BEFORE FIRST USE
•Your vacuum cleaner has been packaged carefully to ensure the
product reaches you in good condition. If the product has been
damaged, dropped, has a malfunction in any way, or if the supply
cord is damaged, immediately contact your retailer for replacement
or repair.
•Carefully unpack your vacuum cleaner. Make sure you do not
discard any packaging material until all parts of the vacuum cleaner
have been found.
•Carefully wipe the exterior of the cleaner to remove any dust that
may have accumulated. Dry with a dry towel. Do not use harsh
abrasive cleaners. Remove any label or sticker.
WARNING! Do not immerse in water or any other liquids.
OPERATION
•Carry the vacuum cleaner to the area to be vacuumed.
•Fit the hose, extending tubes and floor tool to the vacuum cleaner.
Ensure that the vacuum dust bag is correctly fitted. WARNING!
Never use without the dust bag and main cloth filter fitted. Note. The
dust compartment door will not close without a dust bag correctly
fitted.
•Extend or retract the brush on the main floor tool as required for the
type of floor to be vacuumed. Extend brush for hard floors such as
tiles or wood and retract for rugs and carpet.
•Pull out the required amount of power cord from the vacuum
cleaner. WARNING! Do not uncoil past the yellow marker on the
power cord, as this is a warning that the power cord is close to its
full length. If the red indicator on the power cord is visible, retract
back to the yellow indicator. Damage to the recoiling mechanism
can result if this warning is ignored and will void warranty.
•Insert the power plug into a mains outlet corresponding with the
vacuum cleaner requirements of 220 – 240V ~ 50 Hz - AC only.
•Switch on power at the mains outlet.
•Set the suction control to the desired power level of the vacuum
cleaner.
•Depress the on/off switch to start or stop the vacuum cleaner. The
cleaner will now start to suction.
2.
•The vacuum cleaner has a manual air flow regulator attached to the
hose handle. This is used to briefly lower the suction level during
operation; the further open the regulator the weaker the suction
power.
•Regularly change the dust bag and ensure the main filter is clean.
When completed disconnect vacuum from the mains supply, retract cord
and empty dust bowl. Store vacuum cleaner along with all it
accessories.
DUST BAG REPLACEMENT
This vacuum cleaner uses model CS018VB dust bag, barcode number
9421009508068 vacuum dust bag available at The Warehouse LTD
nationwide.
CARE AND CLEANING
To clean the outer surface of the vacuum cleaner, use a soft damp cloth
and dry the appliance afterwards with a dry towel. Ensure that no
moisture enters the appliance. Stubborn spots can be cleaned with a
cloth moistened with mild liquid detergent. Do not use solvents to clean
plastic parts. Liquids such as solvents, petrol and oils that contain
chemical substances may damage, corrode or destroy the plastic parts
of the appliance.
Do not put any detergents or any cleaning agents into the vacuum
cleaner.
Clean only after unplugging the vacuum cleaner from the mains supply.
Keep the ventilation slots on the vacuum cleaner clean to prevent the
appliance from overheating.
Regularly clean the air exit filter (Located at rear of vacuum cleaner
behind the rear exhaust filter). Clean by hand in warm soapy water. Air
dry any filter before reinstalling. Do not use a hair dryer or similar
appliance to dry the filters.
Do not expose the vacuum cleaner to direct sunlight as the quality of the
vacuum cleaner finish may deteriorate.
3.
