Delfin DM3 ENTRY-LEVEL Montageanleitung

Delfin S.r.l.

Strada della Merla, 49/a

10036 Settimo Torinese (TO) Italy

Tel. 0039.011.8005500

Fax 0039.011.8005506

www.delfinvacuums.it

[email protected]

Industrial vacuum cleaners

Operator's and maintenance manual

Read this manual carefully before using the vacuum cleaner

DM3 ENTRY-LEVEL

Introduction

This manual provides all the information needed to use and service your vacuum cleaner. Good

operation and durability depend on proper maintenance and careful use.

Before leaving the factory, this particular model has undergone stringent tests to ensure utmost

reliability. Always check however to make sure the vacuum cleaner has not been damaged during

transport in such a way as to affect operation and safety.

This manual should be considered an integral part of the vacuum cleaner and must be kept

together with the unit until this is scrapped.

In case of loss of or damage to the manual, ask DELFIN for a new copy.

The technical details contained in this manual are the property of DELFIN and should be deemed of

a confidential nature.

Even partial reproduction of the graphic project, the text and the illustrations is legally forbidden.

Some details shown in the illustrations in this manual may be different from those of your vacuum

cleaner. Some component parts may have been removed for greater clarity.

For easier reference, this manual is split into sections, identifiable by specific graphic symbols.

The subjects dealt with in this manual are those expressly required by "Machine Directive

2006/42/CE" and the technical details shown are those provided by the manufacturer at the time of

compilation.

This manual must be kept in a place accessible to all the personnel charged with operating and

servicing the vacuum cleaner.

In case of any doubts, always immediately phone the After-Sales Service.

The competent Law Court for all disputes is that of TURIN (Italy).

This manual must be kept with the vacuum cleaner in case of resale!

Edition 2011

Contents

Information section 1

1.1 Identification of main parts 2

1.2 Accessories provided 3

1.2.1 Optional accessories 4

1.3 Identification details of manufacturer 7

1.4 Marking plate 7

1.5 Intended uses 8

1.6 Allowed environmental conditions 8

1.7 Noise levels 8

1.8 Storage 8

1.9 Scrapping 8

1.10 Technical details 9

1.11 Warranty 10

Safety section 11

2.1 Safety details 12

2.2 Safety precautions 13

2.3 Safety plates and symbols 16

2.4 Outstanding risks 17

2.5 Applied directives 17

Installation section 18

3.1 Handling 19

3.2 Installation 20

Operation section 22

4.1 Description of controls 23

4.2 Work cycle 24

4.3 Releasing and removing the removable container 26

4.4 Using the filter shaking system 27

Maintenance section 28

5.1 Informative notes 29

5.2 General safety precautions 29

5.3 Maintenance operations 30

5.4 Replacing the filters 31

5.5 Troubleshooting 34

Spare parts section 35

6.1 Recommended spare parts 37

INFORMATION SECTION

1.1 IDENTIFICATION OF MAIN PARTS

1) Suction unit

2) Release fastening

3) Push handle

4) Filter chamber

5) Filter shaking lever

6) Removable vacuumed material container

7) Fixed castors

8) Castors

9) Fixed accessory coupling

10) Suction pipe coupling point

DM3 ENTRY-LEVEL

1.2 ACCESSORIES PROVIDED

POLYESTER FILTER:

AR3050 – Kit polyester filter cat. “G” Ø500 14T

AR3024 – Polyester filter cat. “G” Ø500 H400 14T

(only replacing filter)

DM3 ENTRY-LEVEL

1.2.1 OPTIONAL ACCESSORIES

ABSOLUTE FILTER (CODE AA1252)

The absolute filter permits trapping the finest dust particles which have not been trapped by the

primary polyester filter.

If the vacuum cleaner features this specific filter, its filtering capacity will have to be periodically

checked.

Important!________________________________________________________________

During these operations, wear individual protection devices such as gloves,

protective eyewear and dust mask.

To change the filter, switch off the vacuum cleaner and remove the plug from the power socket,

release and remove the upper cap and then loosen nut (A).

Remove the absolute filter, place it in a plastic bag, close this and dispose of it according to

applicable laws for the type of vacuumed dust.

Besides the absolute filter, depending on the dust to be vacuumed, the following filters are

available:

- ANTISTATIC FILTER

For electrostatic dusts

- NOMEX FILTER

For hot dusts up to 240°

- POLYESTER FILTER CAT. M

For very fine dusts

The polyester filters are BIA institute certified.

DM3 ENTRY-LEVEL

REMOVABLE CYCLONE

The cyclone is a treated steel cone that separates the filtering chamber from the container. This

is positioned above the vacuum inlet and below the filter.

Its job is to protect the filter from hot or sharp solid bodies and nebulised liquids.

Cod. AA 1061 (for liquids and solids)

Cod. AA 1145/500 (for dust)

BAG RETENTION RING

This optional can be requested when the vacuumed material is to be collected in a disposable

nylon bag fitted in the container. It allows keeping open the nylon bag, which is subject to vacuum,

for correct use.

(cod. AA 1098)

DM3 ENTRY-LEVEL

WET-DRY FIXED ACCESSORY (CODE AA 1134)

The bracket of the WET-DRY accessory must be secured to the vacuum cleaner frame by means

of the special front setting (A).

SIEVE GRID ACCESSORY

This accessory separates the liquids from the solids. The solids remain in the top gridded basket,

while the liquids deposit on the bottom of the container.

(cod. AA 1003)

A container featuring a special liquid draining valve can be ordered separately or else the valve

only can be ordered before contacting our technical department to have the valve fitted on the

container.

DM3 ENTRY-LEVEL

1.3 IDENTIFICATION DETAILS OF MANUFACTURER

Delfin srl

Strada della Merla, 49/a

10036 Settimo Torinese (TO) - Italy

Tel. 0039.011.800.55.00

Fax. 0039.011.800.55.06

www.delfinvacuums.it

delfin@delfinvacuums.it

1.4 MARKING PLATE

In compliance with the Machine Directive on vacuum cleaners, the machine is fitted with CE

plates.

When contacting the manufacturer or dealer, always quote the details shown on the

vacuum cleaner plate.

DM3 ENTRY-LEVEL

Inhaltsverzeichnis

Andere Delfin Staubsauger Handbücher

Delfin

Delfin DG150 SE Montageanleitung

Delfin

Delfin DM32BL Montageanleitung

Delfin

Delfin ESD.MTL-0468 Montageanleitung

Delfin

Delfin MTL501WD Montageanleitung

Delfin

Delfin MISTRAL 352 DS Montageanleitung

Delfin

Delfin DM35 SGA Montageanleitung

Delfin

Delfin TP.CV-070 Montageanleitung

Delfin

Delfin DG 70 EXP Z22 Montageanleitung

Delfin

Delfin MTL202DS Montageanleitung

Delfin

Delfin D/G 1 Z22 Betriebsanleitung

Delfin

Delfin MISTRAL 501 WD Montageanleitung

Delfin

Delfin HV102 Bedienungsanleitung

Delfin

Delfin MTL300BLC2D2DB Montageanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Exido

Exido 240-114 Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung