Cornelius 6 Flavor Leitfaden

Dieses Handbuch passt für folgende Modelle

1

Inhaltsverzeichnis

Andere Cornelius Getränkespender Handbücher

Cornelius

Cornelius MILLENNIUM MJ30-4 PB Handbuch

Cornelius

Cornelius Enduro-200/250 Bedienungsanleitung

Cornelius

Cornelius VANGUARD 245 Bedienungsanleitung

Cornelius

Cornelius FCB VIPER Bedienungsanleitung

Cornelius

Cornelius IDC PRO 255 Bedienungsanleitung

Cornelius

Cornelius Quantum 45200003 Bedienungsanleitung

Cornelius

Cornelius Impulse Juice Dispenser 851000109 Einrichtungshandbuch

Cornelius

Cornelius Drop-In Post-Mix Dispenser 2323 Universal Bedienungsanleitung

Cornelius

Cornelius Liquid Base Beverage Dispenser Betriebsanleitung

Cornelius

Cornelius ENDURO 250 Bedienungsanleitung

Cornelius

Cornelius 326142000 Bedienungsanleitung

Cornelius

Cornelius ABS 2.0 Bedienungsanleitung

Cornelius

Cornelius ED 300 BN Bedienungsanleitung

Cornelius

Cornelius ED-250 Bedienungsanleitung

Cornelius

Cornelius remcor DB275--BCP Bedienungsanleitung

Cornelius

Cornelius Flavorfusion TP01070 Installationsanleitung

Cornelius

Cornelius Enduro ED-250 BCP Bedienungsanleitung

Cornelius

Cornelius Tea Tower Bedienungsanleitung

Cornelius

Cornelius ED 300 BC Bedienungsanleitung

Cornelius

Cornelius TEA URN Bedienungsanleitung

Cornelius

Cornelius Profile 150 Bedienungsanleitung

Cornelius

Cornelius IDC Pro Installations- und Benutzerhandbuch

Cornelius

Cornelius ED 300 BC Bedienungsanleitung

Cornelius

Cornelius VANTAGE Bedienungsanleitung

Beliebte Getränkespender Handbücher anderer Marken

PEGAS

PEGAS Evolution Bedienungsanleitung

Ugolini

Ugolini MT micro Bedienungsanleitung

Bunn

Bunn SLCA-7 Montageanleitung

Gekkeikan

Gekkeikan Sake Machine Bedienungsanleitung

Olympia

Olympia DH709 Bedienungsanleitung

Marco

Marco ECOSMART PB10 Bedienungsanleitung

Marvel

Marvel ML24BN Series Handbuch

Cecilware

Cecilware 2K-GB-LD Handbuch

Sure Vend

Sure Vend 673 Bedienungsanleitung

Nostalgia Electrics

Nostalgia Electrics KEG7000SS Bedienungsanleitung

Bunn

Bunn LCR-3 HV Fehlerbehebungshandbuch

Servend

Servend SV-200 Bedienungsanleitung

EdgeStar

EdgeStar VBR440 Bedienungsanleitung

CDS AUTOMATEN

CDS AUTOMATEN ML-16C2-C Bedienungsanleitung

Siemens

Siemens GA 3000 Gebrauchsanweisung

Selbach

Selbach Fruit Juice dispenser Bedienungsanleitung

Taylor

Taylor C302NP Bedienungsanleitung

Vinotemp

Vinotemp VT-WINEDISP2 Bedienungsanleitung

Mellennium II - Water Inlet Replacement

© 2002, IMI Cornelius Inc. - 1 - Publication Number: 620919561

MILLENNIUM II

WATER INLET REPLACEMENT

This instruction sheet details the procedure for replacing the water inlet fitting at the valve.

All necessary material to make the change, along with this bulletin, is included in a kit. The

kit contents are listed below. Note that this kit will work for all models, regardless of volt-

age.

Procedure

1. Turn off the water supply to the dispenser. Disconnect power from the dispenser.

Remove the top panel and merchandiser. Note that there are two harnesses from the top

panel and one from the merchandiser that must be disconnected. Make sure to mark the

harnesses so as not to incorrectly wire them during re-assembly. Next remove both side

panels by sliding them towards the front of the dispenser.

2. Remove the hitch pins that secure the refrigeration deck to the waterbath housing.

Carefully lift the refrigeration deck out of the waterbath to access the manifold.

3. Remove the water inlet fittings from the back of the valve (Figure 1). These are the fit-

tings attached to the 3-inch piece of tubing that runs from the manifold. Also remove this

tubing from the manifold. Discard both the fitting and the tubing for all valves.

4. If not already done, install the new o-ring to the new fitting. Attach this fitting to a 3-inch

piece of tubing with a clamp, and then attach this assembly to the manifold (clamps, tubing

and fittings supplied in kit). Install the fitting into the valve. Repeat for remaining valves.

5. Turn on the water supply to the dispenser and check for leaks. If any leaks are discov-

ered, turn off supply and re-install the fitting into the valve.

6. Install and secure the refrigeration deck into the waterbath, and install the side panels,

top panel and merchandiser. Making sure to properly connect the harnesses and interlock

all cladding pieces. Do not force any panels together. During proper assembly, the panels

will slide together easily and remain interlocked. Connect power to the dispenser.

Millennium II - Kit No. 629087501

Fitting (Qty. 6) 77050300

O-Ring (Qty. 6) 31525003

Clamp (Qty. 12) 40502

Tubing (Qty. 18 in.) 50299

Instruction Sheet 620919561

FIGURE 1

Release Date: February 2, 2002 Revision: A

Mellennium II - Water Inlet Replacement

Publication Number: 620919561 - 2 - © 2002, IMI Cornelius Inc.