Cabletron Systems 7F06-02 FDDI SmartSwitch Bedienungsanleitung

7F06-02 FDDI SmartSWITCH

™

Interface Module

User’s Guide

9031672-01

Notice

NOTICE

Cabletron Systems reserves the right to make changes in

speciﬁcations and other information contained in this document

without prior notice. The reader should in all cases consult

Cabletron Systems to determine whether any such changes have

been made.

The hardware, ﬁrmware, or software described in this manual is

subject to change without notice.

In no event shall Cabletron Systems be liable for any incidental,

indirect, special, or consequential damages whatsoever (including

but not limited to lost proﬁts) arising out of or related to this

manual or the information contained in it, even if Cabletron

Systems has been advised of, known, or should have known, the

possibility of such damages.

Cabletron Systems, Inc.,

35 Industrial Way

Rochester, NH 03867-0505

Printed in the United States of America

Order Number: 9031672-01

LANVIEW

is a registered trademark of Cabletron Systems, Inc.

MMAC

and

MMAC SmartSWITCH

are

registered trademarks of

Cabletron Systems, Inc.

Ethernet

is a trademark of Xerox Corp.

CompuServe

is a registered trademark of CompuServe, Inc.

Notice

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is

subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

NOTE:

This equipment has been tested and found to comply with

the limits for a Class A digital device, pursuant to Part 15 of the

FCC rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is

operated in a commercial environment. This equipment uses,

generates, and can radiate radio frequency energy and if not

installed in accordance with the operator’s manual, may cause

harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause interference in

which case the user will be required to correct the interference at his

own expense.

WARNING:

Changes or modiﬁcations made to this device which

are not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

DOC NOTICE

This digital apparatus does not exceed the Class A limits for radio

noise emissions from digital apparatus set out in the Radio

Interference Regulations of the Canadian Department of

Communications.

Le présent appareil numérique n’émet pas de bruits

radioélectriques dépassant les limites applicables aux appareils

numériques de la class A prescrites dans le Règlement sur le

brouillage radioélectrique édicté par le ministère des

Communications du Canada.

Notice

iii

VCCI NOTICE

This equipment is in the 1st Class Category (information

equipment to be used in commercial and/or industrial areas) and

conforms to the standards set by the Voluntary Control Council for

Interference by Information Technology Equipment (VCCI) aimed

at preventing radio interference in commercial and/or industrial

areas.

Consequently, when used in a residential area or in an adjacent area

thereto, radio interference may be caused to radios and TV

receivers, etc.

Read the instructions for correct handling.

CONTENTS

CHAPTER 1 INTRODUCTION

1.1 USING THIS MANUAL .........................................................................1-1

1.2 THE 7F06-02 MODULE...........................................................................1-2

1.2.1 Cable Type and FPIMs ..................................................................1-2

1.2.2 7C03 MMAC SmartSwitch, the 7C04 Workgroup SmartSwitch

and the 7C04-R Workgroup SmartSwitch ..................................1-3

1.3 FEATURES ................................................................................................1-4

1.3.1 FPIMs...............................................................................................1-4

1.3.2 LANVIEW LEDs............................................................................1-4

1.3.3 Connectivity....................................................................................1-4

1.4 RELATED MANUALS ............................................................................1-5

1.5 GETTING HELP.......................................................................................1-5

CHAPTER 2 NETWORK REQUIREMENTS

2.1 FPIM MODULE SPECIFICATIONS......................................................2-1

2.1.1 FPIM-00 and FPIM-01 ...................................................................2-1

2.1.2 FPIM-02 and FPIM-04 ...................................................................2-3

2.1.3 FPIM-05 and FPIM-07 ...................................................................2-4

CHAPTER 3 INSTALLATION/REMOVAL

3.1 UNPACKING THE 7F06-2 MODULE...................................................3-1

3.2 INSTALLING FPIMS...............................................................................3-1

3.3 INSTALLING/REMOVING THE 7F06-02 MODULE.......................3-2

3.3.1 Installing in the 7C03 SmartSwitch .............................................3-2

3.3.2 Removing from the7C03 SmartSwitch........................................3-3

3.3.3 Installing in the 7C04 or 7C04-R Workgroup SmartSwitch .....3-5

3.3.4 Removing from the 7C04 or 7C04-R Workgroup SmartSwitch.3-

CHAPTER 4 TROUBLESHOOTING

CHAPTER 5 TECHNICAL SPECIFICATIONS

5.1 STANDARDS............................................................................................5-1

5.2 EMI.............................................................................................................5-1

5.3 EMC ...........................................................................................................5-1

5.4 NETWORK INTERFACES......................................................................5-1

5.5 SAFETY......................................................................................................5-2

5.6 SERVICE....................................................................................................5-2

Contents

5.7 PHYSICAL ................................................................................................5-2

5.7.1 Dimensions .....................................................................................5-2

5.7.2 Weight..............................................................................................5-2

1-1

CHAPTER 1

INTRODUCTION

Welcome to Cabletron Systems

7F06-02 FDDI SmartSwitch Interface

Module User’s Guide

. This guide is a simple reference for installing

and using the 7F06-02 Module. Before installing this module, you

should carefully read through this manual to gain a full

understanding of its capabilities.

The 7F06-02 Module is a two port FDDI module. This module

connects to a network and the 7X00 SmartSwitch™ Control

Module in the 7C03,7C04 or 7C04-R MMAC SmartSwitch via a

SmartSwitch bus.

1.1 USINGTHIS MANUAL

Chapter 1,

Introduction

, discusses the capabilities and special

features of Cabletron Systems 7F06-02 Module. This chapter also

includes a list of related manuals.

