Cycleboard ELITE Bedienungsanleitung
CYCLEBOARD | ELITE
Important Instructions and Warnings
Read this manual completely before riding your CycleBoard.
OWNER’S MANUAL
PATENTED
cycleboard.com
TM
Page 2
TABLE OF CONTENTS:
Introduction 3
Cycleboard Major Parts And Diagram 4
Specifications 5
Folding / Unfolding Handle 6
Setup 7
Safety Instructions 8
Safety And Warning Labels 11
Operating Procedures 12
Throttle / LCD Display 15
Braking 19
Steering 20
Pre-ride Checklist 21
Battery And Charger Use And Care 23
Maintenance and General Troubleshooting 26
FAQ 30
Note: Manual illustrations are for demonstration purposes only.
Illustrations may not reflect exact appearance of actual product.
Specifications are subject to change without notice.
For assistance contact www.cycleboard.com
Please have your Serial Number ready before contacting CycleBoard for warranty assistance and/or replacement parts. It is located
on the bottom of your CycleBoard.
Page 3
INTRODUCTION
READ AND UNDERSTAND THIS ENTIRE MANUAL BEFORE USING OR ALLOWING OTHERS TO USE THIS PRODUCT
Congratulations on the purchase of your new CycleBoard!
Read this manual thoroughly! Pay special attention to the safety and product warnings before you start riding your CycleBoard to help
ensure that you ride safely and your CycleBoard electric vehicle has a long service life.
UPDATES TO WARNINGS AND OWNERS MANUAL
We continually update our warnings, safety and product information on our website so please make sure to check it periodically at
www.cycleboard.com
!
!
Page 4
Handlebar
Brake
Throttle
Bell
Height Adjustment
Battery Charger
Self-Centering Springs
Serial Number
Steering Mechanism
Charging Port Deck / Standing Area
Caliper
Brake Disc
Rear Wheel & Hub Motor
Front Wheel
Folding Handle Mechanism
Battery and Motor Controller
Compartment
CYCLEBOARD MAJOR PARTS AND DIAGRAM
Page 5
SPECIFICATIONS
CYCLEBOARD
Weight: 44 lbs
Max Capacity: 250 lbs
Max Speed: 20 MPH / 32 KMH
Full Charge Distance: Up to 15 Miles (5.8Ah Battery) / Up to 25
Miles (9.6Ah Battery)
Climbing Grade: up to 20° Incline
MOTOR
48V 450W Brushless, Gearless rear hub motor
Hall Sensors
BATTERY
Lithium Ion (LG Cells) – 48V 5.8Ah or 9.6Ah
CHARGER
2A charger – Input Voltage: 110 – 240V
Charging time: 5.8Ah battery = 3 hours / 9.6Ah battery = 4.5 hours
Plug charger into wall outlet and CycleBoard charging port
BRAKES
Vented rear disc brake
TIRES
Front pneumatic. Rear semi-pneumatic
WARNING: DO NOT USE NON-CYCLEBOARD PARTS
WITH YOUR CYCLEBOARD ELECTRIC VEHICLE. The
vehicle has been built to certain design specifications. Certain
aftermarket parts may or may not be compatible and may void
your warranty.
Note: The CycleBoard must be moving at 2-3 mph while applying
the throttle to engage motor.
Need Help? Visit our website for replacement parts and product
support at www.cycleboard.com
Make sure to register your CycleBoard on our website for access
to replacement parts and to activate your warranty. The serial
number is located on the underside of your CycleBoard.
!
Page 6
Note: If the release tab is dicult to press, gently shift the handle forwards and backwards while pressing the release tab.
FOLDING / UNFOLDING HANDLE
The CycleBoard comes with the handle folded down in the shipping box.
TO UNFOLD:
TO FOLD:
Reverse the steps above:
1. Loosen the handle lever by rotating it counter clockwise.
2. Press the release tab downward.
3. Lower the handle until it locks in the lowered position
4. Once the handle locks in the lowered position, tighten the handle lever on the left side by rotating it clockwise until tight
Pick up the CycleBoard by
the handle to lift out of box
Press release tab downward
to raise handle to the upright
position
After handle locks in place,
tighten the handle lever
on the left side by rotating it
clockwise.
