Bosch FlexiDome VDA-CMT-Dome Bedienungsanleitung

FlexiDome Corner Mount

VDA-CMT-Dome

en Installation manual

FlexiDome Corner Mount Safety | en 3

Bosch Security Systems Installation manual | v2.0 | 2011.08

1Safety

1.1 Safety precautions

1.2 Important safety instructions

Read, follow, and retain for future reference all of the following safety instructions. Heed all

warnings on the unit and in the operating instructions before operating the unit.

1. Safety check - Safety checks should be performed upon completion of service or repairs

to the unit to ensure proper operating condition.

2. Installation - Install in accordance with the manufacturer's instructions and in

accordance with applicable local codes.

3. Attachments, changes or modifications - Only use attachments/accessories specified by

the manufacturer. Any change or modification of the equipment, not expressly approved

by Bosch, could void the warranty or, in the case of an authorization agreement, authority

to operate the equipment.

1.3 Important notices

Environmental statement - Bosch has a strong commitment towards the environment. This

unit has been designed to respect the environment as much as possible.

More information

For more information please contact the nearest Bosch Security Systems location or visit

www.boschsecurity.com

WARNING!

Medium risk: Indicates a potentially hazardous situation.

If not avoided, this could result in minor or moderate bodily injury.

CAUTION!

Low risk: Indicates a potentially hazardous situation.

If not avoided, this could result in property damage or risk of damage to the unit.

Disposal - Your Bosch product was developed and manufactured with high-quality material

and components that can be recycled and reused. This symbol means that electronic and

electrical appliances, which have reached the end of their working life, must be collected and

disposed of separately from household waste material. Separate collecting systems are

usually in place for disused electronic and electrical products. Please dispose of these units

at an environmentally compatible recycling facility, per European Directive 2002/96/EC.

WARNING!

For a secure installation use stainless steel or zinc plated fasteners.

CAUTION!

If these mounts are used outdoors ensure that the equipment they are used with is also

suitable for outdoor use.

FlexiDome Corner Mount Unpacking | en 4

Bosch Security Systems Installation manual | v2.0 | 2011.08

2 Unpacking

Unpack carefully and handle the equipment with care. The packaging contains:

–Mount

– Hardware kit

If equipment has been damaged during shipment, repack it in the original packaging and

notify the shipping agent or supplier.The shipping carton is the safest container to transport

the unit. Save it for possible future use.

FlexiDome Corner Mount Installation | en 5

Bosch Security Systems Installation manual | v2.0 | 2011.08

3 Installation

This installation should be made by qualified service personnel and conform to the National

Electrical Code and applicable local codes.

3.1 Installing the Corner Mount

Figure 3.1 Corner Mount Disassembly

1. Disassemble housing by releasing security screw [3] on bottom of unit using provided

security wrench, then pull front cover [1] off rear cover [2].

2. Determine location for corner mount.

3. Using rear cover [2] of mount as template, mark location of mount holes on walls.

4. Drill holes for anchors and install anchors into wall.

5. Decide which conduit hole to use and plug remaining openings using two (2) plugs

(provided with hardware kit). Secure conduit plug on top of unit by tightening set screw

on back of rear cover [2]. This step must be performed before rear cover [2] is secured

to wall. Use a 2.5 mm Hex Key (not supplied).

6. If a side feed-through is chosen, mark hole using rear cover as template. Drill hole into

wall. Use this hole to pull wires into bracket.

7. Assemble rear cover [2] of mount to wall.

8. Pull all wires from wall through feed-through hole.

9. Assemble camera to front cover [1] and fix with three (3) M5 screws (supplied).

10. Install the camera dome housing cover.

11. Connect all wires to camera.

12. Pull any excess wires back into mount.

13. Slide front cover [1] onto rear cover [2] and secure with security screw [3].

1 Front cover

2Rearcover

3 Security screw

FlexiDome Corner Mount Installation | en 6

Bosch Security Systems Installation manual | v2.0 | 2011.08

3.2 Corner mount assembly

The figure below illustrates the corner mount assembly:

Figure 3.2 Corner mount assembly

Note:

The rear cover provides three ¾-inch conduit openings. Install the ¾-inch conduit fittings as

needed for the installation.

FlexiDome Corner Mount Dimensional outlines | en 7

Bosch Security Systems Installation manual | v2.0 | 2011.08

4 Dimensional outlines

The following illustration depicts the dimensional outlines for the corner mount.

Figure 4.1 VDA-CMT dimensions

Bosch Security Systems

www.boschsecurity.com

Inhaltsverzeichnis

Andere Bosch Rack & Stand Handbücher

Bosch

Bosch MBE Series Bedienungsanleitung

Bosch

Bosch GCR 350 Bedienungsanleitung

Bosch

Bosch MSGZWML Bedienungsanleitung

Bosch

Bosch T1B Kurzanleitung

Bosch

Bosch GTA500 Montageanleitung

Bosch

Bosch S 500 A PROFESSIONAL Bedienungsanleitung

Bosch

Bosch BDS3210 Bedienungsanleitung

Bosch

Bosch NDA-FMT200-DOME Bedienungsanleitung

Bosch

Bosch PTA 2400 Bedienungsanleitung

Bosch

Bosch GTA 600 Professional Bedienungsanleitung

Bosch

Bosch HMP 0001 A Bedienungsanleitung

Bosch

Bosch T4B Montageanleitung

Bosch

Bosch GTA 2500 W Professional Bedienungsanleitung

Bosch

Bosch FBH 0000 A Bedienungsanleitung

Bosch

Bosch FRK 0019 A Bedienungsanleitung

Bosch

Bosch RA1165 Montageanleitung

Bosch

Bosch FLEXIDOME NDA-FMT-MICDOME Bedienungsanleitung

Bosch

Bosch B12 Bedienungsanleitung

Bosch

Bosch TS1014 Bedienungsanleitung

Bosch

Bosch GTA 2500 W Professional Bedienungsanleitung

Bosch

Bosch GTA 3800 Professional Montageanleitung

Bosch

Bosch GTA 2600 Professional Bedienungsanleitung

Bosch

Bosch PTA 2400 Bedienungsanleitung

Bosch

Bosch T10031 Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung