Desa Mantel and Base W32RO Gebrauchsanweisung

ASSEMBLING MANTEL

WARNING: Use only 1/2" screws to attach metal

angle brackets. Damage to mantel will result if other

screws are used for this purpose.

IMPORTANT: More than one person is required to lift

assembled mantel. Lift mantel by leg assemblies. Lifting

by header or mantel top could damage mantel.

When assembling mantel do not tighten screws completely

until told to do so. There should be some play in the pieces

to allow for proper alignment and best possible t. It is very

important that more than one person assemble mantel. Panels

must be held in proper alignment to each other while tighten-

ing screws to assure fewer gaps and proper surface align-

ment. When tightening screws, do not over tighten. This may

cause threads to strip. The supplied Allen wrench should be

used rather than a power screwdriver. Panels have threaded

inserts installed at screw locations. Screws should start and

turn easily in threaded holes when assembled according to

instructions. Do not force screws into holes.

IMPORTANT: A serial number label is located inside of right

side panel and on outside package. When calling to request

technical assistance or for replacement parts please have

serial number ready.

W32RO MANTEL AND BASE

ASSEMBLY AND INSTALLATION INSTRUCTIONS

IMPORTANT: Read entire instruction sheet before

assembling or installing mantel kit.

This mantel is only approved for use with DESA

Heating, LLC 32" replace systems. Do not use

mantel with any other product.

This mantel kit contains the following:

• Mantel pieces - unassembled and marked as follows:

#1 Base

#2 Right Side with arrow

#3 Right Front Leg with arrow

#4 Left Side with arrow

#5 Left Front Leg with arrow

#6 Header with arrow

#7 Top

• Hardware Kit*

14 - Metal Brackets 118937-01

28 - Screws M6 x 12 mm (1/2") 121149-01

11 - Screws M6 x 30 mm (1 1/4") 121335-01

11 - Washers M6 121336-01

1 - Allen Wrench 121337-01

* Extra hardware may be included.

If any wood pieces are missing or damaged, contact the

dealer where you purchased this mantel for replacement.

If hardware is missing or damaged, contact DESA Heating,

LLC at 1-866-672-6040 for referral. You can also visit DESA

Heating, LLC's web site at www.desatech.com.

Note: Gather all mantel pieces together before assembling.

www.desatech.com

www.desatech.com 122075-01B

Figure 3 - Installing Header

Left Leg

Assembly

Right Leg

Assembly

Header

Shoulder

Figure 1 - Attaching Front Leg

Figure 4 - Attaching Header to Leg Assembly

Header

Leg

Assembly

1 1/4" Screw

1. Lay right side panel (#2) face down on a soft surface

to avoid marking nish. Attach four brackets with 1/2"

screws to bottom of right front leg (#3) leaving screws

slightly loose. Face brackets out (see Figure 1). Place

right front leg (#3) over right side (#2) as shown in Figure

2, paying close attention to direction arrow pointing up

on panels. Align threaded holes with brackets on side.

Start four 1/2" screws through brackets. Align bottom of

side and leg assembly so they are ush with each other.

Hold these pieces securely in alignment while tightening

(but not over tightening) screws.

2. Assemble left side (#4) and left leg (#5) as described in

step 1.

3. Attach 6 brackets to base (#1) at threaded hole locations

using 1/2" screws leaving screws loose. Face brackets

toward outside (see Figure 2).

Right Side

Right Front Leg

1/2" Screws

Washer

Figure 2 - Leg Assembly to Base

1/2" Screw

Bracket

Right

Side/Leg

Assembly

Base (#1)

4. Place right side/leg assembly on base and align threaded

holes with brackets. Start 1/2" screws through brackets

into threaded holes in side/leg assembly. Back of side/

leg assembly should be ush with back of base. Assure

alignment is correct and spaces are at a minimum and

tighten leaving screws slightly loose.

5. Assemble left side/leg assembly to base (#1) following

step #4.

HEADER ASSEMBLY

Position header (#6) between leg assemblies onto shoul-

ders with direction arrow pointing up. Align threaded holes

in header with holes in leg assembly (see Figure 4). Attach

header (#4) with four 1 1⁄4" screws and washers (see Figure

4). Hold header in proper alignment with leg assemblies and

tighten, leaving screws slightly loose.

www.desatech.com

122075-01B 3

Top (#7)

Leg

Assemblies

11/4" Screw

Figure 5 - Attaching Top to Leg and Header Assembly

Washer

Back of Top

Flush with

Back of Leg

Assembly

GAS FIREPLACE INSTALLATION

1. Fireplace should be fully assembled. See Assembling

Fireplace in replace owner’s manual.

2. Place mantel base close to installation location. See re-

place owner’s manual for installation clearances. Leave

enough room to insert replace from back of mantel.

3. Install gas line. See Connecting to Gas Supply in replace

owner’s manual. Remember to leave access to the gas

shutoff valve somewhere on the base or where it is ac-

cessible to the user.

4. Check for leaks. See Checking Gas Connections in re-

place owner’s manual.

5. Position replace inside mantel (see Figure 6). Carefully

position gas lines. Important: Use caution when position-

ing replace on base. Base may scratch easily. Make

sure replace is in proper position within mantel opening

before continuing with installation.

6. Fireplace with louver door: Lower bottom louver door.

Use two screws provided in hardware package and attach

replace to wooden base. Close louver door.

Fireplace with xed louver: Before installing logs or

burner assembly (see owner’s manual) remove screws

securing oor to assembly. Lift oor for access to bot-

tom of replace. Use two screws provided in replace

hardware package and attach replace base to wooden

base. Reinstall oor with screws removed previously.

7. Carefully push mantel and base into position against

wall.

ELECTRIC FIREPLACE INSTALLATION

This mantel can be used with DESA Heating, LLC's 32" Electric

Fireplace. Electric replaces install from the front of mantel.

To install electric replace see replace instruction manual.

Use caution when positioning replace on base. Base may

scratch easily.

MANTEL TOP ASSEMBLY

Place mantel top (#7) on mantel assembly. Align back of top

with back of sides. Using four 1

1/4" screws with washers, place

two in each mantel side assembly (see Figure 5). With three

1 1/4" screws with washers, attach top to header. Make sure

all pieces are aligned properly and tighten, leaving screws

slightly loose.

Figure 6 - Installing Fireplace

NOT A UPC

122075-01

Rev. B

10/08

DESA Heating, LLC

2701 Industrial Drive

P.O. Box 90004

Bowling Green, KY 42102-9004

www.desatech.com

1-866-672-6040

122075 01

Inhaltsverzeichnis

Andere Desa Kaminzubehör Handbücher

Desa

Desa PCDM-36VB Bedienungsanleitung

Desa

Desa 102865-01 Bedienungsanleitung

Desa

Desa W26GO Gebrauchsanweisung

Desa

Desa BK3 Bedienungsanleitung

Desa

Desa W32TO Gebrauchsanweisung

Desa

Desa C26TO Gebrauchsanweisung

Desa

Desa PCBM-325 Bedienungsanleitung

Desa

Desa GA6050 Bedienungsanleitung

Desa

Desa C36TO Gebrauchsanweisung

Desa

Desa GA6050 Bedienungsanleitung

Desa

Desa GA9150A Bedienungsanleitung

Desa

Desa Wall Mantel and Base W26LT Gebrauchsanweisung

Desa

Desa Comfort Glow GA3750 Bedienungsanleitung

Desa

Desa HFL300 SERIES Bedienungsanleitung

Desa

Desa Mantel and Base W21TO Gebrauchsanweisung

Desa

Desa DS37 Bedienungsanleitung

Desa

Desa W23FT Gebrauchsanweisung

Desa

Desa W32AOSA Gebrauchsanweisung

Desa

Desa Mantel and Base W26TO Gebrauchsanweisung

Desa

Desa DVC36 Kurzanleitung

Desa

Desa Wall Mantel and Base W26LC Gebrauchsanweisung

Desa

Desa Wall Mantel and Base W32LT Gebrauchsanweisung

Desa

Desa W32GO Gebrauchsanweisung

Desa

Desa Wall Mantel with Base and Trim WD26CP Gebrauchsanweisung

Beliebte Kaminzubehör Handbücher anderer Marken

Valor

Valor L2 1700K Bedienungsanleitung

Exodraft

Exodraft Xzense Bedienungsanleitung

Whalen

Whalen Ruso MNFP62BF23-6 Bedienungsanleitung

Lopi

Lopi Hearthview 864 Bedienungsanleitung

Woodstock Soapstone

Woodstock Soapstone Fireview 201 Bedienungsanleitung

EdilKamin

EdilKamin SERBATOIO 250 Kurzanleitung

Bronpi

Bronpi KIT-1 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces 22150051 Bedienungsanleitung

Travis Industries

Travis Industries 33 DVI Bedienungsanleitung

Superior

Superior ASD3628-TI Bedienungsanleitung

pleasant hearth

pleasant hearth OFP28WG Bedienungsanleitung

IHP

IHP Astria Series Bedienungsanleitung

Firegear

Firegear FG-H-2110SS Bedienungsanleitung

Nibe

Nibe Contura C i31 Bedienungsanleitung

kozy heat

kozy heat KZK-052 Bedienungsanleitung

SimpliFire

SimpliFire SF-WM36 Bedienungsanleitung

Bluegrass Living

Bluegrass Living BC18NR Kurzanleitung

pleasant hearth

pleasant hearth IRIS SCROLL Bedienungsanleitung