Comnet CNGE2FE24MS Bedienungsanleitung
i
INSTALLATION AND OPERATION MANUAL
CNGE2FE24MS
ENVIRONMENTALLY HARDENED MANAGED ETHERNET SWITCH WITH (24)
10/100TX + (2) 10/100/1000TX RJ45 OR 1000 FX SFP PORTS
V1.02 – October 2009
The ComNet™ CNGE2FE24MS Managed Ethernet Switch provides transmission of (24) 10/100
BASE-TX and (2) 10/100/1000TX or 1000FX combo ports. Unlike most Ethernet switches, these
environmentally hardened units are designed for deployment in difficult operating environments,
and are available for use with either conventional CAT-5e copper or optical transmission media.
The 24 electrical ports support the 10/100 Mbps Ethernet IEEE 802.3 protocol, and auto-
negotiating and auto-MDI/MDIX features are provided for simplicity and ease of installation. 2 ports
are 10/100/1000 configurable for copper or fiber media for use with multimode or single mode optical
fiber, selected by optional SFP modules. These network managed layer 2 switches are optically
(1000 BASE-FX) and electrically compatible with any IEEE 802.3 compliant Ethernet devices. Plug-
and-play design ensures ease of installation, and no electrical or optical adjustments are ever
required. The CNGE2FE24MS incorporates LED indicators for monitoring the operating status of the
managed switch and network. These units are rack mountable.
i
FCC Warning
This Equipment has been tested and found to comply with the limits for a
Class-A digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy. It may cause harmful interference to radio communications
if this equipment is not installed and used in accordance with the instructions.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CE Mark Warning
This is a Class-A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.
ii
Content
FCC Warning ............................................................... i!
CE Mark Warning ........................................................ i!
Content ....................................................................... ii!
Introduction ................................................................ 1!
Hardware Features .................................................. 1!
Software Feature...................................................... 4!
Package Contents.................................................... 7!
Hardware Description................................................ 8!
Physical Dimension.................................................. 8!
Front Panel............................................................... 9!
Rear Panel ............................................................... 9!
LED Indicators........................................................ 11!
Cabling ................................................................... 12!
Desktop Installation ................................................ 16!
Attaching Rubber Feet......................................................16!
Rack-mounted Installation...................................... 16!
Network Application ................................................ 18!
X-Ring Application.................................................. 19!
Couple Ring Application......................................... 20!
Dual Homing Application........................................ 21!
Console Management.............................................. 22!
Connecting to the Console Port ............................. 22!
Login in the Console Interface ............................... 22!
CLI Management.................................................... 23!
iii
Web-Based Management ........................................ 26!
About Web-based Management ............................ 26!
Preparing for Web Management ............................ 26!
System Login ......................................................... 27!
System ...................................................................... 28!
System Information ................................................ 28!
IP Configuration ..................................................... 29!
DHCP Server – System configuration .................... 31!
DHCP Server – Client Entries ................................ 32!
DHCP Server - Port and IP Bindings ..................... 33!
TFTP - Update Firmware ....................................... 34!
TFTP – Restore Configuration ............................... 34!
TFTP - Backup Configuration.................................35!
System Event Log – Syslog Configuration............. 35!
System Event Log - SMTP Configuration .............. 37!
System Event Log - Event Configuration ............... 39!
Fault Relay Alarm................................................... 41!
SNTP Configuration ............................................... 42!
IP Security.............................................................. 44!
User Authentication ................................................ 46!
Advanced Configuration—Broadcast Storm Filter . 46!
Advanced Configuration—Aging Time ................... 47!
Advanced Configuration—Jumbo Frame ............... 48!
1000TX Cable Length ............................................ 49!
iv
Port............................................................................ 50!
Port Statistics ......................................................... 50!
Port Counters ......................................................... 51!
Port Control ............................................................ 54!
Port Trunk .............................................................. 56!
Aggregator setting ............................................................56!
