Cisco 7941G - Unified IP Phone VoIP Bedienungsanleitung

Handset, Headset, and Speakerphone

•Headset, Handset, and Speaker Overview, page 1

•Handset, page 1

•Headset, page 2

•Speakerphone, page 3

•AutoAnswer with Headset or Speakerphone, page 3

Headset, Handset, and Speaker Overview

You can use your phone with these audio devices: a handset, headset, or speakerphone.

The phone is off-hook when the handset is lifted or another audio device is in use.

The phone is on-hook when the handset is in its cradle and other audio devices are not in use.

Handset

The following table describes how to use the handset.

Then...If you want to...

Lift it to go off-hook; replace it to go on-hook.

The ringing line is automatically selected. Contact your system

administrator about options to always select the primary line.

Use the handset

Press or ( ), then hang up the handset.

Switch to the speakerphone or a

headset during a call

Press the Volume button during a call or after invoking a dial tone.

Press Save to preserve the volume level for future calls.

Adjust the volume level for a call

Cisco Unified IP Phone 7941G, 7941G-GE, 7942, 7961G, 7961G-GE, and 7962 User Guide for Cisco Unified

Communications Manager 9.0 (SCCP and SIP)

Headset

Your phone supports four- or six-wire headset jacks for wired headsets. Cisco Unified IP Phones 7962G and

7942G also support wireless headsets. For information about purchasing headsets, see Wired and Wireless

Headsets.

You can use a headset with all of the controls on your phone, including and .

However, if you use a wireless headset, refer to the wireless headset documentation for instructions.

Then...If you want to...

Press .

Toggle headset mode on and off

Lift the handset.Switch to a handset

Press during a call or after invoking a dial tone.

Press Save to preserve the volume level for future calls.

Adjust the volume level for a call

If you use AutoAnswer, see AutoAnswer with Headset or Speakerphone, on page 3.

Your system administrator can set up your phone to record a conversation between you (on your headset), a

supervisor (on the phone handset), and your connected party.

Control Wired Headset Sidetone

When you speak on a telephone using a headset, the sound picked up by the headset microphone can be sent

back through the headset speaker. This creates a low-level feedback, known as sidetone. The wired headsets

can result in sidetone . Different wired headsets require different sidetone and settings. You need to select the

best sidetone level for the wired headset you use.

Procedure

Step 1 Press .

Step 2 Use the Preferences menu and navigate to Headset Sidetone.

Step 3 Select Headset Sidetone.

Step 4 Select one of the sidetone levels:

•High

•Normal

•Low

•Very Low

•Off

Cisco Unified IP Phone 7941G, 7941G-GE, 7942, 7961G, 7961G-GE, and 7962 User Guide for Cisco Unified

Communications Manager 9.0 (SCCP and SIP)

Handset, Headset, and Speakerphone

Headset

Step 5 Press Save or press Cancel.

Wireless Headset

Cisco Unified IP Phones 7962G and 7942G support wireless headsets. Refer to the wireless headset

documentation for information about using the wireless headset’s remote features. Also, check with your

system administrator to be sure your phone is enabled to use a wireless headset with the wireless headset

remote hookswitch control feature.

Wideband Headset

If you use a headset that supports wideband, you may experience improved audio sensitivity if you enable

the wideband setting on your phone (this setting is disabled by default). To access the setting, choose

>User Preferences >Audio Preferences >Wideband Headset.

If the Wideband Headset setting is dimmed, then you cannot control this setting.

Check with your system administrator to be sure your phone system is configured to use wideband. If the

system is not configured for wideband, you may not detect any additional audio sensitivity even when using

a wideband headset. To learn more about your headset, refer to the headset documentation or contact your

system administrator for assistance.

Speakerphone

If the handset is in its cradle and is not lit, many of the actions you can take to dial a number or answer a

call will trigger speakerphone mode automatically.

Then...If you want to...

Press .

Toggle speakerphone mode on or off

Lift the handset.Switch to a handset

Press during a call or after invoking a dial tone.

Press Save to preserve the volume level for future calls.

Adjust the volume level for a call

AutoAnswer with Headset or Speakerphone

When AutoAnswer is enabled, your phone answers incoming calls automatically after a few rings. Your

system administrator configures AutoAnswer to use either the speakerphone or a headset. You may use

AutoAnswer if you receive a high volume of incoming calls.

Cisco Unified IP Phone 7941G, 7941G-GE, 7942, 7961G, 7961G-GE, and 7962 User Guide for Cisco Unified

Communications Manager 9.0 (SCCP and SIP)

Handset, Headset, and Speakerphone

Wireless Headset

Then...If you...

Keep headset mode active (in other words, keep illuminated), even when you are

not on a call.

To keep headset mode active, perform the following actions:

•Press EndCall to hang up.

•Press New Call or Dial to place new calls.

If your phone is set up to use AutoAnswer in headset mode, calls are automatically

answered only if is illuminated.

Otherwise, calls ring normally and you must manually answer them.

Use AutoAnswer

with a headset

Keep the handset in the cradle and headset mode inactive ( unlit).

Otherwise, calls ring normally and you must manually answer them.

Use AutoAnswer

with the

speakerphone

Tip

AutoAnswer is disabled when the Do Not Disturb feature is active.

Cisco Unified IP Phone 7941G, 7941G-GE, 7942, 7961G, 7961G-GE, and 7962 User Guide for Cisco Unified

Communications Manager 9.0 (SCCP and SIP)

Handset, Headset, and Speakerphone

AutoAnswer with Headset or Speakerphone

Andere Handbücher für 7941G - Unified IP Phone VoIP

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Cisco IP-Telefon Handbücher

Cisco

Cisco 7925G - Unified Wireless IP Phone VoIP Bedienungsanleitung

Cisco

Cisco SPA525G - Small Business Pro IP Phone VoIP Bedienungsanleitung

Cisco

Cisco Unified IP Phone Expansion Module 7915 Bedienungsanleitung

Cisco

Cisco 8945 Bedienungsanleitung

Cisco

Cisco 8841 Bedienungsanleitung

Cisco

Cisco SPA300 Series Referenzhandbuch

Cisco

Cisco 8800 Series Bedienungsanleitung

Cisco

Cisco Expansion Module 7914 Bedienungsanleitung

Cisco

Cisco 7962 Bedienungsanleitung

Cisco

Cisco Small Business SPA 301 Bedienungsanleitung

Cisco

Cisco DX650 Bedienungsanleitung

Cisco

Cisco Cisco Unified IP Phone 7960G Bedienungsanleitung

Cisco

Cisco 7905 Bedienungsanleitung

Cisco

Cisco 6851 Bedienungsanleitung

Cisco

Cisco IP Phone Gebrauchsanweisung

Cisco

Cisco 7962 Bedienungsanleitung

Cisco

Cisco 7841 Leitfaden

Cisco

Cisco CM 7 Bedienungsanleitung

Cisco

Cisco Unified 8961 Bedienungsanleitung

Cisco

Cisco 30 VIP Bedienungsanleitung

Cisco

Cisco CP-7942G Kurzanleitung

Cisco

Cisco 7906G - Unified IP Phone VoIP Bedienungsanleitung

Cisco

Cisco 7961G - IP Phone VoIP Bedienungsanleitung

Cisco

Cisco 8800 Series Bedienungsanleitung

Beliebte IP-Telefon Handbücher anderer Marken

Alcatel

Alcatel 4028 Bedienungsanleitung

Polycom

Polycom Polycom VVX 600 Bedienungsanleitung

Polycom

Polycom SoundPoint IP 450 Bedienungsanleitung

Polycom

Polycom SoundPoint IP 650 Bedienungsanleitung

Proximus

Proximus Maestro 3016 IP Bedienungsanleitung

Fanvil

Fanvil X4 Bedienungsanleitung

Snom

Snom 320 Bedienungsanleitung

Yealink

Yealink Yealink SIP-T46G Bedienungsanleitung

Avaya

Avaya 4625SW Bedienungsanleitung

Yealink

Yealink SIP-T52S Bedienungsanleitung

Nortel

Nortel 1140E Bedienungsanleitung

Nexotek

Nexotek NT-P500 Bedienungsanleitung

Avaya

Avaya Integral 5 R3.0 Bedienungsanleitung

GE 28320EE2 - Dect 6.0 InfoLink 2 Bedienungsanleitung

Avaya

Avaya 4600 Series Service-Handbuch

Mitel

Mitel MIVOICE OFFICE 400 6940 SIP Bedienungsanleitung

Nortel

Nortel i2050 Bedienungsanleitung

Fiberme

Fiberme FAP260 Series Bedienungsanleitung