Crux DKGM-49 Bedienungsanleitung

- Retains factory features in select GM LAN 29 Bit vehicles while functioning with an aftermarket radio.

- Pre-programmed to retain factory Steering Wheel Controls.

- iPhone Voice Recognition (VR) feature from SWC on Kenwood, Pioneer, Alpine and JVC radios.

- Supports Pick Up/End Call, Pick Up and Toggle between 1st and 2nd Incoming call, AVRCP Track, Seek.

- Supports Bose, non-Bose and Y-91 audio systems.

- Provides Factory Rear Seat Entertainment Activation. Requires Cable #CRUX2333A

(sold separately).

- Retains factory front and back park assist system.

- Retains chime functions.

- EIA color coded wiring for easy installation.

1. *NOT compatible with 2012-Up SUVs/Trucks that are equipped with factory-installed Navigation

radios.

2. **NOT compatible with Express and Savana vans that are powered by a diesel engine.

3. Supports Rear Entertainment System with special order harness #CJA2333A (sold separately).

4. DOES NOT support ONSTAR.

GM-49 Module

GM-49 Harness

SWC Cables

Antenna Adaptor

CRUX2543

Dash Kit

Rev.032917

1 / 6

GMC

2007-2015 Acadia

2008-2013 Savana**

2007-2013 Sierra 1500-3500

Pickup*

2007-2014 Yukon*

HUMMER

2008-2009 H2

PONTIAC

2007-2009 Torrent

SATURN

2007-2010 Outlook

2008-2009 Vue

SUZUKI

2007-2008 XL7

BUICK

2008-2015 Enclave

2006-2011 Lucerne

CADILLAC

2006-2011 DTS

2007-2014 Escalade

2007-2009 SRX

CHEVROLET

2007-2013 Avalanche*

2007-2008 Equinox

2008-2013 Express Van**

2006-2013 Impala / Impala SS

2006-2007 Monte Carlo

2007-2013 Silverado 1500-3500

Pickup*

2007-2014 Suburban*

2007-2014 Tahoe*

2009-2015 Traverse

SETTING THE AFTERMARKET RADIO BRAND

With the key in the off position, set the DIP switches to the corresponding radio listed below.

3.5MM SWC CABLE

The DKGM-49 Module allows for both types of connections:

OPTION A is used for ALPINE, CLARION, JVC, and KENWOOD units (Blue/Yellow wire is attached)

OPTION B is used for BOSS, DUAL, FAHRENHEIT, JENSEN, POWER ACOUSTIK, PIONEER, SONY and

SOUND STREAM units.

NOTE: Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used.

2 / 6

Rev.032917

If the vehicle is equipped with a Bose system, the DKGM-49 module has a built-in Bose adaptor that allows the

proper audio input gain from the aftermarket radio to the Bose amplifier. To use this feature, plug in the male 8-pin

connector on the harness to the GRAY female 8-pin connector on the DKGM-49 module. The module is also labeled

“Bose” and “Non Bose” to avoid confusion. (see picture below)

If the vehicle is NOT equipped with a Bose system, plug in the male 8-pin connector to the BLACK female 8-pin on

the GM-49 module.

The DKGM-49 module has a potentiometer to adjust the chime volume. It is set at half way by default. To adjust

the volume, simply use a suitable screw driver and turn the potentiometer clockwise to increase the volume and

counter-clockwise to decrease the volume.

You can retain use of the factory backup camera by using the CRUX2543 harness provided in the kit. See below for

connection instructions. (Note: Loose wires may not be needed in the installation.)

3 / 6

Rev.032917

BOSE

Connection

Non-BOSE

Connection

Chime

Volume

Adjustment

A double DIN radio replacement dash kit is included in the kit to make the installation quick and easy. You have the

option of installing a Double DIN or two Single DIN radios. The DKGM-49 kit includes:

(1) Main trim ring

(1) Left ISO mounting bracket

(1) Right ISO mounting bracket

Installation:

NOTE: Suzuki XL7 trim top corners of radio housing. See diagram A.

Diagram A

Before installation:

1. Locate the main trim ring.

2. Locate the left and right mounting brackets.

3. Slide the appropriate mounting bracket into the trim ring, aligning the holes in the trim ring to the clips on the bracket.

(See Diagram B)

4.For two Single DIN radio installation, slide the stacked ISO DIN unit into the trim ring bracket assembly and secure the unit to

the kit using the screws supplied with the radio. (See Diagram C)

Diagram B

Diagram C

4 / 6

Rev.032917

STEERING WHEEL CONTROL BUTTON FUNCTIONS

SWC Button

SHORT PRESS

LONG PRESS

PIONEER

VOL +

VOL -

Arrow Up ▲

Arrow Down ▼

SRCE

►I

Voice

Step Increment

Step Decrement

Preset Up

Preset Down

Source

Tune

Pick Up Call

Continuous VOL +

Continuous VOL -

Seek Up

End Call

Power On/Off

Mute On/Off

Activate VR/Deactivate VR

SWC Button

SHORT PRESS

LONG PRESS

ALPINE

VOL +

VOL -

Arrow Up ▲

Arrow Down ▼

SRCE

►I

Voice

*NOTE:

