Champion Power Equipment 100306 Service-Handbuch

11/8/18 1 Champion Power Equipment, Inc.

Technical Bulletin

Number: 181108-60-50-1

Date: 11/8/18

Recoil Install for Clamshell Inverters

This covers the following models (Read completely before performing service):

•100306

•100402

•100414

•100565

•All other Clamshell-Style Inverters

1. Unscrew total (8) screws of left and right cover

assembly, and then remove left and right cover

assembly. (Note: there are two tapping screws at

the bottom of right panel side –remove them)

11/8/18 2 Champion Power Equipment, Inc.

2. Unscrew all screws and bolts of front cover/ rear

cover. Remove the snap spring under the fuel

spill rubber. Then remove the rear cover and the

illuminator.

11/8/18 3 Champion Power Equipment, Inc.

3. Pull out the fuel hose from the fuel switch and

remove the fuel tank. (If the unit has fuel level

sensor, unplug the connector of the sensor).

4. Unscrew the screws to remove the right cover.

Unscrew the screws of handle oriented plate and

have the recoil handle through the front cover.

5. Pull out the fuel hose from the carburetor inlet

nozzle to have front cover move freely.

11/8/18 4 Champion Power Equipment, Inc.

6. Unscrew the (2) bolts of metal bracket. And

unplug the connectors of right panel and

controller module. Remove the right panel

assembly and whole metal bracket with the

controller module.

7. Unscrew the bolts of the recoil cover and remove

the recoil assembly

8. Put the new spring into the pulley if need to

replace a new spring.

11/8/18 5 Champion Power Equipment, Inc.

9. Put the new rope into the pulley and secure with

a stop-knot. And then rotate the rope clockwise

[spring side towards to you] (about 3.5 turns)

until the rope aligns with the open slot on the

outer edge of the pulley.

10. Apply lubricant or grease to the shaft of the

recoil cover and insert the pulley to the recoil

cover.

11. Pull the rope into the slot and take the loose part

of the rope inside the pulley and rotate the

pulley about 3 turns [counter-clockwise] until the

tension spring resists. Hold the pulley from

reversing until the rope is ready to wind back

onto the pulley. Feed the rope out to the hole of

recoil cover and pull it through the guide hole on

the outside of the recoil cover. Place the guide

plate / pull handle on the rope and secure with a

stop-knot.

11/8/18 6 Champion Power Equipment, Inc.

12. Place the (2) detent springs as shown

13. Place 2 plastic detents into the spring positions

with some lubricant. Note the detents must

press the springs when installing.

11/8/18 7 Champion Power Equipment, Inc.

14. Install the hoop onto the plastic press plate, and

then put the plastic press plate onto the plastic

detents. Note: the salient of detents must snap-

into the guide slot of press plate.

11/8/18 8 Champion Power Equipment, Inc.

15. The bolt can have some locking glue, put the bolt

into the through-hole of press plate and tighten

the bolt.

16. Secure a stop-knot at the end of the new recoil

cover end.

17. Pull rope out for some length and secure a stop-

knot, and then disassemble the oriented plate

from old recoil assembly and install it to the new

one.

11/8/18 9 Champion Power Equipment, Inc.

18. Re-install the recoil assembly with tightening the

bolts. Have the recoil handle and oriented plate

through the front cover. And then install the

oriented plate to the panel and tighten the

screws.

19. Re-install the metal bracket and plug all

connectors.

20. Re-install the fuel tank. Remember to plug the

fuel hoses to fuel switch side and carburetor

inlet nozzle side.

11/8/18 10 Champion Power Equipment, Inc.

21. Re-Install front cover, rear cover and illuminator

and tighten the screws and bolts. Don’t forget the

tapping screws at the bottom and the snap spring.

Andere Handbücher für 100306

Dieses Handbuch passt für folgende Modelle

Andere Champion Power Equipment Tragbarer Generator Handbücher

Champion Power Equipment

Champion Power Equipment 201182 Betriebsanleitung

Champion Power Equipment

Champion Power Equipment 75531i Systemhandbuch

Champion Power Equipment

Champion Power Equipment 73534i Systemhandbuch

Champion Power Equipment

Champion Power Equipment 41111 Handbuch

Champion Power Equipment

Champion Power Equipment 71330 Systemhandbuch

Champion Power Equipment

Champion Power Equipment C41155 Bedienungsanleitung

Champion Power Equipment

Champion Power Equipment 46539 Systemhandbuch

Champion Power Equipment

Champion Power Equipment 42431 Handbuch

Champion Power Equipment

Champion Power Equipment 71531 Systemhandbuch

Champion Power Equipment

Champion Power Equipment 73536i Systemhandbuch

Champion Power Equipment

Champion Power Equipment ETL70007 Handbuch

Champion Power Equipment

Champion Power Equipment 41153 Handbuch

Champion Power Equipment

Champion Power Equipment C75520 Bedienungsanleitung

Champion Power Equipment

Champion Power Equipment 100331 Bedienungsanleitung

Champion Power Equipment

Champion Power Equipment Cabela's Outdoorsman Series Bedienungsanleitung

Champion Power Equipment

Champion Power Equipment Power Sports 73538i Systemhandbuch

Champion Power Equipment

Champion Power Equipment C46540 Handbuch

Champion Power Equipment

Champion Power Equipment 72531 Systemhandbuch

Champion Power Equipment

Champion Power Equipment 40008 Handbuch

Champion Power Equipment

Champion Power Equipment CSA40043 Handbuch

Champion Power Equipment

Champion Power Equipment Paralink 100740 Bedienungsanleitung

Champion Power Equipment

Champion Power Equipment 201078 Bedienungsanleitung

Champion Power Equipment

Champion Power Equipment C41255 Bedienungsanleitung

Champion Power Equipment

Champion Power Equipment 100396 Bedienungsanleitung

Beliebte Tragbarer Generator Handbücher anderer Marken

Kohler

Kohler 20EORZ Bedienungsanleitung

Powerhorse

Powerhorse 83171 Bedienungsanleitung

HURST

HURST ML-630-SI Bedienungsanleitung

ETQ

ETQ TG4000 Bedienungsanleitung

Briggs & Stratton

Briggs & Stratton 40265 Einrichtungshandbuch

evertz

evertz 7700 Series Bedienungsanleitung

Firefly

Firefly Cygnus CYG2400/460/24 Bedienungsanleitung

Owon

Owon Waveform Generator Bedienungsanleitung

Draper

Draper PG950S Firmware-Update

SDMO

SDMO SH 4000 Bedienungsanleitung

EINHELL

EINHELL STE 5500 Bedienungsanleitung

Wanco

Wanco WI3000P Bedienungsanleitung

Full Boar

Full Boar FBT-3300 Bedienungsanleitung

Dwyer Instruments

Dwyer Instruments ASG Bedienungsanleitung

Westinghouse

Westinghouse WH1000i Series Bedienungsanleitung

Wallenstein

Wallenstein GF5000A Bedienungsanleitung

Leroy-Somer

Leroy-Somer LSA 49.1 Bedienungsanleitung

Yamakoyo

Yamakoyo SH2900DX Bedienungsanleitung