Handle Lever
Loosen
Tighten
Release Tab
Page 7
SETUP
PACKAGE CONTENTS:
CycleBoard Electric Vehicle
Battery Charger
2 Allen wrenches
Quick Start Guide
INSTRUCTIONS:
Your CycleBoard has been pre-assembled and only requires a few steps to prepare it to ride:
1. After opening the box, inspect the contents for any damage that may have occurred during shipping.
If anything has been damaged, contact us for replacement or repair.
2. The Hand brake lever and throttle (Fig 1 and Fig 2) are adjusted downward for shipping. Adjust the
throttle and hand brake lever to your desired location, then tighten the screws using the 2 included
Allen wrenches.
3. Using the height adjustment handle and thumb screw (Fig 3), adjust the handle bars to your desired
height. Fully tighten the thumb screw and clamp so that the handlebars cannot rotate while riding.
(Note: It should be very tight)
Note: The maximum handle height will be limited by the brake cable, do not attempt to force the handle
higher than the brake cable will allow. When lowering the handle height, pull the excess brake cable and
wiring out to prevent it from crimping inside the upper handle.
4. Fully charge your battery before riding for the first time. The light on your charger will change from
red to green when the battery is fully charged.
5. Check the hand brake on the left handlebar to ensure it is functioning properly. If any adjustment is
required, use the adjustment knob (Fig 4) where the brake cable connects to the hand brake lever.
6. The self centering springs in the front of the CycleBoard may initially make squeaking and clicking
sounds when steering but will stop after a short break in period. Shown in Fig 5.
FIG 3. HEIGHT ADJUSTMENT
FIG 4. ADJUSTMENT KNOB
FIG 5. SPRINGS
FIG 1. HAND BRAKE LEVER FIG 2. THROTTLE
Page 8
SAFETY INSTRUCTIONS
BE SURE TO READ AND UNDERSTAND THE SAFETY AND OPERATIONS SECTIONS OF THIS MANUAL. FAILURE TO USE COMMON SENSE AND
HEED ALL WARNINGS AND INSTRUCTIONS INCREASES RISK OF SERIOUS INJURY OR DEATH. USE WITH APPROPRIATE CAUTION AND SERIOUS
ATTENTION TO SAFE OPERATION.
The CycleBoard should be maintained and repaired in accordance with the manufacturer’s specifications, using only the
manufacturer’s authorized replacement parts, and should not be modified from the manufacturer’s original design and configuration.
ACCEPTABLE RIDING PRACTICES AND CONDITIONS
Always check and obey any local laws or regulations, which may aect the locations where the CycleBoard may be used. Do not
turn on or activate the throttle unless you are standing on the CycleBoard with both hands on the handlebars and in a safe, outdoor
environment suitable for riding. The normal powered top speed of the CycleBoard will be approximately 20 mph/32km/h, which can
be aected by conditions such as rider weight, inclines, tire inflation and battery charge level. Avoid excessive speeds that can be
associated with downhill rides. Do not do “wheelies” or pull up on the handlebars when riding, as this could cause damage to the
CycleBoard or injury to the rider. Do not touch the brakes or motor of your CycleBoard when in use or soon after riding as these parts
can become very hot. Watch out for potential obstacles that could catch your wheel or force you to swerve suddenly or lose control.
Be careful to avoid vehicles, pedestrians, skateboards, scooters, bikes, other moving obstacles, or animals who may enter your path,
and respect the rights and property of others. The CycleBoard is intended for use on flat surfaces such as pavement or level ground.
Wet, slick, bumpy, uneven or rough surfaces may impair traction and contribute to possible accidents. Do not ride in mud, snow, ice,
puddles or water. Avoid sharp bumps, drainage grates, and sudden surface changes. Do not attempt to do stunts or tricks, it is not
made to withstand abuse from misuse, such as jumping, curb grinding or any other type of stunts. Racing, stunt riding, or other extreme
maneuvers enhance the risk of loss of control. Do not ride at night without adequate lighting and visibility. Never use near steps, large
drop os or swimming pools. Do not allow hands, feet, hair, body parts, clothing, or other articles or objects to come in contact with
moving parts, wheels, or while the motor is running. Never hitch a ride or hold onto another vehicle while on the CycleBoard. Do not
immerse the CycleBoard in water, as the electrical and drive components could be damaged by water or create other possibly unsafe
conditions. Make sure all bolts and screws are tight before riding. CHECK AND MAINTAIN SAFE CONDITIONS before use.