Chapter 2,

Network Requirements

, contains a list of available

FPIMs and the network requirements that should be considered

before installing the 7F06-02 Module.

Chapter 3,

Installation/Removal

, contains instructions for

installing and removing the 7F06-02 in the 7C03 MMAC

SmartSwitch, the 7C04 Workgroup SmartSwitch or the 7C04-R

Workgroup SmartSwitch.

Chapter 4,

Troubleshooting

, contains instructions for using

LANVIEW

(Cabletron Systems built-in diagnostic and status

monitoring system).

Chapter 5,

Technical

Speciﬁcations,

provides detailed information

about the physical characteristics of the 7F06-02 Module.

1-2

INTRODUCTION

1.2 THE 7F06-02 MODULE

The 7F06-02 Module provides two Fiber Optic ports via front panel

FPIM modules.

1.2.1 CableType and FPIMs

The 7F06-02 module has two front panel connectors that interface

to the 7X00 Smart Switch Module through the chassis backplane.

The front panel connections are standard Cabletron FPIMs. There

are two FPIMs for each channel. These FPIMs allow the use of

single mode or multimode ﬁber cable with MIC or SC type

connectors and twisted pair cable, either shielded or unshielded.

INTRODUCTION

1-3

Figure 1-1. 7F06-02 Module

1.2.2 7C03 MMAC SmartSwitch, the 7C04 Workgroup

SmartSwitch and the 7C04-RWorkgroup

SmartSwitch

The 7F06-02 Module is designed to be installed in the 7C03 MMAC

SmartSwitch, the 7C04 Workgroup SmartSwitch or the 7C04-R

Workgroup SmartSwitch.

The modular design of the 7C03 MMAC SmartSwitch allows other

modules that support Ethernet, Fast Ethernet, ATM, FDDI, or

7F06-02

1-4

INTRODUCTION

Token Ring to be used with the 7F06-02 Module. These modules

provide the capability to share data without the use of external

bridges or routers.

The 7C03 MMAC SmartSwitch is a unique module that can be

installed in an MMAC Series chassis. The 7C04 Workgroup

SmartSwitch and the 7C04-R Workgroup SmartSwitch are stand-

alone chassis that provide the same functions.

1.3 FEATURES

The 7F06-02 Module provides two FDDI ports via front panel

FPIMs. The 7F06-02 Module includes the following features:

1.3.1 FPIMs

The front panel connections are standard Cabletron FPIMs. These

FPIMs allow the use of single mode or multimode ﬁber cable with

MIC or SC type connectors.

1.3.2 LANVIEW LEDs

The 7F06-02 uses LANVIEW, Cabletron Systems built-in visual

diagnostic and status monitoring system. With LANVIEW LEDs,

you can quickly identify, at a glance, the status of the device

connected to a port on the 7F06-02 Module.

1.3.3 Connectivity

The 7F06-02 Module has one backplane connection and two sets of

A/B front panel FPIM connections. The backplane connection

provides power to the 7F06-02 Module and a channel for

communication with the 7X00 SmartSwitch Control Module. The

two front panel FPIMs provide FDDI connections, allowing the use

of single mode or multimode ﬁber cable with MIC or SC type

connectors.

Inhaltsverzeichnis

Andere Cabletron Systems Schalten Handbücher

Cabletron Systems

Cabletron Systems SmartSwitch 9000 Bedienungsanleitung

Cabletron Systems

Cabletron Systems SEHI-22 Bedienungsanleitung

Cabletron Systems

Cabletron Systems SmartSTACK ELS100-S24TX2M Bedienungsanleitung

Cabletron Systems

Cabletron Systems SEHI SEHI100TX- Bedienungsanleitung

Cabletron Systems

Cabletron Systems MMAC-Plus 9F116-01 Bedienungsanleitung

Cabletron Systems

Cabletron Systems MMAC-Plus 9EX02-12 Bedienungsanleitung

Cabletron Systems

Cabletron Systems SmartCell 6A000 Bedienungsanleitung

Cabletron Systems

Cabletron Systems Cabletron CyberSWITCH CSX5500 Bedienungsanleitung

Cabletron Systems

Cabletron Systems SmartSTACK ETHERNET ELS10-27 Bedienungsanleitung

Cabletron Systems

Cabletron Systems Netlink FRX8000 Bedienungsanleitung

Cabletron Systems

Cabletron Systems STH 24 STH-24 Bedienungsanleitung

Cabletron Systems

Cabletron Systems CyberSWITCH CSX150 Bedienungsanleitung

Cabletron Systems

Cabletron Systems SmartSwitch 8000 Bedienungsanleitung

Cabletron Systems

Cabletron Systems BRIM-A6 Bedienungsanleitung

Cabletron Systems

Cabletron Systems HubSTACK SEHI-34 Bedienungsanleitung

Cabletron Systems

Cabletron Systems SmartSwitch 9W006 Bedienungsanleitung

Cabletron Systems

Cabletron Systems 9F120-08 Technisches Dokument

Cabletron Systems

Cabletron Systems MMAC-Plus 9G426-02 Bedienungsanleitung

Cabletron Systems

Cabletron Systems SmartSwitch 9000 Technisches Dokument

Cabletron Systems

Cabletron Systems SmartStack STS16-20R Bedienungsanleitung

Cabletron Systems

Cabletron Systems MMAC-Plus 9H423-28 Handbuch

Cabletron Systems

Cabletron Systems SEHI100TX-22 Bedienungsanleitung

Cabletron Systems

Cabletron Systems SmartSwitch 6500 Montageanleitung

Cabletron Systems

Cabletron Systems 2E48-27R Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung