ClearCube A1410 Bedienungsanleitung

Quick Start Guide

ClearCube Technology 8834 Capital of Texas Hwy N Austin, Texas 78759 voice 512 652 3500 www.clearcube.com

The A1410 PC blade uses the Intel® Q965 Express chipset

and supports DDR2 800, DDR2 667, and DDR2 533 MHz

DIMMs for the following memory maximums:

•8 GB system memory—using DDR2 667 or 533

DIMMs

•4 GB system memory—using DDR2 800 DIMMs

For optimum compatibility, always use memory modules

that ClearCube supplies.

Memory Configurations

The A1410 contains four memory sockets that accept 240-

pin DDR2 SDRAM. A1410 memory sockets are color-coded:

•Blue sockets—DIMM 0

•Black sockets—DIMM 1

Memory is organized in two pairs of sockets and can operate

in Interleaved, Asymmetric, or Flex modes depending on the

memory capacity and channel configuration that you use.

•Dual channel (Interleaved) mode—Offers highest

throughput. Dual channel mode is enabled when the

DIMMs installed in both channels are equal in density,

speed, and latency (using DIMMs from the same

manufacturer helps to ensure that you are using matching

DIMMs). If channels A and B contain DIMMs of

different speeds, the slowest speed is used.

•Single channel (Asymmetric) mode—Used when a

single DIMM is installed or when multiple DIMMs are

installed and their memory capacities are unequal. If

channels A and B contain DIMMs of different speeds,

the slowest speed is used.

•Flex mode—Offers multiple areas of dual and single

channel operation over the entire DRAM memory. In

flex mode:

– Memory lowest in the system memory map operates

in dual channel mode

– Memory nearest the 8 GB address space limit, if any,

operates in single channel mode

You must populate both channels to use flex mode.

A1410 Memory Upgrade

2 GB, DIMM 0

1 GB, DIMM 1

Dual Channel Configurations

Flex Mode ConfigurationSingle Channel Configurations

2 GB, DIMM 0 1 GB, DIMM 0 1 GB, DIMM 0

1 GB, DIMM 0

2 GB, DIMM 1

2 GB, DIMM 0 2 GB, DIMM 0

2 GB, DIMM 0

2 GB, DIMM 1

2 GB, DIMM 0

1 GB, DIMM 0

Three DIMMs—Combined memory

capacity of channel A matches memory

capacity of channel B.

Two DIMMs—DIMM 0 (blue socket)

with matching DIMMs.

Four DIMMs—Combined memory capacity of both

channels match. DIMMs match in both channels.

One DIMM—DIMM 0 (blue socket) with

one DIMM. Channel B is unpopulated.

Three DIMMs—Combined memory

capacity of both channels does not match.

Three DIMMs—Half of 2 GB DIMM operates in

dual-channel mode with 1 GB DIMM. Other half of

2 GB DIMM operates in single-channel mode.

ClearCube Technology 8834 Capital of Texas Hwy N Austin, Texas 78759 voice 512 652 3500 www.clearcube.com

G0200096 Rev A

RoHS

WEEE Disposal Guidelines

In the European Union, this electronic

product falls under the European Directive

(2002/96/EC) WEEE. When it reaches the

end of its useful life or is no longer

wanted, it should not be discarded with

conventional waste, but disposed of at an

approved designated recycling and/or

treatment facility.

Laws are different in each country, so

please check with your local authorities for

proper disposal instructions.

For assistance, contact ClearCube at

[email protected].

Removing and Installing Memory

Removing Memory

1. Remove the blade from the chassis.

2. Place the blade on a flat surface. Remove the three 6-32 screws on the top

cover and remove the top cover.

3. Pull the latches on the sides of the memory socket away from the DIMM to

pop the DIMM out of the socket.

4. Hold the DIMM by the edges and remove it from the socket. Store the

DIMM according to the manufacturer’s instructions.

You can now install new memory.

Installing Memory

To ensure memory compatibility, use only ClearCube-supplied memory.

Note: In any memory configuration, DIMM 0 of channel A must be populated.

1. Ensure that memory is removed as described above.

2. Ensure that the latches on the sides of the memory socket are pushed

outward, away from the socket.

3. Hold the DIMM by the edges and gently insert the DIMM into the socket.

Gently press down on the top edge of the DIMM until it snaps into place and

is fully seated. Ensure that the latches are engaged with the cutouts on the

sides of the DIMM.

4. Replace the top cover and replace the three 6-32 screws.

You can now return the blade to the A3100 chassis. See A–Series Setup and

Installation Guide for more information about the A1410 blade.

Email: [email protected]

Web site: support.clearcube.com

Toll-free: (866) 652-3400

Phone: (512) 652-3400

CAUTION: Some blade surfaces might be hot, especially

when the blade has been powered on. Remove and

handle the blade with care.

DIMM

Andere Handbücher für A1410

Andere ClearCube Server Handbücher

ClearCube

ClearCube R1200 Technisches Handbuch

ClearCube

ClearCube CD8620 series Bedienungsanleitung

ClearCube

ClearCube R1350 Bedienungsanleitung

ClearCube

ClearCube R1200 Bedienungsanleitung

ClearCube

ClearCube R2200 Technisches Datenblatt

ClearCube

ClearCube I9422 Zero Client Bedienungsanleitung

ClearCube

ClearCube I8800 Technisches Handbuch

ClearCube

ClearCube R1300 Technisches Handbuch

ClearCube

ClearCube A1010 Bedienungsanleitung

ClearCube

ClearCube A1010 Kurzanleitung

ClearCube

ClearCube A2100 Technisches Handbuch

ClearCube

ClearCube A1010 Bedienungsanleitung

ClearCube

ClearCube I8440 Bedienungsanleitung

ClearCube

ClearCube I9420 Bedienungsanleitung

ClearCube

ClearCube I8020 Bedienungsanleitung

ClearCube

ClearCube A1010 Technisches Handbuch

ClearCube

ClearCube CD7424SFPST Bedienungsanleitung

ClearCube

ClearCube R2200 Bedienungsanleitung

ClearCube

ClearCube SmartVDI-110 Bedienungsanleitung

ClearCube

ClearCube A6108 Bedienungsanleitung

ClearCube

ClearCube MVX Bedienungsanleitung

ClearCube

ClearCube R2200 Betriebsanleitung

ClearCube

ClearCube Thin Client CD8831 Bedienungsanleitung

ClearCube

ClearCube R1300 Bedienungsanleitung

Beliebte Server Handbücher anderer Marken

HP AlphaServer ES47 Bedienungsanleitung

Dell

Dell PowerEdge R410 Bedienungsanleitung

PowerNAS

PowerNAS CMA Bedienungsanleitung

Supero

Supero FatTwin F617R3-FT Bedienungsanleitung

MSI

MSI P1-109N-L70 Bedienungsanleitung

Dell

Dell PowerEdge XE9640 Handbuch

Dell

Dell PS4100 Montageanleitung

EtroVISION

EtroVISION EV3151 Bedienungsanleitung

NEC

NEC Express5800/T110j Bedienungsanleitung

HP ProLiant Gen9 Bedienungsanleitung

Compaq

Compaq ProLiant 3000 Handbuch

Dell

Dell PowerEdge 3YPMN Bedienungsanleitung

iRobo

iRobo IPC2U Bedienungsanleitung

Nortel

Nortel 1000 Con?guration guide Bedienungsanleitung

Asus

Asus AP7500 Bedienungs- und Wartungshandbuch

Avid Technology

Avid Technology AirSpeed 5000 Bedienungsanleitung

HP Integrity rx2600 Installationsanleitung

Milestone

Milestone Husky IVO 350T Bedienungsanleitung