Bosch SE3401 Bedienungsanleitung

SE3401

Installation Instructions

Wireless (RF)

Point Tracking Transmitter

Bosch Security Systems | 6/03 | 40281E

EN | 2

SE3401 | Installation Instructions | 1.0 General Information

1.0 General Information

The SE3401 Point Transmitter is a magnetic and dry

contact wireless transmitter used for monitoring assets.

The unit is equipped with an internal reed contact for

use with an external magnet assembly (included), a

cover tamper switch, and RF supervision. The SE3401

can accept a supervised dry contact input from an

external device.

1.1 Supervision

Supervision is provided by transmitting a low power

level signal to the receiver every 70 min. if there is no

other activity. All transmissions from the SE3401 send

battery status information to the system.

1.2 Auto Tracking

Once an alarm is initiated, such as the transmitter

moved away from the magnet, the auto tracking feature

begins. The transmitter sends a signal back to the

central console every few seconds, updating its location

for several minutes. To reset the transmitter after an

alarm has been initiated, all device conditions (such as

tamper, loop, or magnet) must be reset to normal.

2.0 Specifications

3.0 Mounting the Point Transmitter

Avoid mounting the point transmitter on

metal surfaces as it can reduce the range of

the unit. Placing the point transmitter on

ferrous metal (iron or steel) surfaces can

affect operation of the magnetic contact.

3.1 Recommended Mounting

1. Position the mounting plate over the desired

location and attach it with the supplied screws.

2. Depending on the product you are using, select the

picture that best describes it to open the cover.

Figure 1: Attach Mounting Plate

1 - Release tab

2 - Mounting holes

M A G N E T

Table 1: Specifications

Description SE3401 Wireless Point Tracking

Transmitter

Dimensions

(H x W x D)

Transmitter without Mounting Plate:

35 mm x 76.5 mm x 19 mm

(1.4 in. x 3.25 in. x 0.75 in.)

Mounting Plate:

35 mm x 76.5 mm x 3.2 mm

(1.4 in. x 3.25 in. x 0.125 in.)

Operating

Temperature -20°C to +65°C (-4°F to +150°F)

Operating

Voltage Supplied by a 3 VDC lithium battery.

Battery Life Up to five years under normal usage

with the recommended battery types.

Higher usage decreases battery life.

Recommended

Battery Types

Duracell DL 123A,

Energizer EL 123AP, or

Panasonic CR 123A

Compatible

Receivers EA102A-304

Options Magnet-RF-10 Assembly (supplied in

packages of ten) 1 - Insert screwdriver and press here

2 - Push in

Figure 2: Open Cover

EN | 3

SE3401 | Installation Instructions |

Bosch Security Systems | 6/03 | 40281E

3.0 Mounting the Point Transmitter

3. Be sure to note the location of the magnet when

mounting the base.

4. Slide the point transmitter over the base to lock it

into place as shown is Figure 3.

5. The point transmitter can be released from the base

by pressing the release tab with a small screwdriver

or a paper clip.

6. For higher security installations, mount the

transmitter using the tamper screw provided (see

Figure 4).

Figure 3: Slide Point Transmitter Over Base

3.2 Mounting Without the Mounting Plate

1. If the battery was installed in the point transmitter,

remove it at this time.

2. Using a small screwdriver, gently lift the printed

circuit board away from the case mounting clips.

You do not need to remove the cover to remove the

board.

3. Rock the board gently to loosen the battery clips

from the case and slide the board away from the

mounting clips near the area where the cover

connects to the base.

4. Mount the point transmitter in the desired location,

taking note the magnet needs to be on the same side

of the case as the reed switch.

Figure 6: Mount Point Transmitter in Desired

Location

1 - Magnet side

2 - Mounting holes

Figure 5: Lift Printed Circuit Board

Figure 4: Mount Transmitter Using Tamper Screw

1 - Tamper screw

Bosch Security Systems | 6/03 | 40281E

EN | 4

SE3401 | Installation Instructions |

3.3 Mounting the Magnet

Mount the magnet as shown in Figure 7. The magnet

must mount within 19 mm (0.75 in.) of the base of the

unit.

4.0 Installing the Battery

Install the recommended type of battery: Duracell

DL123A, Energizer EL123AP, or Panasonic CR123A.

Be sure to observe the polarity.

Figure 7: Mount the Magnet

1 - End view from the opening end

Figure 8: Install Battery

1 - Battery

EN | 5

SE3401 | Installation Instructions |

Bosch Security Systems | 6/03 | 40281E

5.0 Setting Up Magnetic or

External Contacts

The SE3401 has the capacity to monitor magnetic

and/or dry external contacts. External Normally Closed

(NC) or external Normally Open (NO) contacts can be

monitored.

