DFI KS070-AL Bedienungsanleitung

KS070-AL Installation Guide

Package Contents

•

One 7" Touch Panel PC

•

One sheet of Poron foam

•

Panel mounting kit

•

1 DVD disk includes:

- Manual

DFI reserves the right to change the specications at any time prior to

the product's release. For the latest revision and more details of the

installation procedure, please refer to the user's manual on the website.

www.d.com

Panel

Top View

Mic-in

USB 2.0

Line-out

LAN 2 LAN 1

DP++

Power on/off

USB 3.0

VGA

DC-in

Bottom View

COM 1

(RS232/RS422/RS485)

Antenna Hole

COM 2

(RS232/RS422/RS485)

The CFast card slot can be accessed externally without opening the chassis.

Before installing a CFast card, take off the CFast card slot cover.

Installing a CFast Card

CFast slot cover

1. Gently insert the CFast card straight with the label on the CFast card

facing up until you feel it lock into place. Do not force the card into the

slot if the card is not correctly inserted.

2. Close the CFast card cover and attach the screw. To eject the card, push

the card inward to release the lock and pull it out.

CFast slot cover

Removing the Chassis Cover

1. Make sure the system and all other peripheral devices connected to it

have been powered-off.

2. Disconnect all power cords and cables.

3. The 12 mounting screws on the top and bottom as well as both sides of

the system are used to secure the cover to the chassis. Remove these

screws and put them in a safe place for later use.

4. Lift the cover up to open the system.

5. The Mini PCIe and the M.2 sockets are readily accessible after removing

the chassis cover.

Mounting screw

M.2 socket Mini PCIe socket

Mounting screw

Installing an M.2 Card

The system is equipped with one M.2 socket, supporting the M.2 22x42mm

(key B) form factor. Use the following procedure to install an M.2 card:

M.2 card

1. Align the notch at the edge of the M.2 card with the key in the connector.

2. Insert the M.2 card into the connector.

Mounting screw

Note:

The M.2 socket supports PCIe, USB, and SATA signals and can accommodate common

mobile broadband and storage modules. For jumper settings on switching the signal

betwen SATA and PCIe, refer to "Board Layout and Jumper Settings."

3. Push down on the other end of the M.2 card and secure and card on the

mainboard with the provided mounting screw.

Installing a Mini PCIe Card

The system board is equipped with one Mini PCIe slot that supports PCIe

and USB signals. Use the following procedure to install a Mini PCIe card:

1. Grasp the Mini PCIe card by its edges and align the notch in the

connector of the PCIe card with the key in the connector on the

system board.

2. Push the Mini PCIe card down and use the provided mounting screws to

secure the card on the system board.

Mini PCIe card

Mounting screw

The wall mount kit includes the following:

• 2 wall mount brackets

• Bracket screws

2. Select a place on the wall where you will mount the Panel PC.

3. Use the provided mounting screws to attach “wall mount bracket 1” to

the wall.

Mounting Options

Wall mount

Wall mount bracket 1 Wall mount bracket 2

Wall mount bracket 1

Mounting screw

1. Before starting any installation procedures, attach the poron foam to

the Panel PC.

Poron foam

4. Attach the other bracket (wall mount bracket 2) to the rear of the

Panel PC.

5. Slide the Panel PC to "wall mount bracket 1" to attach the two brackets

with the hooks. Then tighten the screw to secure the assembly in place.

Wall mount bracket 2

Mounting screw

Hooks

Screw

2. Select a place on the panel (or wall) where you will mount the Panel PC.

3. Cut out a shape on the panel that corresponds to the Panel PC’s rear

dimensions (210.5mm x 132.2mm) and ensure that the Panel PC can be

tted into the panel properly.

4. Insert the Panel PC from the outside surface of the panel into the

mounting hole until it is properly tted against the panel.

5. Position the mounting clamps along the rear edges of the Panel PC and

insert them into the slits around the Panel PC.

Panel

Mounting hole

132.20

210.50

Panel mount

The panel mounting kit includes the following:

• 6 mounting clamps

1. Before starting any installation procedures, attach the poron foam to

the Panel PC.

Poron foam

Note:

The at panel thickness is less than 5mm.

132.20

210.50

Slit for mounting the clamp

Mounting clamp

White plastic cap

6. The rst and second clamps must be positioned and secured diagonally

prior to mounting the rest of the clamps. Tighten the clamp’s screw

using an electric screwdriver by pressing the white plastic cap onto

the back of the panel. The illustration below shows that all clamps are

properly mounted.

Andere Handbücher für KS070-AL

Inhaltsverzeichnis

Andere DFI Touchscreen Handbücher

DFI

DFI VS436 (15") Bedienungsanleitung

DFI

DFI VS 15 Bedienungsanleitung

DFI

DFI TPC150-SD Bedienungs- und Wartungsanleitung

DFI

DFI KS150-BT Bedienungsanleitung

DFI

DFI KS150-BT Bedienungsanleitung

DFI

DFI KS070-AL Bedienungsanleitung

DFI

DFI KS-SD Series Bedienungsanleitung

DFI

DFI KS070-BT Bedienungsanleitung

DFI

DFI PPC Workstation 19 480 Bedienungsanleitung

DFI

DFI KS070-AL Bedienungsanleitung

DFI

DFI KS230 Bedienungsanleitung

DFI

DFI BPC370-BW Bedienungsanleitung

DFI

DFI KS070-ALE39P Bedienungsanleitung

DFI

DFI KS156-AL Bedienungsanleitung

DFI

DFI KSM-KH Series Bedienungsanleitung

DFI

DFI KS150 Bedienungsanleitung

DFI

DFI KS310-IMX6 Bedienungsanleitung

DFI

DFI VP070-M8M Bedienungsanleitung

DFI

DFI KS156P-EHL Bedienungsanleitung

DFI

DFI VP070-M8M Bedienungsanleitung

DFI

DFI KS070-FS Bedienungsanleitung

DFI

DFI TPC121 Bedienungsanleitung

DFI

DFI KS200 Bedienungsanleitung

DFI

DFI TPC170 Installationsanleitung

Beliebte Touchscreen Handbücher anderer Marken

FlowLine

FlowLine Data loop Bedienungsanleitung

ALPEX

ALPEX AEx-8 P Series Bedienungsanleitung

Ltech

Ltech E5S Bedienungsanleitung

Harman

Harman AMX MODERO S MSD-701-L2 Bedienungsanleitung

Acnodes

Acnodes PC 1150 Bedienungsanleitung

AIS

AIS IP10IA99 series Bedienungsanleitung

IBASE Technology

IBASE Technology ASTUT-152-RE1S Bedienungsanleitung

YASKAWA

YASKAWA TP 610C Bedienungsanleitung

B&R

B&R Power Panel C Series Bedienungsanleitung

Beijer Electronics

Beijer Electronics X2 control Bedienungsanleitung

AXIOMTEK

AXIOMTEK GOT321W-521 Bedienungsanleitung

TRIDONIC.ATCO

TRIDONIC.ATCO x-touchBOX Bedienungsanleitung

Qomo

Qomo QIT1386 Bedienungsanleitung

AMX

AMX AXP-PPC Leitfaden

Sartorius

Sartorius X3 PR 5410 Bedienungsanleitung

AMX

AMX Modero X Series Bedienungsanleitung

Advantech

Advantech TPC-30 Series Bedienungsanleitung

B&R Industries

B&R Industries MAPPC900-ENG Bedienungsanleitung