Aggregator Information .....................................................58!
State Activity .....................................................................59!
Port Mirroring ......................................................... 61!
Rate Limiting .......................................................... 62!
VLAN configuration ................................................ 63!
VLAN configuration - Port-based VLAN............................63!
802.1Q VLAN....................................................................67!
Rapid Spanning Tree ............................................. 72!
RSTP - System Configuration...........................................73!
RSTP—Port Configuration ..................................... 75!
SNMP Configuration .............................................. 77!
System Configuration .......................................................77!
Trap Configuration ................................................. 79!
SNMPV3 Configuration.....................................................80!
QoS Configuration.................................................. 83!
QoS Policy and Priority Type............................................83!
v
IGMP Configuration................................................ 85!
LLDP Configuration ................................................ 86!
X-Ring .................................................................... 87!
Security .................................................................. 89!
802.1X/Radius Configuration............................................89!
MAC Address Table..........................................................92!
Access Control List ................................................ 97!
Factory Default....................................................... 98!
Save Configuration................................................. 98!
System Reboot....................................................... 98!
Troubleshooting ...................................................... 99!
Incorrect connections ............................................. 99!
Diagnosing LED Indicators................................... 100!
Appendix A—RJ45 Pin Assignment .................... 101!
10 /100BASE-TX Pin outs ..............................................101!
10/100Base-TX Cable Schematic...................................102!
10/100/1000Base-TX Pin outs........................................103!
10/100/1000Base-TX Cable Schematic..........................103!
Appendix B—Command Sets ............................... 105!
Commands Set List ........................................................105!
System Commands Set ..................................................105!
Port Commands Set .......................................................109!
Trunk Commands Set.....................................................111!
vi
VLAN Commands Set.....................................................113!
Spanning Tree Commands Set ......................................115!
QOS Commands Set ......................................................118!
IGMP Commands Set.....................................................118!
Mac / Filter Table Commands Set ..................................119!
SNMP Commands Set....................................................121!
Port Mirroring Commands Set ........................................124!
802.1x Commands Set ...................................................124!
TFTP Commands Set .....................................................127!
SystemLog, SMTP and Event Commands Set...............128!
SNTP Commands Set ....................................................130!
X-Ring Commands Set ...................................................132!
LLDP Command Set.......................................................133!
Access Control List Command Set .................................133!
1
Introduction
The 24 10/100TX + 2 10/100/1000T/SFP Combo Managed Industrial Switch is a cost-
effective solution and meets the high reliability requirements demanded by industrial
applications. Using fiber port can extend the connection distance that increases the network
elasticity and performance.
Hardware Features
IEEE Standard
IEEE 802.3 10Base-T Ethernet
IEEE 802.3u 100Base-TX / 100Base-FX
IEEE802.3z Gigabit fiber
IEEE802.3ab 1000Base-T
IEEE802.3x Flow Control and Back Pressure
IEEE802.3ad Port trunk with LACP
IEEE802.1d Spanning Tree/ IEEE802.1w Rapid Spanning
Tree
IEEE802.1p Class of Service
IEEE802.1Q VLAN Tag
IEEE 802.1x User Authentication (Radius)
IEEE802.1ab LLDP
Switch
Architecture
Back-plane (Switching Fabric): 8.8Gbps
Packet throughput ability (Full-Duplex):
13.1Mpps@64bytes
Transfer Rate
14,880 pps for 10Base-T Ethernet port
148,800 pps for 100Base-TX/FX Fast Ethernet port
1,488,000 pps for Gigabit Fiber Ethernet port
2
Packet Buffer
4Mbits
MAC address
8K MAC address table
Flash ROM
4Mbytes
DRAM
32Mbytes
Jumbo Frame
9022bytes (for Gigabit Ports)
Connector
RS-232 console : Female DB-9
10/100TX: 24 x RJ45
10/100/1000T/ Mini-GBIC Combo: 2 x RJ45 + 2 x SFP
sockets
LED
DC-PWR1, DC-PWR2: Green, Fault: Red
Link/Activity (P1 ~ P26): Green
FDX (P1 ~ P24): Amber
FDX/COL (P25, P26): Amber
Network Cable
10Base-T: 2-pair UTP/STP Cat. 3, 4, 5, 5e cable
EIA/TIA-568 100-ohm (100m)
100Base-TX: 2-pair UTP/STP Cat. 5/5e cable
EIA/TIA-568 100-ohm (100m)
1000Base-TX: 2-pair UTP/STP Cat. 5e cable
EIA/TIA-568 100-ohm (100m)
Power Supply
DC 12V ~ 48V – A readily accessible disconnect device
as part of the building installation shall be incorporated
into the fixed wiring. Moreover, The disconnect device
(appropriate circuit breaker) must be included in the
ungrounded supply conductor.
3
Redundant Power
Supply
DC 12V ~ 48V
Power
Consumption
16.2 Watts
Operating Temp.
-40oC to 75oC
Operation
Humidity
5% to 95% (Non-condensing)
Storage
Temperature
-40oC to 85oC
Case Dimension
440mm (W) x 280mm (D) x 44mm (H)
Installation
19” Rack mount
EMI
FCC Class A, CE EN61000-4-2 (ESD),
CE EN61000-4-3 (RS), CE EN-61000-4-4 (EFT), CE
EN61000-4-5 (Surge), CE EN61000-4-6 (CS), CE
EN61000-4-8, CE EN61000-4-12,
CE EN61000-6-2, CE EN61000-6-4, C-Tick
Safety
UL, cUL, CE/EN60950-1
Stability testing
IEC60068-2-32 (Free fall), IEC60068-2-27 (Shock),
IEC60068-2-6 (Vibration)
Inhaltsverzeichnis
Andere Comnet Netzwerk-Router Handbücher
Comnet
Comnet CWGE2FE24MODMS Bedienungsanleitung
Comnet
Comnet CLFE4+1SMS[POE](C Bedienungsanleitung
Comnet
Comnet CWFE8TX8MS Bedienungsanleitung
Comnet
Comnet CWFE2COAX Betriebsanleitung
Comnet
Comnet CNGE28FX4TX24MS2 Betriebsanleitung
Comnet
Comnet RLXE4GE24MODMS Bedienungsanleitung
Comnet
Comnet CWGE24MS2 Bedienungsanleitung
Comnet
Comnet CLFE4US1TPC Bedienungsanleitung
Comnet
Comnet CNFE4+1SMSM2 Bedienungsanleitung
Comnet
Comnet CNFE10MS Bedienungsanleitung
Comnet
Comnet CNGE5MS Bedienungsanleitung
Comnet
Comnet CNGE3FE7MS4 Bedienungsanleitung
Comnet
Comnet CNGE24FX12TX12MSPOE Bedienungsanleitung
Comnet
Comnet CNGE8US Series Bedienungsanleitung
Comnet
Comnet CWFE8MS/DIN Bedienungsanleitung
Comnet
Comnet NW7/M Bedienungsanleitung
Comnet
Comnet RLXE4GE24MODMS Bedienungsanleitung
Comnet
Comnet netwave NW3 Einrichtungshandbuch
Comnet
Comnet CNGE3FE8MS Bedienungsanleitung
Comnet
Comnet CNGE3FE8MSPOE Bedienungsanleitung
Beliebte Netzwerk-Router Handbücher anderer Marken
NETGEAR
NETGEAR FS526T - Switch Bedienungsanleitung
Korenix
Korenix JetNet 5710G Series Bedienungsanleitung
Automated Logic
Automated Logic ZN551 Betriebsanleitung
Cisco
Cisco ASR 1000 Series Bedienerhandbuch
EnGenius
EnGenius ESR-9710 Bedienungsanleitung
Cisco
Cisco 805 Series Bedienungs- und Sicherheitshinweise