B+K precision 2640 Bedienungsanleitung

Safety Term and Symbols

Danger statements identify condition or practices that could result in injury

or loss of life.

Caution statements identify conditions or practices that could result in

damage or fire.

Ground statements identify conditions or practices that could connect

protective conductor.

Caution for safety

Prohibiting to removal the cover

Do not remove the instrument cover to access the internal components. Only B&K

Precisions’ Service technician with knowledge of the instruments’ condition and

dangerous voltages can repair the instrument.

Instruments that appear damaged or defective should be made inoperative and secured

against unintended operation until they can be repaired by qualified service personnel.

Keep the clean on power insert

Instrument’s power insert should remain dust free.

Clean the power insert regularly. Dust could result in damage to this instrument.

Continually clean the dust on input terminal of RF frequency counter.

Clean the input terminal regularly. Dust could result in damage to the instrument.

RF in/output rating

Rating of RF input and output connector

Maximum DC voltage rating

RF input connector (socket): N type female, 50Ohms

Maximum RF input power: 5Vrms

Caution: Do not use over 5Vrms supplied and/or (-) power could result in damage to this

instrument

Do not operate this instrument if there is any doubt it is functioning properly: if

operating personnel feels the instrument is not operating properly, return this instrument

to B&K Precision for service and repair to ensure the safety features are maintained.

DC Power

The operating Personnel must use the DC adaptor supplied with this instrument. Other

adaptors could result in damage to this instrument and it is the limitation of warranty Exterior

DC input connector should be matched with polar. DC connector tip must attach with (+) polar

grounding.

The operating personnel must use grounded power Restore this instrument

Instrument care

＊Avoid direct light

＊Keep away the heating system

＊Avoid high temperature(Ex. Inside of the car during the summer time)

＊Keep away from liquids

＊Avoid high moisture and/or poor ventilation

＊Keep away from dust and/or smoke

＊Avoid extremely low temperature

B&K Precision 2640 Ni-MH battery is rechargeable. Charging is controlled from the power of

the battery cell and the temperature of the battery. Ni-MH Rechargeable battery is going to

increase temp slowly until the temperature is extremely higher. Battery charging is finished

automatically by checking the degree of the temperature (dT/dt). For battery protection, when

the power of Battery cell is increased, comparing regular temperature and/or exterior

temperature degree of when the temperature increases over 50 degrees, battery charging will

be finished automatically.

Operating personnel must use Ni-MH Rechargeable Battery and do not operate in an

explosive atmosphere.

-The battery usage time can change due to the using term, environment and

temperature.

-When battery consumption is large battery-running time will decrease.

Operating personnel should phase in a new battery when battery -running time is less than

half of the initial operating time.

-Operating personnel should not use this instrument and/or keep the battery in

place for long periods of time, which could result in discharge of the battery.

To avoid damages to battery, when battery is low, this instrument will turn off

automatically.

Warranty

Limited One-Year Warranty

B&K Precision warrants to the original purchaser that its products and the

component parts thereof, will be free from defects in workmanship and

materials for a period of one year from date of purchase from an authorized

B&K Precision distributor.

B&K Precision will, without charge, repair or replace, at its option, defective

product or component parts. Returned product must be accompanied by proof

of the purchase date in the form of a sales receipt.

To obtain warranty coverage in the U.S.A., this product must be registered by

completing the warranty registration form on www.bkprecision.com within fifteen

(15) days of purchase.

Exclusions: This warranty does not apply in the event of misuse or abuse

of the product or as a result of unauthorized alterations or repairs. The

warranty is void if the serial number is altered, defaced or removed.

B&K Precision shall not be liable for any consequential damages, including

without limitation damages resulting from loss of use. Some states do not allow

limitations of incidental or consequential damages. So the above limitation or

exclusion may not apply to you.

This warranty gives you specific rights and you may have other rights, which

vary from state-to-state.

B&K Precision

22820 Savi Ranch Parkway

Yorba Linda, CA 92887

www.bkprecision.com

Accessories (included)

