desa CCFPDFT Bedienungsanleitung

Miles Industries

Miles Industries Vogue 1300IRN Handbuch

Regency Fireplace Products

Regency Fireplace Products Pro Series Kurzanleitung

Baxi churchill II 347 Bedienungsanleitung

Beliebte Kamin im Innenbereich Handbücher anderer Marken