Page 9
SAFETY INSTRUCTIONS CON’T
PROPER RIDING ATTIRE
Always wear proper protective equipment, such as an approved safety helmet (with chin strap securely buckled). *A helmet may be
legally required by local law or regulation in your area. A long-sleeved shirt, long pants, and gloves are recommended. Always keep
shoelaces tied and out of the way of the wheels and drive system.
USING THE CHARGER
The charger supplied with the CycleBoard should be regularly examined for damage to the cord, plug, enclosure and other parts. In
the event of such damage, the product must not be charged until the charger has been replaced with a CycleBoard approved battery
charger. Use only with the recommended charger. Use caution when charging. The charger is not a toy. Charger should be operated
by an adult. Do not operate charger near flammable materials, in high heat temperatures or in confined spaces. Unplug charger
and disconnect from the CycleBoard when not in use. Do not exceed charging time. Always disconnect the charger and turn o the
throttle prior to wiping down and cleaning your CycleBoard with a damp cloth.
Riding a CycleBoard electric vehicle does present potential risks and caution is required. Like any riding product, this product has
inherent hazards associated with its use (for example, falling o or riding it into a hazardous situation). Like any riding product, the
CycleBoard is intended to move and it is therefore, of course, possible to lose control or otherwise get into dangerous situations. All
riders must recognize that if such things occur, a rider can be seriously injured or die, even when using safety equipment and other
precautions. Any rider unable to stand and lean comfortably on the CycleBoard as well as operate the throttle and brake properly
should not attempt to ride it. Keep the CycleBoard away from children under the age of 18 and remember that it is intended for use
only by persons who are, at a minimum, completely comfortable and competent while operating the product. Persons with any mental
or physical conditions that may make them susceptible to injury, impair their physical dexterity or mental capabilities to recognize,
understand, and follow safety instructions and to be able to understand the hazards inherent in its use, should not ride the CycleBoard.
Persons with heart conditions, head, back or neck ailments, problems with balance (or prior surgeries to these areas of the body), or
pregnant women, are cautioned not to operate the CycleBoard. DO NOT EXCEED THE WEIGHT LIMIT OF 250 lbs. (113.4 kg). Rider
weight does not necessarily mean a person’s size is appropriate to fit or maintain control of the CycleBoard.
Page 10
SAFETY
WARNING: RIDE AT YOUR OWN RISK AND USE COMMON SENSE.
To minimize risks, follow these safety precautions:
• Always observe trac regulations and do not lend your CycleBoard to anyone who is unfamiliar with it.
• Always test your brakes prior to riding and remember the CycleBoard will not stop as quickly in wet or icy conditions
• Frequently check your front tire pressures. Front tires should be inflated to 15 psi. Low tire pressures will result in damage to the
tires and will reduce your range.
• NEVER drink alcohol and ride your CycleBoard.
• Always wear a helmet and other safety gear while riding.
• While riding, be aware of your surroundings and obey local trac laws.
• Never exceed the 250-lb. weight limit.
• Never let children under the age of 18 ride your CycleBoard. The CycleBoard can reach speeds of 20mph+. The CycleBoard is an
adult product and not meant for use by children.
• Make sure the height adjustment handle and thumb screw is securely tightened so the handlebars cannot rotate while riding.
• Always check all screws and bolts to ensure they are tight and operating properly prior to riding.
Note: If screws or bolts are removed, replaced or become loose: Add Loctite to secure them from coming loose while riding.
• Always check the throttle to ensure it is operating properly prior to riding.
• Never step on or o o the CycleBoard while it is in motion
• Do not turn o the power while riding
• Avoid braking abruptly, especially while turning or going down hill as this could cause the rear tire to skid and loss of control
• Avoid riding at excessive speeds beyond your comfort level
• Avoid riding at excessive speeds not appropriate for your terrain
• Avoid riding at excessive speeds down hill
• Do Not ride over bumps or transitions that are larger than 1 inch.
• Do Not wash or get any of the electronic components wet
• Do Not ride in the rain or in very cold weather
Inhaltsverzeichnis
Beliebte Roller Handbücher anderer Marken
First Choice Mobility
First Choice Mobility Roma Medical Corella S741 Bedienungsanleitung
Carrera
Carrera impel Bedienungsanleitung
Afikim
Afikim Superlight SL-3 Bedienungsanleitung
CareCo
CareCo ZOOM Bedienungsanleitung
Douglas
Douglas Vespa G.S. Bedienungsanleitung
Gazelle
Gazelle with BOSCH System Bedienungsanleitung