Bosch 830ES Referenzhandbuch

Technical Service Bulletin:

Resetting the Watervalve

Models: 830ES, 940ES-ESO, C950ES, C1050ES, 1210ES-ESC, T9800/T9900 SE(C)

Data subject to change without notice | Printed in the USA | BTC 740002333 A | 05.2018 Bosch Thermotechnology Corp.

A qualiﬁed service technician is recommended to perform the work.

Problem

Tankless water heater that doesn’t activate, and doesn’t show an error code.

Possible Cause

The watervalve may be clogged or needs to be reset.

Overview

Sometimes a tankless water heater doesn’t start up when water is turned on (above

activation rate), and also doesn’t give an error code. This can be due to the impeller

in the watervalve being stuck or clogged, the water valve being closed, or even just

a clogged inlet ﬁlter. Some of the models have an inlet ﬁlter accessible from outside

the machine, which you can inspect for debris ﬁrst. Other models have it directly

in line with the watervalve, in which you will have to disconnect and remove the

watervalve for access.

Procedure

1. Drain the machine down of any water on both the hot and cold sides.

2. Remove the inlet and outlet water clips and remove watervalve from the

machine. After it is removed, disconnect all wiring to the watervalve.

Inspect the screen for any blockage and clean if necessary.

3. Remove the 2 Phillips head screws that hold the watervalve engine to the

watervalve body (Fig. 1).

Figure 1

4. Remove the 2 Phillips head screws that hold the watervalve engine to the

watervalve body (Fig. 1).

5. Separate the 2 the watervalve body and the watervalve engine.

6. On the valve side, locate the brass gear. Rotate the gear counter clockwise

(towards the “0”) until it stops (Fig. 2).

Figure 2

Data subject to change without notice | Printed in the USA | BTC 740002333 A | 05.2018 Bosch Thermotechnology Corp.

Technical Service Bulletin

2 | Resetting the Watervalve

Bosch Thermotechnology Corp.

65 Grove Street

Watertown, MA 02472

Tel: 1-866-642-3198

Fax: 1-954-776-5529

www.boschheatingandcooling.com

7. On the motor side, slowly rotate the gear clockwise to “0” (Fig. 3). There are

gears inside this motor that cause resistance, do not try to move it fast or

you will damage the gearing.

Figure 3

8. Once that is completed, make sure you can blow through the valve freely

from the bottom where the cross diverter is (Fig. 4). When you forcefully

blow through the valve, you should hear the impeller spinning. If not, use

a small pick or similar device to manually move it. It should move freely

with no resistance. Any resistance could be signs of buildup inside the

valve. Flushing out the valve at this point would be your only way to clear

that obstruction. The impeller is not removable on these valves. If it can’t

spin freely by ﬂushing out the valve or manually rotating it, you may need to

replace the valve.

Figure 4

9. After performing the service, attach the watervalve engine to the watervalve

body with the 2 phillips head screws as shown in Fig. 1.

10. Plug the wiring back in, and reinstall the clips on both the incoming and

outgoing side of the valve.

11. Slowly turn on water supply to check for leaks, before powering up and

returning the tankless unit to service

Andere Handbücher für 830ES

Dieses Handbuch passt für folgende Modelle

Andere Bosch Boiler Handbücher

Bosch

Bosch TRONIC 5000C Pro Technisches Dokument

Bosch

Bosch TR2000T Series Betriebsanleitung

Bosch

Bosch OptiFlow Professional GWH12 1 CTD E23 Bedienungsanleitung

Bosch

Bosch AQUA STAR 250SX LP Bedienungsanleitung

Bosch

Bosch AQUA STAR 2400E NG Bedienungsanleitung

Bosch

Bosch 250 SXO LP Bedienungsanleitung

Bosch

Bosch Greentherm 9800 SEO 160 Bedienungsanleitung

Bosch

Bosch Tronic 3000T Sicherheitsleitfaden

Bosch

Bosch TR5000R Series Bedienungsanleitung

Bosch

Bosch OptiFlow Professional GWH12 1 CTD E23 Bedienungsanleitung

Bosch

Bosch SST150-40 Bedienungsanleitung

Bosch

Bosch Stora WS 300-5 PK Betriebsanleitung

Bosch

Bosch W 135 K B Series Benutzerhandbuch

Bosch

Bosch AquaStar 38B LP Bedienungsanleitung

Bosch

Bosch Tronic 1000 4 T Bedienungsanleitung

Bosch

Bosch YS2180RA Bedienungsanleitung

Bosch

Bosch C1210ES Gebrauchsanweisung

Bosch

Bosch W11P Bedienungsanleitung

Bosch

Bosch BC3200RA Bedienungsanleitung

Bosch

Bosch Tronic 3000T ES2.5 Technisches Dokument

Bosch

Bosch Tronic 1000 T Bedienungsanleitung

Bosch

Bosch 520-HN-N Bedienungsanleitung

Bosch

Bosch 125HX Bedienungsanleitung

Bosch

Bosch Tronic 3500 TO Bedienungsanleitung

Beliebte Boiler Handbücher anderer Marken

Kenmore

Kenmore 153.582400 Bedienungsanleitung

Applimo

Applimo Edel AIR Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON Eltronom SHU 5 S Bedienungsanleitung

clage

clage E-Mini Series Bedienungsanleitung

Toyotomi

Toyotomi Oil Miser OM-180 Bedienungsanleitung

Bradford White

Bradford White EF Series Bedienungsanleitung

Eccotemp

Eccotemp 40-H Bedienungsanleitung

Dimplex

Dimplex ECSd125-580 Leitfaden

Dux

Dux 32FCR6N Bedienungsanleitung

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Fehlerbehebungshandbuch

Noritz

Noritz N-132M Gebrauchsanweisung

TESY

TESY GCV7/4S 10047 Technisches Datenblatt

A.O. Smith

A.O. Smith Gphe 50 Bedienungsanleitung

Koryo

Koryo KWHZF15Y Bedienungsanleitung

Pentair

Pentair PSC-14-4-02 Bedienungsanleitung

GE 40M06AAG Montageanleitung

Thermor

Thermor AEROMAX SPLIT 2 Bedienungsanleitung

American Hometec

American Hometec AHQ-B03X Bedienungsanleitung