Dream Catcher FEBPS107-2 Bedienungsanleitung
Fitted Washable Electric Blanket
Instruction Manual
FEBPS107-2 /FEBPD137-2
FEBPK152-2 /FEBPSK182-2
Please read all instructions carefully
and retain for future reference.
Thank you for purchasing our Electric Blanket which has been
designed to give many years of service under normal use.
In order to get the most from your Electric Blanket please carefully
read and follow the instruction provided.
Specifications
Voltage: 220 - 240V~ 50Hz
Rated Power: 1 x 70W
FEBPS107-2 Size: 91 x 193 cm
Rated Power: 2 x 60W
FEBPD137-2 Size: 137 x 193 cm
FEBPK152-2 Size: 152 x 203 cm
Rated Power: 2 x 70W
FEBPSK182-2 Size: 182 x 203 cm
How to use
1. Your electric blanket should be placed directly onto the mattress
with the power lead near the edge of the pillow. If using a mattress
protector this goes over the electric blanket.
2. Ensure that the electric blanket is one to suit your mattress – i.e.
a King size electric blanket must be used on a King size mattress.
Do not use a Single Bed blanket on a Double, A King or a Super
King size mattress. Nor use a Double, a King or a Super King size
blanket on a Single bed mattress.
3. Its size is much as to give even all over warmth for the whole
bed surface. The blanket should not be tucked in at the sides.
4. When securely attached to the mattress, connect the plug to the
power point and switch on. The flexible cord and switch must be
kept outside the bed and away from open window or exposure to
moisture.
5. Double, King and Super King have dual control, which enables
the users to set their sides of the bed to their desired heat setting.
Overheat protection
All electric blankets are fitted with our overheat safeguard system.
This offers protection against overheating or damage to the
element by disengaging the power to the heating element before
any overheat hazards occur.
Important
Check daily that your blanket is flat, fully spread out and secured
before switching on.
Failure to observe these instructions will cause overheating.
This will activate our overheat safeguard system, thus
leaving the blanket inoperative, voiding all warranties.
1. Use as an under blanket only. Not recommended for Futon or
similar bedding system.
2. This blanket is not recommended to be used on an adjustable
bed. If used on an adjustable bed, check that the blanket or cord
cannot become caught or rucked.
3. Make sure that the heating area (element) on any side of the
bed does not hang over the edge of the mattress, that means of
attachment are adequate and suitable for the particular mattress,
and that the instructions which follow are read carefully before
using the blanket.
4. The appliance is not intended for use by young children or infirm
persons without supervision. For human use only, not pets.
5. Young children should be supervised to ensure that they do not
play with the appliance.
6. Prolonged application at the high setting can result in skin burns.
7. Do not tuck in.
8. Do not use tucked or folded.
9. Keep the control unit away from an open window.
10. Do not use pins-they may damage the electric wiring.
11. Be sure that this blanket is used only on an alternating current
supply circuit of the proper voltage.
12. The supplied flexible cord and switch must, as far as practicable,
be kept outside the bed.
13. Do not switch the power on if the blanket is wet or in folded
state.
14. Switch off at the power outlet and remove plug when this
blanket is not in actual use.
15. This blanket must be kept in the fully spread condition at all
times during use to avoid overheating. It is imperative that the
blanket be frequently inspected to ensure that this condition is
being maintained.
16. Bedclothes should not be folded back when unit is switched on.
Do not leave heavy objects on the bed when the unit is switched on,
e.g. Folded blankets or suitcases.
17. Do not dry clean this blanket.
18. Persons suffering from bed-wetting should not use this electric
blanket.
19. If any abnormality or defect in operation of this blanket is
observed, discontinue its use immediately and consult the
manufacturer or the supplier regarding its repair.
20. The blanket should be examined frequently for signs of wear,
either of the blanket, controller or flexible cord. If wear is visible,
the blanket should be returned immediately to manufacturer or
supplier for inspection and overhaul. Servicing, by law, must be
undertaken by a qualified and registered person.
