Bushnell IMAGE VIEW 111024 Bedienungsanleitung

Quick Start Guide

0613

Model#: 111024/

111024ML

TABLE OF CONTENTS PAGE #

ENGLISH

FrANçAIS

ESPAñOL

DEuTSCH

ITALIANO

3-10

11-18

19-26

27-34

35-42

Camera and Binocular Parts Guide

Battery

Cover

USB Port

SD Card Slot

MODE/Power

Button

Camera

Lens

Binocular

Focus

SNAP

Button

Diopter

Adjustment

LCD

Display

1. The camera is powered by two AAA batteries (not included). Insert batteries into the compartment,

using the polarity marks inside for reference. A power meter on the top right of the display indicates

battery condition.

2. Insert an SD card (“upside down” with metal contacts facing up) in the slot if greater storage is desired.

An SD card icon will appear at the top right corner of the LCD display. You may use SD cards (not MMC

cards) up to 2 GB capacity. If no card is inserted, the camera will store photos in its internal memory.

When the internal or card memory is full, and can hold no more photos, the display will indicated“FUL”.

3. Press and release the MODE (Power) button to turn on the camera. The camera will turn o

automatically after about two minutes if no buttons are pressed. To turn the camera o manually, press

and hold the MODE button until the display goes out. Note: when the camera is connected to a computer

via the supplied USB cable, the camera will power on automatically, and draw its power from the computer

with no battery drain.

4. Hold the ImageView steady and press SNAP to take a picture. The camera focus is preset to take sharp

photos of subjects about 50 feet or farther away.

Special Functions/Features

There are several functions/features that can be accessed by pressing the MODE button one or more times

after the camera has been turned on to select the function, then pressing SNAP to conrm and execute the

function. If you do not press the SNAP button to conrm/execute the selected function (while the icon for

that function is displayed) within 5 seconds, the function is cancelled and the camera will return to normal

operating mode. The functions and their display icons are:

Basic Setup

Special Functions/Features (continued)

Press

MODE x

times

Function Name (Description) Display Icon

1Delay Timer (a photo is taken following a

10-second delay after pressing SNAP)

2Movie Mode (camera shoots a short video clip

when SNAP is pressed)

3Consecutive Shot (camera shoots a rapid series

of 3 photos)

4Delete All Photos (erases all photos in internal

or card memory)

5Delete Last Photo (erases only the last photo

taken from internal or card memory)

When cycling through the functions, pressing the MODE button a sixth time (once more after “Delete Last

Photo”) will return the camera and display to normal operating mode (a single still photo is taken as soon

as the SNAP button is pressed).

System Requirements

Operating System: Windows® 2000/ME/XP/Vista/Windows 7 (Windows 98 is not supported)

or Mac OS 9 / OS X

Internal USB Port

Downloading Your Photos

1. Connect the supplied cable to the ImageView’s USB port, then directly to

a main USB port on your computer-do not use front panel/keyboard USB

ports or unpowered “hubs”. The camera’s LCD will indicate “Sto”, and the

ImageView will be recognized as a standard “USB Mass Storage” device-no

driver is needed.

2. With Windows XP or later, you can simply use the options in the pop-up

window to copy, view, or print your photos (Fig. 1). On all Windows OS, the

ImageView will appear as a “Removable Disk” under the “My Computer” list

(on Macs, an icon will appear on your desktop). The ImageView’s photo les

are named “IMG_0001.JPG” etc, and are located in the “DCIM” folder on this

“Removable Disk”. You may copy them to your hard drive as you would any

Special Functions/Features (continued)

Fig. 1

Fig. 2

le-just copy/paste or drag the le names or icons to your drive or desktop.

3. After the photos are copied to your hard drive, you can disconnect the camera. (On Mac computers,

drag the “disk” that appeared on your desktop when the camera was connected into your Trash to “eject” it

before disconnecting.)

4. The standard jpg les from the ImageView may be edited with any photo software you choose to use.

Photos may also be downloaded by removing the card and using any USB card reader with an SD slot.

Adjusting the Binocular IPD

The distance between the eyes, called “interpupillary distance,”

varies from person to person. To set the hinge for your personal

IPD:

Hold the binocular in the normal viewing position, with a firm grip

on each side. Move the barrels closer together or further apart (Fig.

2) until you see a single circular field. Always re-set your binocular to this position before using.

Eyecups

The ImageView binocular is fitted with rubber roll-down eyecups designed for your comfort and to

exclude extraneous light. If you wear glasses, roll down the eyecups. This will bring your eyes closer to the

binocular lens so you can view the entire image without any cutoff.

Downloading Your Photos (continued)

Windows is a registered trademark of Microsoft Corporation in the United States and other countries.

Mac and Mac OS are trademarks of Apple Inc., registered in the U.S. and other countries.

Focusing/Diopter Adjustment

As individual eyesight varies from one person to another, your binocular has an adjustable diopter feature

which allows you to fine-tune the binocular to your vision. To set the diopter and focus the binocular:

1. Adjust the hinge for your interpupillary distance as described in “Adjusting the Binocular IPD”.

2. Set the “diopter adjustment” to zero (Fig. 3).

3. Keep both eyes open at all times.

4. Using a lens cover or your hand, cover the objective (front) lens of the right side of the binocular.

5. Using the center focus wheel, focus on a distant object with fine detail (e.g., brick wall, tree

branches, etc.) until it appears as sharp as possible through the left side of the binocular.

6. Uncover the objective lens on the right side, cover the left objective lens, then view the same

object.

7. Turn the “diopter setting” adjustment ring, until the object is sharp for

your right eye. Caution should be used as over turning or forcing the

diopter eyepiece may damage the binocular.

8. Your binocular should now be adjusted for your eyesight. Focus at any

far or near distances can now be attained simply by turning the center

focus wheel. Make a note of your diopter setting for reference.

Fig. 3

ONEYEAR LIMITED WARRANTY

Your Bushnell®product is warranted to be free of defects in materials and workmanship for one year after the date of purchase. In the event of a defect

under this warranty, we will, at our option, repair or replace the product, provided that you return the product postage prepaid. This warranty does

not cover damages caused by misuse, improper handling, installation, or maintenance provided by someone other than a Bushnell Authorized Service

Department.

Any return made under this warranty must be accompanied by the items listed below:

1. A check/money order in the amount of $10.00 to cover the cost of postage and handling

2. Name and address for product return

3. An explanation of the defect

4. Proof of Date Purchased

5. Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit, with return postage prepaid to the address

listed below:

IN U.S.A. Send To: IN CANADA Send To:

Bushnell Outdoor Products Bushnell Outdoor Products

Attn.: Repairs Attn.: Repairs

9200 Cody 25A East Pearce Street, Unit 1

Overland Park, Kansas 66214 Richmond Hill, Ontario L4B 2M9

For products purchased outside the United States or Canada please contact your local dealer for applicable warranty information.

In Europe you may also contact Bushnell at: Bushnell Germany GmbH

European Service Centre

Mathias-Brüggen-Str. 80

D-50827 Köln

GERMANY

Tel: +49 221 995568-0

Fax: +49 221 995568-20

This warranty gives you specific legal rights.

You may have other rights which vary from country to country.

FCC Compliance Statement:

is equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. ese limits are

designed to provide reasonable protection against harmful interference in a residential installation.

Operation is subject to the following two conditions: (1) is device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

is equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

· Reorient or relocate the receiving antenna.

· Increase the separation between the equipment and receiver.

· Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

· Consult the dealer or an experienced radio/TV technician for help.

e device does not contain any user-serviceable parts. Repairs should only be made by an Authorized Bushnell repair center. Unauthorized repairs or

modications could result in permanent damage to the equipment, and will void your warranty and your authority to operate this device under Part

15 regulations. e shielded interface cable which is provided must be used with the equipment in order to comply with the limits for a digital device

pursuant to Subpart B of Part 15 of FCC Rules.

Disposal of Electric and Electronic Equipment

(Applicable in the EU and other European countries with separate collection systems)

is equipment contains electric and/or electronic parts and must therefore not be disposed of as normal household waste. Instead, it

should be disposed at the respective collection points for recycling provided by the communities. For you, this is free of charge. If the

equipment contains exchangeable (rechargeable) batteries, these too must be removed before and, if necessary, in turn be disposed of

according to the relevant regulations (see also the respective comments in this unit’s instructions). Further information about the subject

is available at your community administration, your local waste collection company, or in the store where you purchased this equipment.

Andere Handbücher für IMAGE VIEW 111024

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Bushnell Fernglas Handbücher

Bushnell

Bushnell Bear Grylls Bedienungsanleitung

Bushnell

Bushnell Imageview 11-1025 Bedienungsanleitung

Bushnell

Bushnell ImageView 98-0917/04-09 Bedienungsanleitung

Bushnell

Bushnell Spectator Bedienungsanleitung

Bushnell

Bushnell LEGEND BB842W Bedienungsanleitung

Bushnell

Bushnell Compact Instant Replay 11-8323 Bedienungsanleitung

Bushnell

Bushnell POWERVIEW 2 Bedienungsanleitung

Bushnell

Bushnell 11 0834 Bedienungsanleitung

Bushnell

Bushnell ImageView 110833 Bedienungsanleitung

Bushnell

Bushnell Elite e2 Bedienungsanleitung

Bushnell

Bushnell 23-2811 Bedienungsanleitung

Bushnell

Bushnell NIGHT WATCH 263230CL Bedienungsanleitung

Bushnell

Bushnell MARINE Binoculars Bedienungsanleitung

Bushnell

Bushnell ImageView 11-8200 Bedienungsanleitung

Bushnell

Bushnell PRIME BP1025B Bedienungsanleitung

Bushnell

Bushnell 11-0512 Bedienungsanleitung

Bushnell

Bushnell H2O 138005 Bedienungsanleitung

Bushnell

Bushnell Marine 13-7507 Bedienungsanleitung

Bushnell

Bushnell 13-1250 Bedienungsanleitung

Bushnell

Bushnell Marine 13-7500 Bedienungsanleitung

Bushnell

Bushnell BINOCULARS-MULTIPLE LANGUAGES Bedienungsanleitung

Bushnell

Bushnell ImageView 11-8313 Bedienungsanleitung

Bushnell

Bushnell Trophy XLT Bedienungsanleitung

Bushnell

Bushnell ImageView 110833 Bedienungsanleitung

Beliebte Fernglas Handbücher anderer Marken

Celestron

Celestron VistaPix 72218 Bedienungsanleitung

Levenhuk

Levenhuk Atom Digital DNM200 Bedienungsanleitung

ATN

ATN PS-15 Bedienungsanleitung

Bresser

Bresser TOPAS 7x50 Bedienungsanleitung

Berger & Schroter

Berger & Schroter LN-G3-B50 Bedienungsanleitung

Leica

Leica geovid 8x42 HD-R Bedienungsanleitung

Noblex

Noblex NF 8 x 42 inception Bedienungsanleitung

PHOTONIS

PHOTONIS VYPER Bedienungsanleitung

ATN

ATN 6015-WPT Bedienungsanleitung

Famous Trails

Famous Trails ViewCatcher DCB 822 Bedienungsanleitung

AGM

AGM EXPLORATOR FSB50-640 Bedienungsanleitung

Opticron

Opticron Marine-3 7x50 BIF.GA Installationsanleitung

Kayoba

Kayoba 009129 Bedienungsanleitung

Vixen

Vixen ARENA Series Bedienungsanleitung

MAGINON

MAGINON NVB 60 Bedienungsanleitung

Leica

Leica Geovid 56 Bedienungsanleitung

Leica

Leica GEOVID PRO Bedienungsanleitung

Celestron

Celestron LandScout Bedienungsanleitung