5.0 Setting Up Magnetic or External Contacts

Figure 9: Magnet

1 - Battery

2 - EOL

Note:

If not using external contacts, you must install the EOL.

Figure 10: Magnet (Optional) Typical NC Wiring

1 - Battery

2 - EOL 2.21 k

Ω

Figure 11: Magnet (Optional) Typical NO Wiring

1 - Battery

2 - EOL 2.21 k

Ω

1 2

Bosch Security Systems | 6/03 | 40281E

EN | 6

SE3401 | Installation Instructions |

6.0 System Programming

A two part ID sticker is located on the enclosure. You

need the number on this sticker to program this device

into the system.

See your Security Escort Reference Guide for programming

information for wireless type devices.

6.0 System Programming

FCC Compliance Notice

This device complies with Part 15 of the FCC rules and

with RSS-210 of Industry and Science Canada.

Operation is subject to the following two conditions:

• This device cannot cause harmful interference.

• This device must accept any interference

received, including interference that can cause

undesirable operation.

Changes or modifications not expressly approved by

Bosch Security Systems can void the user’s authority to

operate the equipment.

Figure 1: ID Sticker

1 - ID number

167770187

EN | 7

SE3401 | Installation Instructions |

Bosch Security Systems | 6/03 | 40281E

Notes:

Bosch Security Systems

130 Perinton Parkway

Fairport, NY 14450-9199 USA

www.boschsecurity.us

Customer Service: (800) 289-0096

Technical Support: (888) 886-6189

Subject to change | Printed in the USA

40281E

Inhaltsverzeichnis

Andere Bosch Sender Handbücher

Bosch

Bosch INTEGRUS Bedienungsanleitung

Bosch

Bosch CRS-MIYS37-FI Bedienungsanleitung

Bosch

Bosch ATX-TRM-304T01 Bedienungsanleitung

Bosch

Bosch S35 Bedienungsanleitung

Bosch

Bosch CRS-SB-423FI Bedienungsanleitung

Bosch

Bosch MIYN46 Bedienungsanleitung

Bosch

Bosch ATX-TRM-304T01 Bedienungsanleitung

Bosch

Bosch SEC-RFPB60M-433 Bedienungsanleitung

Bosch

Bosch CRS-NC-S37E-ACC Bedienungsanleitung

Bosch

Bosch SEC-3402 Series Bedienungsanleitung

Bosch

Bosch RF3401E Bedienungsanleitung

Bosch

Bosch RFKF-FB Bedienungsanleitung

Bosch

Bosch SE88A-90S-304 Bedienungsanleitung

Bosch

Bosch SEC-3402-304 Bedienungsanleitung

Bosch

Bosch CRS-SB-424FI Bedienungsanleitung

Bosch

Bosch ISW-EN1215EOL Bedienungsanleitung

Bosch

Bosch SE-TRM-433T01 Bedienungsanleitung

Bosch

Bosch ISN-GMX-S1 Bedienungsanleitung

Bosch

Bosch ISW-EN1261HT Bedienungsanleitung

Bosch

Bosch ISW-EN1233 Bedienungsanleitung

Bosch

Bosch ISW-EN1235DF Bedienungsanleitung

Bosch

Bosch Security Systems SE2 Series Handbuch

Bosch

Bosch EN1210 Series Bedienungsanleitung

Bosch

Bosch RF3503E Bedienungsanleitung

Beliebte Sender Handbücher anderer Marken

NIVELCO

NIVELCO EasyTREK SCA-300 Series Betriebsanleitung

Honeywell

Honeywell 5816WMBR Bedienungsanleitung

Kamstrup

Kamstrup READy MTU Betriebsanleitung

Omega

Omega ZW Series Bedienungsanleitung

ABB

ABB Field 264H Leitfaden

Alinco

Alinco DJ-V17T Bedienungsanleitung

Dejero

Dejero EnGo 3x Bedienungsanleitung

Rosemount

Rosemount 4600 Bedienungsanleitung

Speaka Professional

Speaka Professional 2342740 Bedienungsanleitung

trubomat

trubomat GAB 1000 Bedienungsanleitung

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Bedienungsanleitung

Rondish

Rondish UT-11 Bedienungsanleitung

MG 10JRE Bedienungsanleitung

Burkert

Burkert 8177 Bedienungsanleitung

Firetide

Firetide HotPort 3203 Handbuch

Tele Radio

Tele Radio T9-02 Bedienungsanleitung

Rotronic

Rotronic HygroFlex HF3 Series Bedienungsanleitung

Jamara

Jamara FCX6 Pro Tel Bedienungsanleitung