Carrier 5+2 DAY PROGRAMMABLEDIGITAL THERMOSTAT Bedienungsanleitung

NOTE TO INSTALLER: THIS MANUAL MUST BE LEFT WITH THE EQUIPMENT USER.

TSTATCCPQ501 PROGRAMMABLE

DIGITAL THERMOSTAT

USER INFORMATION MANUAL FOR THE OPERATION AND

MAINTENANCE OF YOUR NEW THERMOSTAT

Heating & Cooling

72 72

I2:00

SET

SINGLE STAGE HEAT & COOL

THERMOSTAT

5+2 DAY PROGRAMMABLE

Meets California Title 24 Residential

run

off

set

prog

5+2 DAY PROGRAMMABLE

DIGITAL THERMOSTAT

Separate programs for

weekdays & weekends

Large, easy to read,

backlit digital display

Installation Flexibility

Batteries required for

4-wire operation

No batteries needed

for 5-wire operation

Table Of Contents

LOCATION OF CONTROLS

DISPLAY

NORMAL OPERATION

Manual Thermostat Operation

Time Period Operation

CLOCK SET

ADVANCED SETUP

Page 1

PROGRAMMING Setup

Overview

Program Setup

SAFETY WARNINGS

BATTERY REPLACEMENT

WARRANTY

Carrier Corporation Residential Light Commercial Systems Patents Pending 4/03

Safety Warnings

Page 2

TSTATCCPQ501

CAUTION Follow Installation Instructions carefully.

DISCONNECT POWER TO THE HEATER -

AIR CONDITIONER BEFORE REMOVING

THE OLD THERMOSTAT AND INSTALLING

THE NEW THERMOSTAT.

WARNING

The 2 Alkaline “AA” batteries must be replaced at least

every 12 months to assure proper operation.

The thermostat will display the Low Battery

code (fig. 1) on the display of the thermostat

when it is time to replace the batteries. If the

thermostat is connected to 24v power, the

Batteries may still be installed, but are not required.

When is displayed the batteries must be replaced

immediately. The manufacturer cannot be liable for

improper operation of the thermostat if the batteries are

not immediately replaced.

The annual battery replacement is especially critical in

locations subject to freezing temperatures. The

thermostat will be unable to turn on the Heat if the

batteries are exhausted.

CAUTION

This device complies with Part 15 of the FCC rules.

Operation is subject to the following 2 conditions:

(1) This device may not cause harmful interference, and (2)

This device must accept any interference received, including

interference that may cause undesired operation.

FIG. 1

Location of Controls

Page 3

72 72

I2:00

SET

MODE SWITCH

On or Auto

FAN SWITCH

UP & DOWN

BUTTONS

HEAT/COOL

INDICATOR

Heat, Cool or Off

PROGRAM SWITCH

RUN program

Program OFF

SET program

NEXT BUTTON

For programmingFor programming

How to Use: The Next button is used to advance

from one step to the next in the programming and

advanced setup screens of the thermostat (pages 8-16).

It is also used to enter the Advanced Setup screens (page 16).

The Heat/Cool

indicator will only

energize if the

thermostat is system

powered.

run

off

set

prog

Display

Page 4

8888

I2:00

SET

MTuWThF

SaSuHeatCool

Morning

Evening

Night

Day

Day of the week. When programming, MTuWThF

represents the 5 weekdays, SaSu represent the

2 weekend days.

Heat and Cool indicators. In normal operation, Heat

or Cool appears, reflecting the mode switch position.

Clock Display.

Desired Set temperature indicator.

Current room temperature indicator.

Time period indicators. These indicate the part of

the program that is currently active, if the program

switch is positioned to Run.

Page 5

Normal Operation

72 72

I2:00

SET

Manual Operation (program switch OFF)

Select heat or cool with the mode switch.

Normally leave the fan switched to auto.

In fan auto, the fan will turn on only with a heat

or cool demand. When Fan On is selected, the

fan will run continuously.

Adjust the desired set temperature with the

Up or Down buttons.

On or Auto

Program

Switch

RUN

OFF

SET

PROGRAM

SWITCH

MODE SWITCH FAN SWITCH

Heat

run

off

set

prog

UP & DOWN

BUTTONS

Heat, Cool or Off

Normal Operation

Page 6

72 72

I2:00

SET

MODE SWITCH

Programmed Operation (program switch RUN)

Select heat or cool with the mode switch.

Normally leave the fan switched to auto.

In fan auto, the fan will turn on only with a heat

or cool demand. When Fan On is selected, the

fan will run continuously.

Optionally; adjust the desired set temperature

for temporary override. The programmed

settings will restore in the following time period.

On or Auto

FAN SWITCH

Program

Switch

RUN

OFF

SET

PROGRAM

SWITCH

Heat

run

off

set

prog

UP & DOWN

BUTTONS

Heat, Cool or Off

Page 7

Clock Set

6:00

Use these buttons to

adjust the current time.

Use these buttons to

adjust the current day.

Slide the program switch to the SET position.

6:00

Pushing and holding the Up or Down buttons will slew the time by

10s of minutes.

Press the NEXT button for 5 seconds to enter advanced

setup. (Page16)

Setting the time & day are the first 2 steps after

sliding the program switch to SET.

Program

RUN

OFF

SET

Page 8

Time Period Programming

Program

Switch

RUN

OFF

SET

PROGRAM SWITCH

Overview

Slide the program switch to the SET position.

The blinking icon(s) on the display may be

changed by pressing the Up or Down buttons.

After the blinking icon is changed how you want

it, press the Next button.

The next icon in ‘programming sequence’ will flash.

It can be modified with the Up & Down buttons.

Continue the steps above until programming is complete.

Slide the program switch to RUN and the thermostat

will now run the time period programming.

If the program switch is in the OFF position, the thermostat

will not run the time period program. In this case the

thermostat will be a manual heat or cool only thermostat.

Please be certain to program each time period in chronological

order to ensure proper programmed operation of the

thermostat. For example, if the Morning Start Time is

6:30am, then the Day Start Time MUST be programmed

for any time AFTER the 6:30am Morning Start Time.

Page 9

Time Period Programming

Slide the program switch to the SET position. The

1st 2 steps are clock and day set, see page 7.

Program

RUN

OFF

SET

6:00

MTuWThF

Morning

Use these buttons to

adjust the start time for

the morning time period.

6:00

SET

MTuWThF

Cool

Morning

Use these buttons to

adjust the cool setpoint for

the morning time period.

6:00

SET

MTuWThF

Heat

Morning

Use these buttons to

adjust the heat setpoint for

the morning time period.

8:00

MTuWThF

Use these buttons to

adjust the start time for

the day time period.

Day

Weekday Programming

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Carrier Thermostat Handbücher

Carrier

Carrier TP-WEM01 Bedienungsanleitung

Carrier

Carrier 33CS Anleitungen und Rezepte

Carrier

Carrier KSACN0901AAA Bedienungsanleitung

Carrier

Carrier Touch-n-Go TC-PHP01-A Bedienungsanleitung

Carrier

Carrier CRC2 - NTC Bedienungsanleitung

Carrier

Carrier 33CS Bedienungsanleitung

Carrier

Carrier TSTTCCPB101 Bedienungsanleitung

Carrier

Carrier EDGE Pro 33CS Bedienungsanleitung

Carrier

Carrier 33CS Handbuch

Carrier

Carrier 33CS Bedienungsanleitung

Carrier

Carrier 53DFS250-HW Bedienungsanleitung

Carrier

Carrier Performance TP-NHP Bedienungsanleitung

Carrier

Carrier 33CS Bedienungsanleitung

Carrier

Carrier TC-WHS01 Bedienungsanleitung

Carrier

Carrier EDGE Pro 33CS2PPRH-03 Bedienungsanleitung

Carrier

Carrier 33CSSP3-FC Bedienungsanleitung

Carrier

Carrier CONNECT 33CONNECTSTAT Bedienungsanleitung

Carrier

Carrier 33CS Bedienungsanleitung

Carrier

Carrier 33CS Bedienungsanleitung

Carrier

Carrier ComfortVu TBPL-24-H Betriebsanleitung

Carrier

Carrier Cool Share Web-Programmable Thermostat Bedienungsanleitung

Carrier

Carrier TSTATCCPS701 Bedienungsanleitung

Carrier

Carrier 33CSSP3-FC Bedienungsanleitung

Carrier

Carrier Programmable Dual Fuel Thermostats Anleitungen und Rezepte

Beliebte Thermostat Handbücher anderer Marken

EWELLY

EWELLY EW-181 Bedienungsanleitung

Prolon

Prolon T1100 Montageanleitung

Computherm

Computherm Q20 Bedienungsanleitung

Heatmiser

Heatmiser neoStat Bedienungsanleitung

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Bedienungsanleitung

Saswell

Saswell SAS920XWHB-7-S-RF Leitfaden

Aircalo

Aircalo TFP1-ET85P2 Bedienungsanleitung

Honeywell

Honeywell CM721 Bedienungsanleitung

Lennox

Lennox iHarmony Zone Thermostat Montageanleitung

Gemtech

Gemtech GT7000 Bedienungsanleitung

Rollei

Rollei Smartes 45000 Bedienungsanleitung

Sinope

Sinope TH1300RF Bedienungsanleitung

Honeywell

Honeywell RLV4305 Bedienungsanleitung

Honeywell

Honeywell Prestige 2.0 THX9421 Bedienungsanleitung

NuTone

NuTone NTBZ48 Original Betriebsanleitung

Stelpro

Stelpro MAESTRO ASMT402AD Bedienungsanleitung

Honeywell

Honeywell T6811 Bedienungsanleitung

Aube Technologies

Aube Technologies TH305 Bedienungsanleitung