Bosch 715ES Bedienungsanleitung

Models: 715ES, C800ES, C920ES, C920ESC, 2400ES, 2700ES

Cleaning and replacing ignition group

Service Bulletin G3-23

Introduction

The ignition group consists of two ignition electrodes and one

ame sensing rod. These components may need to be cleaned

or the entire group replaced if the heater has frequent EC or EA

error codes or fails to produce a spark.

Tools needed:

Phillips head screwdriver

 8mm wrench or small adjustable wrench

Fine steel wool for cleaning

Preparation

1. Unplug water heater and turn off gas to heater using installer

supplied manual shut off valve.

2. Loosen two Phillips head screws located at bottom rear of cover.

(Fig. 1, step 1, pos. 1).

3. Lift front cover upward and remove. (Fig. 1, step 1, pos. 2 & 3)

4. Remove combustion cover by unclipping two upper and two

lower clips securing cover. (Fig. 1, step 2)

Step 1 Step 2

tep

Figure 1

Removing the ignition group

1. Locate ignition group. (Fig. 2, pos. 1).

2. Disconnect two large yellow ignition wires from ignition group.

(Fig. 2, pos. 2)

3. Disconnect small black ame sensor wire from ignition group.

(Fig. 2, pos. 3).

Figure 2

Data subject to change without notice | Printed in the USA | BTC710002310 A | 01.2009 Bosch Thermotechnology Corp.

Service bulletin

18 | G3-23 | 715ES, C800ES, C920ES, C920ESC, 2400ES, 2700ES

Bosch Thermotechnology Corp.

50 Wentworth Avenue

Londonderry, NH 03053

Tel: 1-866-642-3198

Fax: 1-603-584-1681

www.boschhotwater.com

4. Remove two 8mm nuts from ignition group. (Fig. 3, pos. 1).

5. Remove ignition group and gasket from the water heater. Leave

the observation window in place.

Figure 3

Cleaning ignition group

1. If the ignition group gasket is discolored or torn, replace with a

new gasket. (Fig. 4)

2. Using steel wool, gently polish all metal surfaces of the ame

sensor and the ignition electrodes. (Fig. 4)

Figure 4

Gasket

Flame

sensor

Ignition

electrodes

Replacing ignition group

1. Gently place ignition group gasket over left bolt stud for 8mm

nut. The stud will hold the gasket in place.

(Fig. 3, pos. 1)

2. Carefully feed tips of ignition group into heat exchanger ensuring

that the ame sensor rod is on the far left.

3. Ensure a proper seal between the heat exchanger and ignition

group.

4. Replace and tighten two 8mm retaining nuts. (Fig. 3, pos. 1).

5. Reconnect two large ignition wires to the right and center igniter

terminals. (Fig. 2, pos. 2).

6. Reconnect small black ame sensor wire to the left terminal.

(Fig. 2, pos. 3).

7. Ensure that all three wire connections t securely on the

terminals.

8. Replace combustion cover and front cover. (Fig. 1).

9. Plug in water heater‘s power cord and press On/Off button to

"ON". Reset any error that is displayed.

10. Open manual gas shutoff valve.

11. Return water heater to service.

!WARNING

FAILURE TO PROPERLY SEAL THE

IGNITION GROUP WITH GASKET MAY

CREATE A HAZARDOUS CONDITION

CAUSING SEVERE PERSONAL INJURY

OR DEATH.

Andere Handbücher für 715ES

Dieses Handbuch passt für folgende Modelle

Andere Bosch Boiler Handbücher

Bosch

Bosch WR430-7K Montageanleitung

Bosch

Bosch GWH 10-2 G Series Technisches Dokument

Bosch

Bosch C 1210 ESC Referenzhandbuch

Bosch

Bosch AQUA STAR 250SX LP Bedienungsanleitung

Bosch

Bosch 660 EF Bedienungsanleitung

Bosch

Bosch 830ES Bedienungsanleitung

Bosch

Bosch Gas Water Heaters Bedienungsanleitung

Bosch

Bosch AquaStar 125B NGS Bedienungsanleitung

Bosch

Bosch Integra 500 Series Referenzhandbuch

Bosch

Bosch Stora WS 300-5 PK Betriebsanleitung

Bosch

Bosch Model GWH 425 Bedienungsanleitung

Bosch

Bosch Tronic 2500 TO Bedienungsanleitung

Bosch

Bosch Greentherm T9800 SEO199 Bedienungsanleitung

Bosch

Bosch WR400 K T2 Series Betriebsanleitung

Bosch

Bosch Tronic 1000 T Bedienungsanleitung

Bosch

Bosch 940ES Bedienungsanleitung

Bosch

Bosch RDH06101 Bedienungsanleitung

Bosch

Bosch TR2000 Series Bedienungsanleitung

Bosch

Bosch W 135 K B Series Benutzerhandbuch

Bosch

Bosch TRONIC 3000 US3-2R Technisches Dokument

Bosch

Bosch BC2680RA5 Bedienungsanleitung

Bosch

Bosch Optiflow GWH16 3 CT E23 F6 L S2405 Bedienungsanleitung

Bosch

Bosch Pro Tankless GWH-635-ES-N Bedienungsanleitung

Bosch

Bosch 250SX Bedienungsanleitung

Beliebte Boiler Handbücher anderer Marken

Kenmore

Kenmore 153.582400 Bedienungsanleitung

Applimo

Applimo Edel AIR Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON Eltronom SHU 5 S Bedienungsanleitung

clage

clage E-Mini Series Bedienungsanleitung

Toyotomi

Toyotomi Oil Miser OM-180 Bedienungsanleitung

Bradford White

Bradford White EF Series Bedienungsanleitung

Eccotemp

Eccotemp 40-H Bedienungsanleitung

Dimplex

Dimplex ECSd125-580 Leitfaden

Dux

Dux 32FCR6N Bedienungsanleitung

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Fehlerbehebungshandbuch

Noritz

Noritz N-132M Gebrauchsanweisung

TESY

TESY GCV7/4S 10047 Technisches Datenblatt

A.O. Smith

A.O. Smith Gphe 50 Bedienungsanleitung

Koryo

Koryo KWHZF15Y Bedienungsanleitung

Pentair

Pentair PSC-14-4-02 Bedienungsanleitung

GE 40M06AAG Montageanleitung

Thermor

Thermor AEROMAX SPLIT 2 Bedienungsanleitung

American Hometec

American Hometec AHQ-B03X Bedienungsanleitung