Drive Delta 1000 Bedienungsanleitung

Owner’s Assembly And Operating Manual

Ultra Light Plus, Semi Electric Bed

Delta 1000

Item # 15030

REV3.1.14.16

Conrm that all parts are present.

A. Foot Spring

B. Head Spring

C. Head Board

D. Foot Board

E. Hi/Low Shaft

F. Locking Pins

G. Motor

H. Hand Crank (attached to foot board for shipping)

I. Casters (4) - 2 locking, 2 non-locking

J. Spring Clips (2)

K. Hand Pendant

M. Motor Transport Straps

Assembly Instructions

Assembly Instructions Cont.

3. Connect the head spring

by aligning with foot spring

and swinging both ends away

from each other. (Continued

on next page)

2. The lock collar comes pre-set from

the factory. Ensure that it is 1/4” -

1/2” away from hanger bracket. If

not, slide lock collar 1/4” from the

foot side of the hanger bracket as

shown. Tighten thumb screw.

Note: The rail is marked full or semi as

a guide.

1/4” Gap

Thumb Screw

1. Install drive shaft onto foot section.

Assembly Instructions Cont.

Continued

4. With bed on side extend the shaft until it

reaches the full length of bed.

a. NOTE: The shaft adjustment holes are

marked to indicate the style (semi/full) of bed

the shaft is being installed on.

5. Insert lock pin through connected sleep

surface and secure with spring clip.

5A. Connect head section and foot section

by squeezing together and attaching

with spring links. Pull up the head

section and foot section to release

tension between the springs.

Continued

Assembly Instructions Cont.

6. Connect the 9V battery (sold separately) to the

battery clip on the motor. It is stored in the recess

under the motor cover. With this battery installed,

the motor can be operated to return the sleep

surface to the horizontal position in the event of a

power failure.

7. To install motor, remove locking caps on top of

the motor.

HAND CONTROL

The Delta bed comes with a hand control that will

illuminate when the bed is plugged into a grounded or

polarized wall outlet, or with 9V battery (sold separately)

installed in the hand control. The hand control will

illuminate as long as the wall or battery has power. With

this battery installed, the motor can be operated to return

the sleep surface to the horizontal position in the event

of a power failure.

NOTE: Before installing motor, plug hand

pendant cable into motor as shown

Assembly Instructions Cont.

There are two methods for the installation of

the motor

Method A

The motor is installed on the bed frame when the frame is standing

on its side.

Installation instructions can be found on pages 8-9.

Method B

The motor is installed from underneath the bed frame

(horizontal to the ground)

Installation instructions can be found on pages 10-11.

Assembly Instructions Cont.

A2. Align the opening on the head end of the

motor with the ange on the head section of

the bed and insert the ange into the motor

compartment.

Actuator Bar

A3. With the palm of your hand, snap the motor

ush to the actuator bar.

A4. Align the opening on the foot end of the

motor with the ange on the foot section of

the bed and insert the ange into the motor

compartment.

Method A

Installation of the motor when bed frame is on its side

A1. Prior to installation, make sure that the 2 white motor blocks are in the retracted position.

CORRECT INCORRECT

Assembly Instructions Cont.

A6. After the motor is installed, slide locking covers back on motor.

A8. Attach the foot board and head board

as shown.

a. NOTE: The head section is higher than

the foot section. However, they are

interchangeable with each other, with all

other Drive and other manufacturers

head and foot boards.

A7. Install the casters by inserting the

stem of the caster into the leg

receptacle. It is recommended to

install 1 locking caster and 1 non-

locking caster on each bed end.

The locking casters should be

installed diagonally from each other.

Stem

Leg Receptacle

End Method A

Go To Page 12, Step 8

Method A (Continued)

A5. With the palm of your hand, snap the motor

ush to the actuator bar.

Assembly Instructions Cont.

Method B

Installation of the motor from underneath the frame

B2. Attach the foot board and head board

as shown.

a. NOTE: The head section is higher than

the foot section. However, they are

interchangeable with each other, with all

other Drive and other manufacturers

head and foot boards.

B1. Install the casters by inserting the

stem of the caster into the leg

receptacle. It is recommended to

install 1 locking caster and 1 non-

locking caster on each bed end.

The locking casters should be

installed diagonally from each other.

Stem

Leg Receptacle

B3. Prior to installation, make sure that the 2 white motor blocks are in the retracted position.

CORRECT INCORRECT

Inhaltsverzeichnis

Andere Drive Medizinische Geräte Handbücher

Drive

Drive Aquajoy Premier Plus Bedienungsanleitung

Drive

Drive 11120SV-1 Bedienungsanleitung

Drive

Drive Bed assist handle Bedienungsanleitung

Drive

Drive 16500BV Bedienungsanleitung

Drive

Drive 13067 Bedienungsanleitung

Drive

Drive 15300 Bedienungsanleitung

Drive

Drive MSS Tilt & Recline Bedienungsanleitung

Drive

Drive 14026 Bedienungsanleitung

Drive

Drive SmartDose CTOX-MN02 Bedienungsanleitung

Drive

Drive 15560 Bedienungsanleitung

Drive

Drive RTL10433 Bedienungsanleitung

Drive

Drive Bonsai OM-824 Bedienungsanleitung

Drive

Drive Bellavita handset Betriebsanleitung

Drive

Drive M-Rail Bedienungsanleitung

Drive

Drive 13049SV Bedienungsanleitung

Drive

Drive Winnie wagon Bedienungsanleitung

Drive

Drive RTLAGF-900 Bedienungsanleitung

Drive

Drive 13085RN Bedienungsanleitung

Drive

Drive AIRIAL CHAMBER Bedienungsanleitung

Drive

Drive 12023 Bedienungsanleitung

Drive

Drive MQ3000 Bedienungsanleitung

Drive

Drive 15561 Bedienungsanleitung

Drive

Drive 15003 Bedienungsanleitung

Drive

Drive RTL12068 Bedienungsanleitung

Beliebte Medizinische Geräte Handbücher anderer Marken

TekTone

TekTone Tek-CARE160 Bedienungsanleitung

NeuroMetrix

NeuroMetrix Quell 2.0 Bedienungsanleitung

AMT

AMT XLR8 Bedienungsanleitung

EDAN

EDAN SONOTRAX Pro Bedienungsanleitung

Restorative Therapies

Restorative Therapies RT300 Bedienungsanleitung

Gendex

Gendex Expert DC Bedienungsanleitung

Dexcowin

Dexcowin ADX4000W Bedienungsanleitung

Libelium

Libelium MySignals Bedienungsanleitung

Acelity

Acelity V.A.C.ULTA 4 Bedienungsanleitung

Caputron

Caputron ActivaDose II tDCS Bedienungsanleitung

Plinth 2000

Plinth 2000 93CDT Bedienungsanleitung

GE SENOGRAPHE 800T Bedienungsanleitung

GE Definium 5000 Bedienungsanleitung

Kanmed

Kanmed GE-1380 Bedienungsanleitung

Huntleigh

Huntleigh FD1 Bedienungsanleitung

Stryker

Stryker SPR Plus Bedienungsanleitung

Tobii Dynavox

Tobii Dynavox I-Series Bedienungsanleitung

S-Capepod

S-Capepod Evac Cocoon Bedienungsanleitung