Step Increment

Step Decrement

Seek Up

Seek Down

Source

Preset

Pick Up Call

To Deactivate VR = Say “CANCEL”

Continuous VOL +

Continuous VOL –

None

End Call

None

ATT On/Off

Activate VR*/Deactivate VR*

BT Mode Active:

Voice = Toggle between 1st and 2nd Call

SWC Button

SHORT PRESS

LONG PRESS

CLARION

VOL +

VOL -

Arrow Up ▲

Arrow Down ▼

SRCE

►I

Voice

Step Increment

Step Decrement

Preset Up

Preset

Source

None

Pick Up Call

Continuous VOL +

Continuous VOL –

Seek Up

End Call

Power On/Off

Mute On/Off

SWC Button

SHORT PRESS

LONG PRESS

JVC

VOL +

VOL -

Arrow Up ▲

Arrow Down ▼

SRCE

►I

Voice

NOTE:

Step Increment

Step Decrement

Seek Up

Seek Down

Source

Preset

Pick Up Call

To Deactivate VR = Say “CANCEL”

Continuous VOL +

Continuous VOL –

M-Seek Up

End Call

None

Mute On/Off

Activate VR

5 / 6

Rev.032917

SWC Button

SHORT PRESS

LONG PRESS

KENWOOD

VOL +

VOL -

Arrow Up ▲

Arrow Down ▼

SRCE

►I

Voice

NOTE:

Step Increment

Step Decrement

Seek Up

Seek Down

Source

Preset

Pick Up Call / Call History On/Off

To Deactivate VR = Say “CANCEL”

Continuous VOL +

Continuous VOL -

None

End Call / Deactivate VR

None

ATT On/Off

Activate VR

BOSS Radio SWC Programming

SWC Radio Wiring connection

SWC Key1 (Brown-wire) connect to Female 3.5 mm Jack - Brown wire

SWC Key2 (White-wire) connect to Female 3.5 mm Jack - Brown/White wire

SWC GND (Black-Wire) connect to Radio Negative wire (Black)

Programming the Radio

Press: [SETTING] > [STEER] > [RESET] > [High Z]

Press the Steering Wheel Control (SWC) buttons set the values as listed below:

Vol –[ 4.07]

Vol + [ 3.66]

Seek –[ 3.37]

Seek + [ 2.98]

Mode [1.39]

OFF Hook [ 0.00]

The Value in the bracket [X.XX] will vary and will be used as parameter for each assigned function.

Press: [Assign] > [4.07] > [Vol-], then the [4.07] will be replaced with [ Vol-]

With [Assign] highlighted:

Press: [3.66] > [Vol+], then the [3.66] will be replaced with [Vol+]

Press: [3.37] > [Seek-], then the [3.37] will be replaced with [Seek-]

Press: [2.98] > [Seek+], then the [2.98] will be replaced with [Seek+]

Press: [1.39] > [Mode], then the [1.39] will be replaced with [Mode]

Press: [0.00] > [Call], then the [0.00] will be replaced with [Call]

Press: [Enter] for Save the setting and Exit

rev.032717

7 / 7

6 / 6

Rev.032917

Inhaltsverzeichnis

Andere Crux Autozubehör Handbücher

Crux

Crux RVCCH-75B Bedienungsanleitung

Crux

Crux RVCCH-75W Bedienungsanleitung

Crux

Crux VIMGM-94M Bedienungsanleitung

Crux

Crux VIMBM-86B Bedienungsanleitung

Crux

Crux ACPAD-01 Bedienungsanleitung

Crux

Crux VRFAD-81C Bedienungsanleitung

Crux

Crux RVCCH-75 Bedienungsanleitung

Crux

Crux RVCCH-75 Bedienungsanleitung

Crux

Crux AVIGM-04S Bedienungsanleitung

Crux

Crux MRVFD-79Q Bedienungsanleitung

Crux

Crux BEECR-35P Bedienungsanleitung

Crux

Crux Sightline MRVBM-77Q Bedienungsanleitung

Crux

Crux RVCCH-75 Bedienungsanleitung

Crux

Crux Sightline PCM-3 Bedienungsanleitung

Crux

Crux ACPBM-77X Bedienungsanleitung

Crux

Crux RVCMZ-72D Bedienungsanleitung

Crux

Crux Sightline RVCVW-73 Bedienungsanleitung

Crux

Crux Sightline VIMGM-94 Bedienungsanleitung

Crux

Crux Sightline RVCAD-81 Bedienungsanleitung

Crux

Crux Sightline RVCCH-75E Bedienungsanleitung

Crux

Crux Sightline VIMPR-90P Bedienungsanleitung

Crux

Crux SWRTY-61N Bedienungsanleitung

Crux

Crux RVCCH-75D Bedienungsanleitung

Crux

Crux DKGM-51 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Prorack

Prorack K1163 Bedienungsanleitung