BEGA 84 218 Handbuch

Beliebte Außenleuchte Handbücher anderer Marken

Sealey

Sealey LED37 Bedienungsanleitung

nordlux

nordlux VEJERS Benutzerhandbuch

SImx

SImx ELITE LED LHTC637 Bedienungsanleitung

GEV

GEV CAROLINE 10833 Bedienungsanleitung

WE-EF

WE-EF PFL540 LED Bedienungsanleitung

Lindby

Lindby 9949029 Bedienungsanleitung

HEPER

HEPER DOGO Side LW6048.585-US Montage- und Bedienungsanleitung

Maretti

Maretti VIBE S 14.6080.04.A Bedienungsanleitung

HEPER

HEPER LW8034.003-US Montage- und Bedienungsanleitung

HEPER

HEPER MINIMO Montage- und Bedienungsanleitung

LIGMAN

LIGMAN BAMBOO 3 Bedienungsanleitung

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Bedienungsanleitung

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Bedienungsanleitung

urban ambiance

urban ambiance UQL1273 Bedienungsanleitung

TotalPond

TotalPond 52238 Bedienungsanleitung

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Bedienungsanleitung

LIGMAN

LIGMAN DE-20023 Bedienungsanleitung

Spectroline

Spectroline MAXIMA ML-3500 Series Bedienungsanleitung

Installation and Technical Information

BEGA

Due to the dynamic nature of lighting products and the associated technologies, luminaire data on this sheet is subject to change at the discretion of BEGA North America. For the most current technical data, please refer to bega-us.com

BEGA 1000 Bega Way, Carpinteria, CA 93013 (805)684-0533 © copyright BEGA 2021

Figure 1: Product Diagram

Figure 2:Fixture Installation

Overview:

LED Watts: 4.2W

System Watts: 6.0W

Input Voltage: 12-24V AC

Weight: 7.5 lbs.

Protection Class: IP65

Tools Required:

• 3mm Hex Key

• Digging tool

18 16 14 12 10

40 46 73 116 185 294

30 61 97 155 246 392

20 92 146 232 369 588

15 122 195 309 492 784

10 183 292 464 738 1176

5 366 585 928 1477 2353

WireSize(AWG)

Max.RunLength(ft)PerWireSize:2Voltdrop

Connected

LEDWatts

Garden and pathway bollard – Direct burial anchorage 84 218

Dimensions

A: 4 3/8’’

B: 27 1/2’’

C: 4 3/8’’

Maintenance:

Clean regularly with solvent-free cleaner

removing dirt and debris. Do not use high

pressure cleaners.

Replacement Parts

See label inside of xture for LED replacement

part number.

Consult factory for all other replacement

components.

Accessories

Please refer to the appropriate accessory installation

sheet for further instruction when applicable.

Updated: 03/22/21

84 218 1 of 2

A C

B

D

Notice to Installer:

1. For use with 12-24V AC magnetic landscape transformers only.

2. Voltage must NOT drop below 10V at xture location.

3. Turn main power OFF before start of installation.

4. Luminaires most be installed 10 feet or more from pool, spa or fountain.

5. Wiring connection points must be made in a watertight location.

6. Anchorage tube length 11 3/4’’.

Installation: Luminaire

1. Establish an area for xture placement and prepare the soil for anchorage by digging

a hole (12” maximum depth).

2. Dig a trench from the anchorage hole to the power source. The depth of the trench

will be determined by national, state, and local codes.

3. Install at least 3” of pea gravel or similar in the bottom of the anchorage hole for

drainage.

4. Loosen (2) set screws on the garden bollard to release the anchorage post.

[Figure 1]

5. Bring 12-24V supply wiring into the bottom of the anchorage post and feed through

to the top until 12” of the cable comes up through the top of the anchorage post.

6. Bury supply wiring cable in trench.

7. Place anchorage post into the hole and ll in the hole with packed soil, ensuring that

the post is vertical and secure.

8. Make wire splices from supply wiring coming out of anchorage post to bollard wiring

coming down from bollard shaft. For maximum wire run lengths, see the table below.

9. Push splices into bollard shaft.

10. Mount the bollard onto the anchorage post until the bottom of the bollard hits the

ground. Tighten (2) set screws to secure bollard to anchorage shaft. [Figure 2]

11. Connect supply wiring to main power. Turn on the main power.

Set Screws

Anchorage

Supply Wiring

Installation and Technical Information

BEGA

Due to the dynamic nature of lighting products and the associated technologies, luminaire data on this sheet is subject to change at the discretion of BEGA North America. For the most current technical data, please refer to bega-us.com

BEGA 1000 Bega Way, Carpinteria, CA 93013 (805)684-0533 © copyright BEGA 2021

Product Safety Warnings:

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON

FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

SUITABLE FOR WET LOCATIONS.

MIN 90°C SUPPLY CONDUCTORS.

CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT, PAR UNE PERSONNE QUI CONNAÎT

BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE LES RISQUES INHÉRENTS.

CONVIENT AUX EMPLACEMENTS MOUILLÉS.

LES FILS D’ALIMENTATION 90°C MIN.

Updated: 03/22/21

2 of 2

84 218

Garden and pathway bollard – Direct burial anchorage 84 218