Carrying Case AC Adaptor Carrying Strap

Coaxial Cable RS-232 Cable

Power Cable Ear Phone N-BNC

Adaptor

Ni-MH(Rechargeable

Battery) 6PCS User’s Manual Antenna

Software CD

1. Introduction

Overview……………………………….……………………………..……………….11

2. Features

Main features …………………………………………………………………….…12

3. Functions

RF Field Strength Analyzer…………………………………………………..…….13

Frequency Counter……………………………………………………….………….13

Specifications………………………………………………………………...……….14

4. Instrument overview

Front Panel………………………………………………………………………...….18

Rear Panel…………………………………………………………………………….20

Side Panel…………………………………………………………………………….21

Top Panel…………………………………………………………………………..….22

5. Basic operation

Before Power On…………………………………………………………….……….23

Power On……………………………………………………………………………...24

Turn on Power of Instrument………………………………..…………………….25

Description of operation screen…………………………..……………………….26

Reception Mode……………………………………………………………..……….32

Sweep Mode………………………………………………………………………….33

Set up Span……………………………………………………………………..…….34

Frequency Input……………………………………………………..………………. 35

Adjust Screen Level…………………………………………………….………….37

Run - Scanning…………………………………………………..….……………….38

Marker…………………………………………………………..…………………….39

Power Meter…………………………………………………………………………46

Setting of attenuator………………………………………………………………….49

LCD Light……………………………………………………………………………...50

LCD Contrast………………………………………………………………………….51

Buzzer ON/OFF……………………………………………………..……………….52

Table of contents

Save/Load………………………………………………………….………………….53

Frequency Counter…………………………………………………………….…….57

Power Source………………………………………………………………..……….59

Level Unit………………………………………………………………………..…….60

Reset………………………………………………………………………………..…61

Baud Rate…………………………………………………………………………..…62

Connection for PC……………………………………………………………………63

Auto Power……………………………………………………………………………64

Offset…………………………………………………………………………..………65

Menu……………………………………………………………..…………………….66

System……………………………………………………………..…….……………70

6. Description of key operating

Run [GHz] …………………………………………………………………….………73

Mode [MHz] ………………………………………………………………..…………73

Sweep [kHz] …………………………………………………………….……………74

Marker [DEL] …………………………………………………………………………74

No. 1 [Start/Stop] …………………………………………………….………………75

No. 2 [Span] ………………………………………………………………..…………75

No. 3 [Level] …………………………………………………………………….……76

No. 4 [Single]…………………….…………………………..………………………76

No. 5 [Multi]…………………………………………………………………………77

No. 6 [UNIT] ……..…………………………………………..………………………77

No. 7 [LCD Light] ……………………………………………………….……………78

No. 8 [LCD CONT; LCD Contrast] …………………………………………………78

No. 9 [Attenuator] ……………………………………………………………………79

No. 0 [system] …………………………………………………………..……………79

Shift……………………………………………………………………………….……80

Dot [Buzzer] ……………………………………………………………..……………80

Menu [Load] ………………………………………………………………….………81

Enter [Save] …………………………………………………………….……………81

Up/Down Keys and Knob Key………………………………………………………82

Inhaltsverzeichnis

Andere B+K precision Messgerät Handbücher

B+K precision

B+K precision 889B Bedienungsanleitung

B+K precision

B+K precision 878B Bedienungsanleitung

B+K precision

B+K precision 879B Bedienungsanleitung

B+K precision

B+K precision 2831C Bedienungsanleitung

B+K precision

B+K precision RFM3000 Series Bedienungsanleitung

B+K precision

B+K precision 8500B Series Bedienungsanleitung

B+K precision

B+K precision 4045B Bedienungsanleitung

B+K precision

B+K precision 8540 Bedienungsanleitung

B+K precision

B+K precision 240A Bedienungsanleitung

B+K precision

B+K precision 4070A Bedienungsanleitung

B+K precision

B+K precision 2652A Bedienungsanleitung

B+K precision

B+K precision 309 Bedienungsanleitung

B+K precision

B+K precision 302 Bedienungsanleitung

B+K precision

B+K precision 467 Bedienungsanleitung

B+K precision

B+K precision 177/V-95 Bedienungsanleitung

B+K precision

B+K precision 600B Bedienungsanleitung

B+K precision

B+K precision 5335B Bedienungsanleitung

B+K precision

B+K precision SEFRAM 7861 Bedienungsanleitung

B+K precision

B+K precision 2831E Bedienungsanleitung

B+K precision

B+K precision 1535A Bedienungsanleitung

B+K precision

B+K precision 732A Bedienungsanleitung

B+K precision

B+K precision 5332 Analyst 2050 Bedienungsanleitung

B+K precision

B+K precision 830B Bedienungsanleitung

B+K precision

B+K precision 5335C Bedienungsanleitung

Beliebte Messgerät Handbücher anderer Marken

Suaoki

Suaoki D40 Bedienungsanleitung

Elster

Elster BK-G1.6 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Deltabar FMD71 Handbuch

Duratool

Duratool D03128 Bedienungsanleitung

Vega

Vega VEGAPULS 65 Bedienungsanleitung

Tonghui

Tonghui TH2618B Bedienungsanleitung

Tenmars

Tenmars TM-801 Bedienungsanleitung

MSR

MSR 145 Bedienungsanleitung

TPS

TPS WP-82 Bedienungsanleitung

ELMETRON

ELMETRON CP-511 Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 003C30 Bedienungsanleitung

Tenma

Tenma 72-10465 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Proline Promag 50 Technische Daten

Siemens

Siemens SITRANS F Coriolis FCT030 Stücklistenhandbuch

KLINGER

KLINGER CMF V Series Bedienungsanleitung

EXFO

EXFO FTB-2 Bedienungs- und Wartungshandbuch

Keysight

Keysight M8290A Bedienungsanleitung

ADTEK

ADTEK MW-5 Bedienungsanleitung