Bayer HealthCare Medrad Spectris Solaris EP Montageanleitung

QuickTips

2 Medrad® Spectris Solaris® EP QuickTips

The following information is intended to be a quick summary of operating instructions for your Medrad®

Spectris Solaris® EP Injection System and does not constitute a substitute for the full and complete

instructions within the Medrad® Spectris Solaris® EP Operations Manual, Medrad Document Number 202974

or Mobile Manual: 205580. Refer to the Operations Manual for compete instructions and user warnings.

Powering Up and Down

Power UP:

1. To turn on, lift the clear plastic cover on the back of the Display

Control Unit and press the green button

2. Safety screen appears, review information and press continue to

proceed to main protocol screen

3. To ensure communication between injector head and display

control unit, verify communication icon located on main screen

Power DOWN:

1. To turn unit off, lift the clear plastic cover and press green button

again

Loading Syringes

1. Position injector head in upright position

2. Ensure pistons are fully retracted

a. To retract pistons, press the Enable button,

Press the Reverse Load

switches

on the injector head. The pistons will stop when fully retracted

3. Remove new syringe from package and insert it into the injector ensuring that keyed wings at

syringe base are aligned

a. The syringe is keyed to properly fit the injector only in one way

b. Twist the syringe 1/4 turn clockwise until syringe locks into place

4. Advance the plungers completely forward by pressing the Enable button,

then pressing both

Forward Load Switches.

The pistons will stop when fully advanced

5. Remove protective covers from syringes and filling devices

6. Prepare the bottle and/or bag of contrast media and/or flushing solution

Push the bottle or bag onto the filling device until the seal is punctured

Aspirate the contents by pressing the enable button

then press the Reverse Load switch

a. Use Side A for contrast media syringe

b. Use Side B for saline syringe

MANUAL

PISTON

CONTROL

KNOBS

FORWARD

REVERSE

ENABLE

FORWARD

REVERSE

AIR CONFIRMATION

3 Medrad® Spectris Solaris® EP QuickTips

Loading Syringes (continued)

7. Remove the filling device

8. Securely attach the “T” portion of the connector tubing to syringes

a. The shorter part of the “T” connection with back check valve

attaches to the “A” syringe (contrast)

b. The longer part of the “T” connects to the “B” syringe (flush)

9. Expel air from fluid path. Prime “T” connector and tubing by advancing

plungers with the forward or reverse switches or the manual piston

control knobs. Advance contrast up to the bottom of the check valve,

then prime the rest of the tubing with saline

10. Ensure that all air has been expelled from the syringes and fluid path

11. Depress the “Air Confirmation” button to confirm air has been expelled

MANUAL

PISTON

CONTROL

KNOBS

FORWARD

REVERSE

ENABLE

FORWARD

REVERSE

AIR CONFIRMATION

4 Medrad® Spectris Solaris® EP QuickTips

Programming

Add or Change a Phase:

1. Press the delta key to the left of the flow rate

2. Select the appropriate phase type

3. Enter in the appropiate values

Flow Rate:

1. Touch the corresponding box

2. Enter the desired flow rate using the keypad

3. Touch enter to confirm

Volume:

1. Touch the corresponding box

2. Enter the desired volume

3. Touch enter to confirm

5 Medrad® Spectris Solaris® EP QuickTips

Programming (continued)

Pressure Limit:

1. Touch Set on Pressure Limit field

2. From drop down list, select the appropriate psi from 100-325

6 Medrad® Spectris Solaris® EP QuickTips

KVO and Arming Injector

Independent KVO (Keep Vein Open)

1. Ensure that no air is in the syringe or fluid path

2. Press the Air Confirmation button on injector head or acknowledge

on the DCU that air has been removed

3. Touch the Start button to begin KVO

KVO delivers a pulse of saline to ensure line patency

To ARM if Independent KVO Has Been Used

1. If KVO has been started, touch the ARM button on display screen

2. Press hand switch to begin the injection

To ARM Injector Without Using KVO

1. Ensure that no air is in the syringe or fluid path

2. Press the Air Confirmation button on injector head or

confirm on the DCU that air has been removed

3. Touch ARM on Display Screen

4. Press the hand switch to begin the injection

7 Medrad® Spectris Solaris® EP QuickTips

NOTE: KVO can be started at any time after

arming the injector. To start KVO, touch

Start button before the injection is started.

Storing and Recalling Protocols:

Storing of Protocol:

1. Display desired protocol on screen by setting Flow Rates, Volumes, and

delay rates, if applicable

2. Touch Store button

3. Type in desired protocol name using the keyboard

4. Touch enter. Protocol has now been stored

Store Recall

8 Medrad® Spectris Solaris® EP QuickTips

Storing and Recalling Protocols: (continued)

Recalling Protocols:

1. Press recall

Select protocol by pressing the name of desired protocol

Protocol will be displayed in center screen

2. Press OK to recall

Protocol will be displayed on main screen

3. The pressure limit is changed to the stored protocol pressure limit value

Injection History:

1. From the Main protocol screen select HISTORY button

2. The screen will display the 20 most recent injections

3. The Pressure Limit will now appear in the injection history and will

display the Programmed, Peak and Limited psi

9 Medrad® Spectris Solaris® EP QuickTips

Inhaltsverzeichnis

Andere Bayer HealthCare Medizinische Geräte Handbücher

Bayer HealthCare

Bayer HealthCare Temprid 75 Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD Stellant Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare Breelib Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare Breelib Handbuch

Bayer HealthCare

Bayer HealthCare Rapidlab 800 Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare CHIPCO 26019 N Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD MRXperion Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD Avanta Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare Certegra P3T PA Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD Stellant Technisches Datenblatt

Bayer HealthCare

Bayer HealthCare Breelib Handbuch

Bayer HealthCare

Bayer HealthCare MEDRAD 800 Module Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD Salient ZY6320 Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD Stellant Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MICROLET 2 Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD Twist & Go Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD MRXperion Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD MRXperion XP 65/115VS Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD Sailent Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD CT 300 Series Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD MRXperion Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare CERTEGRA MEDRAD Stellant FLEX Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare Certegra Bedienungsanleitung

Bayer HealthCare

Bayer HealthCare MEDRAD Stellant SDS-TRF-CV Bedienungsanleitung

Beliebte Medizinische Geräte Handbücher anderer Marken

TekTone

TekTone Tek-CARE160 Bedienungsanleitung

NeuroMetrix

NeuroMetrix Quell 2.0 Bedienungsanleitung

AMT

AMT XLR8 Bedienungsanleitung

EDAN

EDAN SONOTRAX Pro Bedienungsanleitung

Restorative Therapies

Restorative Therapies RT300 Bedienungsanleitung

Gendex

Gendex Expert DC Bedienungsanleitung

Dexcowin

Dexcowin ADX4000W Bedienungsanleitung

Libelium

Libelium MySignals Bedienungsanleitung

Acelity

Acelity V.A.C.ULTA 4 Bedienungsanleitung

Caputron

Caputron ActivaDose II tDCS Bedienungsanleitung

Plinth 2000

Plinth 2000 93CDT Bedienungsanleitung

GE SENOGRAPHE 800T Bedienungsanleitung

GE Definium 5000 Bedienungsanleitung

Kanmed

Kanmed GE-1380 Bedienungsanleitung

Huntleigh

Huntleigh FD1 Bedienungsanleitung

Stryker

Stryker SPR Plus Bedienungsanleitung

Tobii Dynavox

Tobii Dynavox I-Series Bedienungsanleitung

S-Capepod

S-Capepod Evac Cocoon Bedienungsanleitung