21. It is recommended you follow washing instructions for localized
soiling if a small amount of soiling occurs.
22. The blanket must not be used over or under a water bed.
23. You may notice a blue flash in the switch when it is moved from
one setting to another. This is NOT dangerous and is only the
copper parts making contact.
24. It is recommended that your electric blanket is inspected by a
qualified and registered person after 3 years of use.
25. When storing, fold neatly but not tightly (or roll) without sharp
bends in the heating element and store where no other objects will
be placed upon it.
26. Avoid pressing creases into the appliance.
27. This appliance is for household use only. Not intended for use in
hospitals.
Compulsory warning
If the supply cord is damaged, it must be discarded.
Operation & Controls
1. Switch controller to ON position.
2. Set temperature “Body” or “Foot” from 1–4 heat setting. Each
can be used separately.
3. Set “Time” button to choose the heating time you need for your
body and feet ranging in 1 – 9 hours.
NOTE: This will help to dry out any moisture which has been
accumulated in the mattress. You may notice some odour when
using the blanket for the first time due to the insulation material.
This is harmless and will disappear soon. The highest mode (4 heat
setting) must be used only for preheat and not for continuous
operation. The 4th heating level will automatically transfer to the 3rd
level after 3 hours working. The other modes can be used
continuously. It is recommended to preset heat setting at number 2
if blanket is to be left on all night.
Remarks: If all the LED lights flashes simultaneously, please check if the
connector is properly connected, then re-operate the controller. If the LED
lights flash again, the unit is damaged.
Care and maintenance
Before cleaning
Disconnect the blanket from the mains supply, and then disconnect
the controller from the blanket. Store the controller away carefully.
Cleaning
Do not dry clean this blanket
The blanket has waterproof heating elements making it safe to
immerse in water and wash by hand or machine. Always remove
the controller first – do not allow any part of the controller to be
immersed in any liquid.
Machine Wash
With the controllers detached the blanket can be washed in a
machine (size permitting).
Wash on WOOL or DELICATES cycle with a neutral detergent or
mild soap powder at a wash temperature of 40oC. Do not use high
speed or extra spin cycles.
Drying
Drape the blanket over a clothes line to dry – do not use pegs to
secure the blanket.
Allow to dry naturally – do not use any form of direct heat such as
a hair dryer or heater. Ensure that the blanket and its connector
are fully dry before re-connecting the controller and using.
Damage Check
The blanket, controller and cable must be regularly checked for
damaged. If any damage or wear is found, the product must be
checked by a qualified engineer before use.
Environmental Protection
Waste electrical products should not be disposed of with
household waste, please recycle where facilities exist. Check
with your local authority or retailer for recycling advice.
Declaration of Conformity
We Futura Direct Ltd, England declare that the Heated Electric
Blanket has been manufactured according to our full quality
assurance procedures.
The declaration is to certify that it conforms to CE, EMC, WEEE and
RoHS directives.
Mr. P Kaye
UK QC Manager
36 Months Limited Warranty
Here at Futura Direct we are confident that you will enjoy many
hours of pleasure from your product. However, if within 36 months
from the date of purchase you experience any problems due to
defects in materials or manufacture, please connect us directly on
01302332030.
Should your product develop a fault please follow these steps
immediately:
Call our technical helpline on 01302332030.
We will replace any defective product that is in warranty due to
defective materials or workmanship.
We will NOT replace any product that has faults due to accidental
damage, abuse or from failure to follow the instructions.
This does not affect your statutory right.
Contact us at www.futuradirect.co.uk/contact
Register at www. .co.uk/ guarantee
We FUTURA Direct Ltd, England DN6 7AY declare that the Polar Fleece Electric Blanket exclusively
manufactured for Futura Direct Ltd and has been manufactured according to our full quality assurance
procedures.
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Andere Dream Catcher Zubehör Handbücher
