Crux Sightline VIMPR-90P Bedienungsanleitung

PORSCHE

2017 –2018 911

2017 –2018 718 Boxster / Cayman

2017 –2018 Cayenne

2017 –2018 Macan

2017 –2018 Panamera

- Retains functionality of Factory-installed Navigation System for passenger access at any time.

- Plug and Play Installation.

- Compatible with Porsche PCM4 and PCM4.1 Navigation radios.

- On some vehicles, the navigation will not work while the video-in-motion function is active. This

can only be detected by a test drive. Please see notes on page 3.

1 / 3

rev.121818

1. Remove the factory radio from the dashboard.

2. Remove the factory connectors from behind the factory radio.

3. Mate the T-Harness connections to the factory harness and radio. (Make sure all connectors are

properly seated into the interface and into the radio.)

4. Connect the 8-pin Molex connector from the T-harness to the VIMPR-90P module.

5. Set the DIP switches according to the table below.

6. Test the interface and re-install the radio into the dash.

Setting the DIP Switches of the VIMPR-90P

Porsche

Dip 1

Dip 2

Dip 3

Dip 4

Dip 5

Dip 6

Video-in-motion permanent

OFF

Video-in-motion selective*

OFF

*With DIP#1 set to OFF the included green wire is used to activate the video-in-motion function.

2 / 3

rev.121818

Note: DIP switch functions of the VIMPR-90P

Dip 1 –Activate Video In Motion

Dip 2 –no function

Dip 3 –no function

Dip 4 –no function

Dip 5 –CAN-bus termination resistor on the vehicle side

Dip 6 –CAN-bus termination resistor on the head-unit side

NOTE: Vehicles with affected navigation performance

On some vehicles, the navigation performance is affected as long as the video-in-motion function is

activated. This can only be detected by a test drive and with DIP# 1 set to ON.

If the navigation performance is affected you have to set DIP#1 to OFF. As long as the video-in-motion

function is activated, the navigation will NOT work. The green wire on the T-harness can be used to

activate the video-in-motion function (Video-in-motion selective) by connecting a switch (not included)

between the GREEN wire and +12V ACC.

Cable colour

Assignment

●Red

+12V Constant Pin 18

●Brown

Ground Pin 17

●●Orange/Violet

CAN HIGH Pin 6

●●Orange/Brown

CAN LOW Pin 12

ACTIVATING AND DEACTIVATING THE VIM FEATURE

The video-in-motion can be activated and deactivated either by setting DIP# 1 to ON (permanent VIM)

or by the connecting a switch (not included) between the GREEN wire and +12V (selective VIM).

Video-in-motion permanent

With DIP#1 set to ON, the video-in-motion function is activated permanently without disturbing the

navigation performance.

Video-in-motion selective

With DIP#1 set to OFF, the GREEN wire is used to activate the video-in-motion function.

Connect a switch between the GREEN wire and +12V ACC.

●+12V = VIM is activated

●0V = VIM is deactivated

3 / 3

rev.121818

Inhaltsverzeichnis

Andere Crux Autozubehör Handbücher

Crux

Crux DKGM-51 Bedienungsanleitung

Crux

Crux CFD-03E Bedienungsanleitung

Crux

Crux BEECR-35 Bedienungsanleitung

Crux

Crux RVCVL-82S Bedienungsanleitung

Crux

Crux VIMGM-94M Bedienungsanleitung

Crux

Crux RVCCH-75 Bedienungsanleitung

Crux

Crux BEECR-35C Bedienungsanleitung

Crux

Crux RVCTY-71L Bedienungsanleitung

Crux

Crux RVCCH-75WM Bedienungsanleitung

Crux

Crux BEECR-35D Bedienungsanleitung

Crux

Crux SWRGM-49L Bedienungsanleitung

Crux

Crux Sightline RVCAD-81B Bedienungsanleitung

Crux

Crux DKGM-49 Bedienungsanleitung

Crux

Crux Sightline RVCVW-73 Bedienungsanleitung

Crux

Crux RVCCH-75W Bedienungsanleitung

Crux

Crux BEELINE Series Bedienungsanleitung

Crux

Crux Logic ACPBM-77Y Bedienungsanleitung

Crux

Crux Sightline VIMGM-94 Bedienungsanleitung

Crux

Crux MRVFD-79Q Bedienungsanleitung

Crux

Crux BEEBG-25 Bedienungsanleitung

Crux

Crux ACPAD-01W Bedienungsanleitung

Crux

Crux SOOCR-26 Bedienungsanleitung

Crux

Crux DKGM-51 Bedienungsanleitung

Crux

Crux SOOGM-15 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Renault

Renault 77 11 423 180 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung