Conforms to the 802.3af standard.
Use with IP telephones, wireless access points, IP print servers, IP cameras, and Bluetooth®
access points.
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500) •
FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746 •
Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018 •
Customer
Support
Information
LPJ000A-F
802.3af 10/100 PoE Injector, 1-Port
1. Specifications
Compliance: cUL/UL®, RoHS
Load (Maximum): 0.35 A
Regulation: Line and load: 46 to 49 VDC
under all conditions
Connectors: Data in: (1) RJ-45 (10/100);
Data/PoE out: (1) RJ-45 (10/100);
Power: (1) IEC 320 (3-pin)
Indicators: (3) LEDs: (1) ON, (1) CONNECT, (1) FAULT
Power: AC input voltage range: 90–264 VAC;
AC input voltage rating: 100–240 VAC, 47–63 Hz;
Output: 15.4 W at 48 VDC
Size: 1.4"H x 2.6"W x 5.5"D (1 x 6.6 x 14 cm)
Weight: 0.4 lb. (0.2 kg)
2. Overview
The LPJ000A-F is an entry-level power injector that conforms to the IEEE 802.3af power standard. As defined in 2003, this standard
provides up to 15.4 W of DC power (minimum 44 VDC and 350 mA) to each device. Only 12.95 W of power is ensured to be
available at the powered device because some power is dissipated in the cable.
Use the LPJ000A-F with IP telephones, wireless access points, IP print servers, IP cameras, and Bluetooth access points.
3. Setting Up Your Power Injector
NOTE: Use CAT5e or higher Ethernet cables (not included).
1. Using screws, affix the metal feet on the front and/or rear to a flat surface such as a table or wall. See Figure 1.
NOTE: The power injector should not use the weight of the Ethernet cables for support.
